scholarly journals Diagnostics of Particles emitted from a Laser generated Plasma: Experimental Data and Simulations

2018 ◽  
Vol 167 ◽  
pp. 04005 ◽  
Author(s):  
Giuseppe Costa ◽  
Lorenzo Torrisi

The charge particle emission form laser-generated plasma was studied experimentally and theoretically using the COMSOL simulation code. The particle acceleration was investigated using two lasers at two different regimes. A Nd:YAG laser, with 3 ns pulse duration and 1010 W/cm2 intensity, when focused on solid target produces a non-equilibrium plasma with average temperature of about 30-50 eV. An Iodine laser with 300 ps pulse duration and 1016 W/cm2 intensity produces plasmas with average temperatures of the order of tens keV. In both cases charge separation occurs and ions and electrons are accelerated at energies of the order of 200 eV and 1 MeV per charge state in the two cases, respectively. The simulation program permits to plot the charge particle trajectories from plasma source in vacuum indicating how they can be deflected by magnetic and electrical fields. The simulation code can be employed to realize suitable permanent magnets and solenoids to deflect ions toward a secondary target or detectors, to focalize ions and electrons, to realize electron traps able to provide significant ion acceleration and to realize efficient spectrometers. In particular it was applied to the study two Thomson parabola spectrometers able to detect ions at low and at high laser intensities. The comparisons between measurements and simulation is presented and discussed.

2019 ◽  
Vol 85 (3) ◽  
Author(s):  
Erik Varberg ◽  
Åshild Fredriksen

The work described in this article was carried out to investigate how permanent magnets (PM) affect the plasma confinement and ion beam properties in an inductively coupled plasma which expands from a helicon source. The cylindrical plasma device Njord has a 13 cm long and 20 cm wide stainless steel port connecting the source chamber and the diffusion chamber. The source chamber has an axial magnetic field produced by two coils, with magnetic field lines expanding into the diffusion chamber. Simulations have shown that the field lines leaving the edge of the source hit the port wall, causing a loss of electrons in this section. In the experiments performed in this work, PMs were added around the port walls near the exit of a plasma source and the effect was investigated experimentally by means of a retarding field energy analyser probe. The plasma potential, ion density and ion beam parameters were estimated, and the results with and without the PMs were compared. The results showed that the plasma density in the centre can in some cases be doubled, and the density at the edges of the plasma increased significantly with PMs in place. Although the plasma potential was slightly affected, and the beam velocity dropped by ${\sim}$ 10 %, the ion beam flux increased by a factor of 1.5.


2007 ◽  
Vol 49 (5A) ◽  
pp. A81-A93 ◽  
Author(s):  
Francis F Chen ◽  
Humberto Torreblanca

2021 ◽  
Vol 2021 ◽  
pp. 1-12
Author(s):  
Jinkun Min ◽  
Guangyu Zhu ◽  
Yidan Yuan ◽  
Jingquan Liu

The experimental facility VULCAN was setup to study the fuel-coolant interaction (FCI) phenomena in a postulated severe accident of light water reactors. The heating system is important for the facility to prepare molten material in a crucible. This article is concerned with the design of the heating system, which applies electromagnetic induction heating method. The COMSOL code was employed to simulate the induction heating characteristics of a graphite crucible under different current and frequency of the work coil (inductor). Given a frequency, the relationship between the crucible’s average temperature and the inductor’s current is obtained, which is instrumental to select the power supply of the induction heating system. Meanwhile, the skin effect of induction heating is analyzed to guide the choice of frequency and inductor of the heating system. According to the simulation results, the induction heating system of frequency 47 kHz is suitable for the experiment, with a good agreement in temperature between the measured and the predicted.


2019 ◽  
pp. 203-206
Author(s):  
D.Yu. Zaleskyi ◽  
G.A. Krivonosov ◽  
G.V. Sotnikov

We studied characteristics of the neon plasma source excited in the atmosphere under the following conditions: gas pressure is about 2 Torr, rectangular pulses have an amplitude from 200 to 800 V, pulse duration is from 0.2 to 10 μs, repetition rate is from 0.2 up to 1 kHz. There is a mode with a stable and unstable mode of existence of the plasma when the voltage on the electrodes of the plasma source varies from 800 to 350 V and from 350 to 250 V before the extinction of the plasma. The pulse from the PMT output in a steady state plasma has a decay of about 100 μs, the duration of which does not depend on the magnitude of the voltage, frequency and pulse duration. With a decrease in the supply voltage U, the pulse front duration with a photomultiplier is increased from 74 to 450 ns. It is shown that a large neon plasma relaxation time of 100 µs compared with a beam pulse duration of 1…2 µs allows only one time to change the phase of the accelerating field.


2011 ◽  
Vol 39 (11) ◽  
pp. 2440-2441 ◽  
Author(s):  
Yuki Itoh ◽  
Kazunori Takahashi ◽  
Tamiya Fujiwara

Sign in / Sign up

Export Citation Format

Share Document