Use of Dynamic Measurements to Drive High Capacity Concrete Piles in Washington's Potomac Formation

2009 ◽  
Author(s):  
John E. Regan ◽  
Karl A. Higgins, III
Keyword(s):  
High Capacity ◽  
Dynamic Measurements ◽  
Concrete Piles

Driven high capacity H-piles in Hong Kong saprolites: A reliability evaluation of two methods

2008 ◽  
Vol 45 (1) ◽  
pp. 124-130
Author(s):  
S. R. Lo ◽  
K. S. Li ◽  
J. Lam
Keyword(s):  
Hong Kong ◽  
Reliability Index ◽  
Objective Assessment ◽  
High Capacity ◽  
Prediction Method ◽  
Prediction Methods ◽  
Dynamic Measurements ◽  
Bias Factor ◽  
Coefficients Of Variation ◽  
Load Tests

A database for high capacity driven H-piles in Hong Kong saprolites was established so that predicted pile capacities could be compared to values measured by maintained load tests. This gave the statistical attributes that were needed for reliability analyses. Two prediction methods based on set value and dynamic measurements were examined. The uncertainty of a prediction method is characterized by a bias factor. The coefficients of variation of bias factors for both prediction methods are small in the context of geotechnical engineering. A simplified reliability analysis was conducted using the statistical attributes of the database. This enabled an objective assessment of the two prediction methods. Both prediction methods perform equally well relative to the current Hong Kong practice of targetting an overall safety factor of two on geotechnical capacity. The reliability index achieved by current Hong Kong practice for high capacity driven H-piles is in excess of three.

CuS2 sheets: a hidden anode material with a high capacity for sodium-ion batteries

2021 ◽  
Author(s):  
Shaohua Lu ◽  
Weidong Hu ◽  
Xiaojun Hu
Keyword(s):  
Lithium Ion Batteries ◽  
Anode Material ◽  
Low Cost ◽  
High Capacity ◽  
Lithium Ion ◽  
Sodium Ion ◽  
Sodium Ion Batteries

Due to their low cost and improved safety compared to lithium-ion batteries, sodium-ion batteries have attracted worldwide attention in recent decades.

Receptor Mediated Binding of the Fibrinolytic Components, Plasminogen and Urokinase, to Peripheral Blood Cells

1987 ◽  
Vol 58 (03) ◽  
pp. 936-942 ◽  
Author(s):  
Lindsey A Miles ◽  
Edward F Plow
Keyword(s):  
T Cells ◽  
B Cell ◽  
Peripheral Blood ◽  
Binding Sites ◽  
Blood Cells ◽  
High Capacity ◽  
Red Cells ◽  
Peripheral Blood Cells ◽  
Cellular Functions ◽  
Fibrinolytic Proteins

SummaryGlu-plasminogen binds to platelets; the monocytoid line, U937, and the human fetal fibroblast line, GM1380 bind both plasminogen and its activator, urokinase. This study assesses the interaction of these fibrinolytic proteins with circulating human blood cells. Plasminogen bound minimally to red cells but bound saturably and reversibly to monocytes, granulocytes and lymphocytes with apparent Kd values of 0.9-1.4 μM. The interactions were of high capacity with 1.6 to 49 × 105 sites/cell and involved the lysine binding sites of plasminogen. Both T cells and non-rosetting lymphocytes and two B cell lines saturably bound plasminogen. Urokinase bound saturably to gianulocytes, monocytes, non-rosetting lymphocytes and a B cell line, but minimally to T cells, platelets and red cells. Therefore, plasminogen binding sites of high capacity, of similar affinities, and with common recognition specificities are expressed by many peripheral blood cells. Urokinase receptors are also widely distributed, but less so than plasminogen binding sites. The binding ol plasminogen and/ or urokinase to these cells may lead to generation of cell- associated proteolytic activity which contributes to a variety of cellular functions.

