scholarly journals Analysis and comparison of methods for the preparation of domestic hot water from district heating system, selected renewable and non-renewable sources in low-energy buildings

2018 ◽  
Vol 30 ◽  
pp. 03001
Author(s):  
Maciej Knapik
Keyword(s):  
Renewable Energy ◽  
Energy Demand ◽  
Renewable Energy Sources ◽  
District Heating ◽  
Heating System ◽  
Hot Water ◽  
Low Energy ◽  
Energy Sources ◽  
District Heating System ◽  
Domestic Hot Water

The article presents an economic analysis and comparison of selected (district heating, natural gas, heat pump with renewable energy sources) methods for the preparation of domestic hot water in a building with low energy demand. In buildings of this type increased demand of energy for domestic hot water preparation in relation to the total energy demand can be observed. As a result, the proposed solutions allow to further lower energy demand by using the renewable energy sources. This article presents the results of numerical analysis and calculations performed mainly in MATLAB software, based on typical meteorological years. The results showed that system with heat pump and renewable energy sources Is comparable with district heating system.

scholarly journals Advanced Control of a District Heating System with High Residential Domestic Hot Water Demand

2020 ◽  
Vol 160 ◽  
pp. 01004 ◽  
Author(s):  
Stanislav Chicherin ◽  
Lyazzat Junussova ◽  
Timur Junussov
Keyword(s):  
Energy Demand ◽  
Energy Use ◽  
District Heating ◽  
Heating System ◽  
Primary Energy ◽  
Hot Water ◽  
District Heating System ◽  
Domestic Hot Water ◽  
Extreme Load ◽  
Flow Controller

Proper adjustment of domestic hot water (DHW) load structure can balance energy demand with the supply. Inefficiency in primary energy use prompted Omsk DH company to be a strong proponent of a flow controller at each substation. Here the return temperature is fixed to the lowest possible value and the supply temperature is solved. Thirty-five design scenarios are defined for each load deviation index with equally distributed outdoor temperature ranging from +8 for the start of a heating season towards extreme load at temperature of -26°C. All the calculation results are listed. If a flow controller is installed, the customers might find it suitable to switch to this type of DHW supply. Considering an option with direct hot water extraction as usual and a flow controller installed, the result indicates that the annual heat consumption will be lower once network temperatures during the fall or spring months are higher. The heat load profiles obtained here may be used as input for a simulation of a DH substation, including a heat pump and a tank for thermal energy storage. This design approach offers a quantitative way of sizing temperature levels in each DH system according to the listed methodology and the designer's preference.

scholarly journals Hybrid solar-biomass system for district heating

2019 ◽  
Vol 85 ◽  
pp. 04006
Author(s):  
Adrian Ilie ◽  
Ion Vişa
Keyword(s):  
Renewable Energy ◽  
Thermal Energy ◽  
Renewable Energy Sources ◽  
District Heating ◽  
Point Of View ◽  
Hot Water ◽  
Energy Sources ◽  
District Heating System ◽  
Heating Systems ◽  
District Heating Systems

The energy used in the built-up environment represents at least 40% of the total energy consumed, out of which, at least 60% is required for heating, cooling and domestic hot water (DHW). Within the European Union, more than 6,000 communities (i.e. over 9%) use district heating systems, the majority of which use the conversion of fossil fuels as a source of energy. This aspect, which is corroborated by the directives of the EU legislation on the use of renewable energy sources and energy performance, imposes the development of new solutions through which the existing district heating systems may be adapted to use renewable energy sources. The solar-thermal systems that are used on a large (district) scale are becoming more and more efficient from the point of view of their feasibility; however, it is almost impossible to create systems that should satisfy the thermal energy demand throughout the four seasons of the year. The hybrid solar-biomass system is becoming the applicable solution for the majority of the communities that have from this potential, since it can secure independence from the point of view of the use of thermal energy. This paper presents the design stages for the implementation of the hybrid solar-biomass systems with a view to identifying the optimal solutions for systems to be integrated into an existing district heating system. A case study (Taberei District in Odorheiu Secuiesc City), which provides a detailed description of the feasible technical solutions, is presented.

