scholarly journals Capturing the failure of a cohesive granular step

2021 ◽  
Vol 249 ◽  
pp. 08006
Author(s):  
Lydie Staron ◽  
Anais Abramian ◽  
Pierre-Yves Lagrée
Keyword(s):  
Shear Band ◽  
Adhesive Force ◽  
Contact Dynamics ◽  
Contact Friction ◽  
Displacement Threshold ◽  
Reproducible Behaviour

A Contact Dynamics algorithm is applied to simulate the failure of 2-dimensional granular steps. Focussing on one single value for both the adhesive force threshold and the contact friction, we track the signature of the failure in the cumulative displacement of the grains. The introduction of a displacement threshold allows for the identification of the onset of a rapid failure and the formation of the corresponding shear band. The latter gives access to an estimation of the failure orientation. The robustness of the measure thus performed for one single run is assessed by carrying out a series of 10 additional simulations, showing a fairly reproducible behaviour.

scholarly journals An Efficient Contact Model for the Simulation of Cargo Airdrop Extraction Phase

2018 ◽  
Vol 2018 ◽  
pp. 1-13
Author(s):  
Leiming Ning ◽  
Jichang Chen ◽  
Mingbo Tong
Keyword(s):  
Degrees Of Freedom ◽  
Friction Model ◽  
Rigid Bodies ◽  
Contact Dynamics ◽  
Moving Frame ◽  
Contact Friction ◽  
Practical Implementation ◽  
Contact Formulation ◽  
Efficient Code ◽  
Extraction Phase

A high-fidelity cargo airdrop simulation requires the accurate modeling of the contact dynamics between an aircraft and its cargo. This paper presents a general and efficient contact-friction model for the simulation of aircraft-cargo coupling dynamics during an airdrop extraction phase. The proposed approach has the same essence as the finite element node-to-segment contact formulation, which leads to a flexible, straightforward, and efficient code implementation. The formulation is developed under an arbitrary moving frame with both aircraft and cargo treated as general six degrees-of-freedom rigid bodies, thus eliminating the restrictions of lateral symmetric assumptions in most existing methods. Moreover, the aircraft-cargo coupling algorithm is discussed in detail, and some practical implementation details are presented. The accuracy and capability of the present method are demonstrated through four numerical examples with increasing complexity and fidelity.

scholarly journals The effect of outer ring elastodynamics on vibration and power loss of radial ball bearings

2020 ◽  
Vol 234 (4) ◽  
pp. 707-722
Author(s):  
R Turnbull ◽  
R Rahmani ◽  
H Rahnejat
Keyword(s):  
Power Loss ◽  
Beam Theory ◽  
Contact Dynamics ◽  
Outer Ring ◽  
Contact Friction ◽  
Ball Bearings ◽  
Performance Limits ◽  
Rolling Element ◽  
Generate Surface ◽  
Bearing Rings

Ball bearings are an integral part of many machines and mechanisms and often determine their performance limits. Vibration, friction and power loss are some of the key measures of bearing performance. Therefore, there have been many predictive analyses of bearing performance with emphasis on various aspects. The current study presents a mathematical model, incorporating bearing dynamics, mechanics of rolling element-to-races contacts as well as the elastodynamics of the bearing outer ring as a focus of the study. It is shown that the bearing power loss in cage cycles increases by as much as 4% when the flexibility of the outer ring is taken into account as a thick elastic ring, based on Timoshenko beam theory as opposed to the usual assumption of a rigid ring in other studies. Geometric optimisation has shown that the lifetime power consumption can be reduced by 1.25%, which is a significant source of energy saving when considering the abundance of machines using rolling element bearings. The elastodynamics of bearing rings significantly affects the radial bearing clearance through increased roller loads and generated contact pressures. The flexible ring dynamics is shown to generate surface waviness through global elastic wave propagation, not hitherto taken into account in contact dynamics of rollers-to-raceways which are generally considered to be subjected to only localised Hertzian deflection. The elastodynamic behaviour reduces the elastohydrodynamic film thickness, affecting contact friction, wear, fatigue, vibration, noise and inefficiency.

A 2D Bristle Friction Force Model for Contact Dynamics Simulation

2009 ◽  
Author(s):  
Ou Ma ◽  
Jianxun Liang ◽  
Steven Fillmore
Keyword(s):  
Contact Point ◽  
Friction Model ◽  
Contact Dynamics ◽  
Dynamics Simulation ◽  
Contact Friction ◽  
Force Model ◽  
Tangential Plane ◽  
Friction Forces ◽  
Body Contact ◽  
Frictional Behavior

This paper describes a 2D bristle contact friction model which is capable of modeling and simulating frictional behavior in both sliding and sticking regimes occurring in general 3D rigid-body contact. The model extends the 1D integrated bristle friction model to a 2D space by allowing the “bristle spring” to not only stretch along the direction of the relative velocity but also rotate due to the direction change of the velocity or motion trend in the common tangential plane of the contacting surfaces involved at the contact point of interest. With such an extension, the resulting friction model can be readily used to compute 3D contact friction forces in both sticking and sliding regimes for a general 3D contact dynamics model working with a multibody dynamics simulation application. Several simulation examples are provided to demonstrate the effectiveness of the model for predicting the experimentally seen frictional behavior such as sticking, stickslip, and sliding.