Abnormal Platelet Serotonin Uptake and Binding Sites in Myeloproliferative Disorders

1984 ◽  
Vol 51 (03) ◽  
pp. 349-353 ◽  
Author(s):  
C Caranobe ◽  
P Sié ◽  
F Fernandez ◽  
J Pris ◽  
S Moatti ◽  
...  
Keyword(s):  
Binding Sites ◽  
High Capacity ◽  
Specific Inhibitor ◽  
Myeloproliferative Disorders ◽  
Normal Subjects ◽  
Binding Data ◽  
Full Explanation ◽  
Number Of Binding Sites ◽  
5 Ht Uptake ◽  
Kinetics Of

SummaryA simultaneous investigation of the kinetics of serotonin (5 HT) uptake and of binding sites was carried out in the platelets of normal subjects and of 10 patients affected with various types of myeloproliferative disorders (MD). The 5 HT uptake was analysed according to the Lineweaver-Burk and the Eadie-Hofstee methods. With the two methods, the patient’s platelets exhibited a dramatic reduction of the Vi max and of the Km; in some patients the Eadie-Hofstee analysis revealed that a passive diffusion phenomenon is superimposed on the active 5 HT uptake at least for the higher concentration used. The binding data were analysed with the Scatchard method. Two classes of binding sites (high affinity - low capacity, low affinity - high capacity) were found in normal subjects and patients. Pharmacological studies with imipramine, a specific inhibitor of 5 HT uptake, suggested that both the sites are involved in 5 HT uptake. The number of both binding sites was significantly decreased in patient’s platelets while the affinity constants of these binding sites were not significantly reduced in comparison with those of the control subjects. No correlations were found between Vi max, Km and the number of binding sites. These results suggest that a reduction in the number of platelet membrane acceptors for 5 HT commonly occurs in myeloproliferative disorders but does not provide a full explanation of the uptake defect.

APPLICATION OF PRESSED PIPE-CONCRETE PILES, AT RECONSTRUCTION OF THE ENGINEERING AND LABORATORY CASE PAT "KHMELNYTSKOBLENERGO"

2020 ◽  
Vol 0 (6) ◽  
pp. 64-71
Author(s):  
Bohdan Demchyna ◽  
Yurii Kunanets ◽  
Mykhailo Surmai ◽  
Yevhen Hlavatskyi
Keyword(s):  
Concrete Piles

Dimensioning a recovery boiler furnace using mathematical optimization

TAPPI Journal ◽  
2015 ◽  
Vol 14 (2) ◽  
pp. 119-129 ◽  
Author(s):  
VILJAMI MAAKALA ◽  
PASI MIIKKULAINEN
Keyword(s):  
Radial Basis Function Network ◽  
High Capacity ◽  
Mathematical Optimization ◽  
Optimization Procedure ◽  
Optimization Method ◽  
Performance Criteria ◽  
Boiler Furnace ◽  
Starting Point ◽  
Recovery Boiler ◽  
Base Design

Capacities of the largest new recovery boilers are steadily rising, and there is every reason to expect this trend to continue. However, the furnace designs for these large boilers have not been optimized and, in general, are based on semiheuristic rules and experience with smaller boilers. We present a multiobjective optimization code suitable for diverse optimization tasks and use it to dimension a high-capacity recovery boiler furnace. The objective was to find the furnace dimensions (width, depth, and height) that optimize eight performance criteria while satisfying additional inequality constraints. The optimization procedure was carried out in a fully automatic manner by means of the code, which is based on a genetic algorithm optimization method and a radial basis function network surrogate model. The code was coupled with a recovery boiler furnace computational fluid dynamics model that was used to obtain performance information on the individual furnace designs considered. The optimization code found numerous furnace geometries that deliver better performance than the base design, which was taken as a starting point. We propose one of these as a better design for the high-capacity recovery boiler. In particular, the proposed design reduces the number of liquor particles landing on the walls by 37%, the average carbon monoxide (CO) content at nose level by 81%, and the regions of high CO content at nose level by 78% from the values obtained with the base design. We show that optimizing the furnace design can significantly improve recovery boiler performance.

Sign in / Sign up

Export Citation Format

Share Document