scholarly journals Overview of Solutions for the Low-Temperature Operation of Domestic Hot-Water Systems with a Circulation Loop

Energies ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3350
Author(s):  
Theofanis Benakopoulos ◽  
William Vergo ◽  
Michele Tunzi ◽  
Robbe Salenbien ◽  
Svend Svendsen
Keyword(s):  
Low Temperature ◽  
Heat Loss ◽  
District Heating ◽  
Heating System ◽  
Hot Water ◽  
Heating Power ◽  
Circulation Loop ◽  
Space Heating ◽  
District Heating System ◽  
Domestic Hot Water

The operation of typical domestic hot water (DHW) systems with a storage tank and circulation loop, according to the regulations for hygiene and comfort, results in a significant heat demand at high operating temperatures that leads to high return temperatures to the district heating system. This article presents the potential for the low-temperature operation of new DHW solutions based on energy balance calculations and some tests in real buildings. The main results are three recommended solutions depending on combinations of the following three criteria: district heating supply temperature, relative circulation heat loss due to the use of hot water, and the existence of a low-temperature space heating system. The first solution, based on a heating power limitation in DHW tanks, with a safety functionality, may secure the required DHW temperature at all times, resulting in the limited heating power of the tank, extended reheating periods, and a DH return temperature of below 30 °C. The second solution, based on the redirection of the return flow from the DHW system to the low-temperature space heating system, can cool the return temperature to the level of the space heating system return temperature below 35 °C. The third solution, based on the use of a micro-booster heat pump system, can deliver circulation heat loss and result in a low return temperature below 35 °C. These solutions can help in the transition to low-temperature district heating.

scholarly journals Transition towards a sustainable heating sector in municipality of Visoko with analysis of loading and optimization of solar collector carriers

2020 ◽  
Vol 4 (1) ◽  
pp. 28-34
Author(s):  
Keyword(s):  
Renewable Energy ◽  
Financial Stability ◽  
Solar Collector ◽  
Local Economic Development ◽  
Renewable Energy Sources ◽  
District Heating ◽  
Heating System ◽  
District Heating System ◽  
Heating Systems ◽  
South Eastern

Many traditional heating systems based on fossils face challenges such as lack of investment or unfavorable price regulation, low technical performance, impact on the environment and negative consumer perceptions. The CoolHeating project funded by the EU’s Horizon 2020 program, whose basic features and outcomes are presented in this work, promotes the implementation of small modular renewable heating and cooling grids for communities in South-Eastern Europe, including the town of Visoko as one of five target regions. Core activities, besides techno-economical assessments and social-environmental benefits, include measures to stimulate the interest of communities and citizens to set-up renewable district heating systems. In this work, an analysis was performed for implementation of small modular district heating system in Visoko, covering several public buildings and few neighborhoods in north-western part of town. Combination of different renewable energy sources were analyzed leading to an optimal and a very promising energy supply strategy due to its contribution to security of supply, financial stability, local economic development, local employment, etc. Possible financial savings for heating of 38% compared to current financial needs are determined. Structure optimization of solar collector holders was also performed, taking into account external influence, enabling savings in the structure material. This approach confirms feasibility of transition from traditional to renewable energy based heating system. Having in mind the modularity of such systems, similar solutions can be replicated in other South-Eastern European cities and other countries.

scholarly journals Impact of Domestic Hot Water Systems on District Heating Temperatures

Energies ◽  
2019 ◽  
Vol 12 (24) ◽  
pp. 4694
Author(s):  
Tina Lidberg ◽  
Thomas Olofsson ◽  
Louise Ödlund
Keyword(s):  
Low Temperature ◽  
District Heating ◽  
Heating System ◽  
Hot Water ◽  
Space Heating ◽  
Circulation System ◽  
District Heating System ◽  
Domestic Hot Water ◽  
Temperature Levels ◽  
The Impact