Anisotropy of damage productions in electron irradiated molybdenum

1978 ◽  
Vol 36 (1) ◽  
pp. 354-355
Author(s):  
K. Izui ◽  
S. Furuno ◽  
H. Otsu ◽  
T. Nishida ◽  
H. Maeta
Keyword(s):  
Electron Flux ◽  
Threshold Energy ◽  
High Energy ◽  
Voltage Electron ◽  
High Voltage Electron Microscope ◽  
Displacement Threshold ◽  
The Mean ◽  
Channeling Effect ◽  
Different Origins ◽  
Threshold Energies

Anisotropy of damage productions in crystals due to high energy electron bombardment are caused from two different origins. One is an anisotropic displacement threshold energy, and the other is an anisotropic distribution of electron flux near the atomic rows in crystals due to the electron channeling effect. By the n-beam dynamical calculations for germanium and molybdenum we have shown that electron flux at the atomic positions are from ∽4 to ∽7 times larger than the mean incident flux for the principal zone axis directions of incident 1 MeV electron beams, and concluded that such a locally increased electron flux results in an enhanced damage production. The present paper reports the experimental evidence for the enhanced damage production due to the locally increased electron flux and also the results of measurements of the displacement threshold energies for the <100>,<110> and <111> directions in molybdenum crystals by using a high voltage electron microscope.

Assessment of Tongue Position and Laryngeal Height in Two Professional Voice Populations

2020 ◽  
Vol 63 (1) ◽  
pp. 109-124
Author(s):  
Carly Jo Hosbach-Cannon ◽  
Soren Y. Lowell ◽  
Raymond H. Colton ◽  
Richard T. Kelley ◽  
Xue Bao
Keyword(s):  
Vocal Fold ◽  
Vocal Tract ◽  
Current Knowledge ◽  
Acoustic Resonance ◽  
Contact Dynamics ◽  
Voice Disorder ◽  
Music Program ◽  
Tongue Position ◽  
Singer Groups ◽  
Professional Voice

Purpose To advance our current knowledge of singer physiology by using ultrasonography in combination with acoustic measures to compare physiological differences between musical theater (MT) and opera (OP) singers under controlled phonation conditions. Primary objectives addressed in this study were (a) to determine if differences in hyolaryngeal and vocal fold contact dynamics occur between two professional voice populations (MT and OP) during singing tasks and (b) to determine if differences occur between MT and OP singers in oral configuration and associated acoustic resonance during singing tasks. Method Twenty-one singers (10 MT and 11 OP) were included. All participants were currently enrolled in a music program. Experimental procedures consisted of sustained phonation on the vowels /i/ and /ɑ/ during both a low-pitch task and a high-pitch task. Measures of hyolaryngeal elevation, tongue height, and tongue advancement were assessed using ultrasonography. Vocal fold contact dynamics were measured using electroglottography. Simultaneous acoustic recordings were obtained during all ultrasonography procedures for analysis of the first two formant frequencies. Results Significant oral configuration differences, reflected by measures of tongue height and tongue advancement, were seen between groups. Measures of acoustic resonance also showed significant differences between groups during specific tasks. Both singer groups significantly raised their hyoid position when singing high-pitched vowels, but hyoid elevation was not statistically different between groups. Likewise, vocal fold contact dynamics did not significantly differentiate the two singer groups. Conclusions These findings suggest that, under controlled phonation conditions, MT singers alter their oral configuration and achieve differing resultant formants as compared with OP singers. Because singers are at a high risk of developing a voice disorder, understanding how these two groups of singers adjust their vocal tract configuration during their specific singing genre may help to identify risky vocal behavior and provide a basis for prevention of voice disorders.

SHEAR BAND OBSERVATIONS AND DERIVATIONS OF REQUIREMENTS FOR A SHEAR BAND MODEL

1985 ◽  
Vol 46 (C5) ◽  
pp. C5-273-C5-282
Author(s):  
L. Seaman ◽  
D. R. Curran ◽  
D. C. Erlich ◽  
T. Cooper ◽  
O. Dullum
Keyword(s):  
Shear Band ◽  
Band Model

Nanorobots Sense Local Physiochemical Heterogeneities of Tumor Matrisome

2020 ◽  
Author(s):  
Debayan Dasgupta ◽  
Dharma Pally ◽  
Deepak K. Saini ◽  
Ramray Bhat ◽  
Ambarish Ghosh
Keyword(s):  
Cell Lines ◽  
Cancer Cell ◽  
Cancer Cell Lines ◽  
Adhesive Force ◽  
Surrounding Tissue ◽  
Quantitative Measurements ◽  
Malignant Breast Tumor ◽  
Malignant Breast ◽  
Cancer Dissemination

The dissemination of cancer is brought about by continuous interaction of malignant cells with their surrounding tissue microenvironment. Understanding and quantifying the remodeling of local extracellular matrix (ECM) by invading cells can therefore provide fundamental insights into the dynamics of cancer dissemination. In this paper, we use an active and untethered nanomechanical tool, realized as magnetically driven nanorobots, to locally probe a 3D tissue culture microenvironment consisting of cancerous and non-cancerous epithelia, embedded within reconstituted basement membrane (rBM) matrix. Our assay is designed to mimic the in vivo histopathological milieu of a malignant breast tumor. We find that nanorobots preferentially adhere to the ECM near cancer cells: this is due to the distinct charge conditions of the cancer-remodeled ECM. Surprisingly, quantitative measurements estimate that the adhesive force increases with the metastatic ability of cancer cell lines, while the spatial extent of the remodeled ECM was measured to be approximately 40 μm for all cancer cell lines studied here. We hypothesized and experimentally confirmed that specific sialic acid linkages specific to cancer-secreted ECM may be a major contributing factor in determining this adhesive behavior. The findings reported here can lead to promising applications in cancer diagnosis, quantification of cancer aggression, in vivo drug delivery applications, and establishes the tremendous potential of magnetic nanorobots for fundamental studies of cancer biomechanics.

Sign in / Sign up

Export Citation Format

Share Document