When buildings become more energy effective, the temperature levels of district heating systems need to be lower to decrease the losses from the distribution system and to keep district heating a competitive alternative on the heating market. For this reason, buildings that are refurbished need to be adapted to suit low-temperature district heating. The aim of this paper is to examine whether four different energy refurbishment packages (ERPs) can be used for lowering the temperature need of a multi-family buildings space heating and domestic hot water (DHW) system as well as to analyse the impact of the DHW circulation system on the return temperature. The results show that for all ERPs examined in this study, the space heating supply temperature agreed well with the temperature levels of a low-temperature district heating system. The results show that the temperature need of the DHW system will determine the supply temperature of the district heating system. In addition, the amount of days with heating demand decreases for all ERPs, which further increases the influence of the DHW system on the district heating system. In conclusion, the DHW system needs to be improved to enable the temperature levels of a low-temperature district heating system.

scholarly journals Possibilities of Upgrading Warsaw Existing Residential Area to Status of Positive Energy Districts

Energies ◽  
2021 ◽  
Vol 14 (18) ◽  
pp. 5984
Author(s):  
Hanna Jędrzejuk ◽  
Dorota Chwieduk
Keyword(s):  
Carbon Dioxide ◽  
Renewable Energy ◽  
Residential Buildings ◽  
Renewable Energy Sources ◽  
District Heating ◽  
Hot Water ◽  
Energy Sources ◽  
Positive Energy ◽  
Final Energy ◽  
The City

This paper analyses possibilities of refurbishment of Warsaw’s residential buildings towards standards of the Positive Energy District. The annual final energy consumption in the city in 2019 for the district heating was 8668 GWh, gas (pipelines) was 5300 GWh, electricity from the grid was 7500 GWh, while the emission of the carbon dioxide was 5.62 × 109 kg. The city consists of 18 districts, which are heterogeneous in terms of typology and structure of buildings. The great variety of buildings can be seen, for example, by the annual final energy demand for space heating and hot water preparation per unit of room area. This annual index ranges from over 400 kWh/m2 in historic buildings to 60 kWh/m2 in modern buildings. A reduction in the consumption of non-renewable energy sources and carbon dioxide emissions can be achieved by improving the energy standard of residential buildings and by using renewable energy sources: solar energy, geothermal energy and biogas. The potential barriers for achieving the status of a positive energy district, for example, problems connected with ownership, financing new investments and refurbishment and legal boundaries, have been identified. Moreover, changing the existing electrical grid and district heating systems in urban areas in Warsaw requires comprehensive modernization of practically the entire city’s infrastructure.

scholarly journals Analysis of District Heating and Cooling Energy Systems in Spain: Resources, Technology and Management

2021 ◽  
Vol 13 (10) ◽  
pp. 5442
Author(s):  
Beatriz María Paredes-Sánchez ◽  
José Pablo Paredes ◽  
Natalia Caparrini ◽  
Elena Rivo-López
Keyword(s):  
Renewable Energy ◽  
Energy Conversion ◽  
Thermal Energy ◽  
Renewable Energy Sources ◽  
District Heating ◽  
Energy Transition ◽  
Energy Sources ◽  
Total Production ◽  
District Heating System ◽  
Heating And Cooling

District heating and cooling (DHC) systems play an important role under the new European Union (EU) energy transition strategy. Thermal energy networks are helping to stimulate the development of alternative technologies based on a broad range of renewable energy sources. The present study analysed the current situation of DHC systems in Spain and provides an overview of the challenges and future opportunities that their use will entail. Its objective is to assess thermal energy conversion and management from a holistic perspective, including a study of existing energy infrastructures. The focus of this study lies on Spain given the country’s abundance of natural resources such as renewable energy sources including solar energy, biomass and geothermal energy, among others, as well as its strategic location on the map of the EU. Based on the analysis of the three factors for energy conversion in a district heating system, namely resources, technology, and management, the methodology provided an assessment of the different factors involved in running a DHC system. The results show an estimated total production for DHC networks of 1448 MWth, of which 72% is supplied purely by renewable energy sources.

Sign in / Sign up

Export Citation Format

Share Document