Environmental factors affecting the capture of southern hairy-nosed wombats (Lasiorhinus latifrons) by stunning

2003 ◽  
Vol 30 (5) ◽  
pp. 539 ◽  
Author(s):  
David A. Taggart ◽  
Graeme R. Finlayson ◽  
Nadine Richings ◽  
Glenn Shimmin ◽  
Ron Dibben ◽  
...  

A 'stunning' technique, combining a rifle shot with spotlighting and hand netting was used for the live-capture of southern hairy-nosed wombats. A successful stun was defined as a rifle shot that resulted in the temporary deafening and disorientation of a wombat. When combined with spotlighting, this technique enabled catchers with nets to approach the wombat undetected to secure an easy capture. Environmental factors (temperature, humidity, dew point, light and wind) were examined in order to determine the optimal conditions for the use of this capture procedure. In all, 558 shots were fired, resulting in ~25% of successful stuns. Stunning was primarily affected by temperature and humidity in a normally distributed manner. Stunning was greatest between 12°C and 18°C with a success rate of 40–51%. At temperatures either side of this significantly fewer stuns were achieved, and below 6°C or above 24°C no successful stuns were recorded. Likewise, stunning worked best at humiditys of 70–90%, declined when humidity was >90% and did not work at all at a humidity of 40% or less. Together, temperature and humidity data suggest that air density, for which these parameters are correlates, may be the key component in the success of this capture technique. Variation in stunning success resulting from changes in temperature and humidity may affect either the frequency spectrum of the sound created by the shot or perhaps the manner in which the eardrum receives the sound. Other factors, including dew point and light, also varied significantly with stunning, but were considered of less importance. Whatever the controlling factors, it was clear that stunning, in combination with spotlighting and netting is a rapid, highly effective, and potentially much less stressful method of capturing southern hairy-nosed wombats than the methods that have been used previously.

1997 ◽  
Vol 87 (2) ◽  
pp. 191-196 ◽  
Author(s):  
Y. Cohen ◽  
S. Farkash ◽  
Z. Reshit ◽  
A. Baider

Fungal, host, and environmental factors affecting sexual reproduction of Phytophthora infestans in planta were studied. Intact and detached leaves were coinoculated with sporangia of various combinations of A1 and A2 mating-type isolates; leaves were incubated under various conditions, and oospore production was estimated microscopically within whole, clarified leaflets. Some A1 + A2 isolate combinations were more reproductive than others, whereas some potato genotypes better supported oospore formation than others. Tomato usually supported more oospore formation than potato. To induce oospore formation, A1 and A2 sporangia were usually mixed at a 1:1 ratio. Ratios of 1:19 to 19:1, however, also allowed abundant production of oospores. Optimal temperatures for sexual sporulation ranged from 8 to 15°C, but oospores also were produced at 23°C. Oogonia developed 5 to 6 days after sporangial coinoculation, and oospores developed after 8 to 10 days. Light had little effect on oospore formation in both tomato and potato leaves provided that initial lesions were established under photoperiodic conditions. Although A1 and A2 sporangia usually were mixed before inoculation on leaves to obtain oospores, we found that discrete A1 and A2 lesions produced on opposite sides of the midvein of tomato leaves also induced oospore formation in the midvein and adjacent tissues. Oospores also formed when the two halves of the leaves were cut and separated at 3 days after sporangial coinoculation, which corresponded with the appearance of late blight lesions. The continuous supply of moisture to infected leaves was essential to oospore production. No oospores or oogonia formed in severely diseased plants kept at 50 to 80% relative humidity. Such plants did allow some oospore formation when kept continuously wet for 2 weeks in plastic boxes or tents. Detached leaves floated on water supported the highest sexual sporulation. Under optimal conditions of wetness and temperature, as many as 100 oospores per mm2 of tissue were observed.


1979 ◽  
Vol 18 (02) ◽  
pp. 89-97 ◽  
Author(s):  
Martha E. Smith ◽  
H. B. Newcombe

Empirical tests of the application of computer record linkage methods versus the use of routine clerical searching, for bringing together various vital and ill-health records, have shown that the success rate for the computer operation was higher (98.3 versus 96.7 per cent) and the proportion of false linkages very much lower (0.1 versus 2.3 per cent). The rate at which the ill-health records were processed by the computer was approximately 14,000 per minute of central processor time, representing a cost of a half a cent apiece.Factors affecting the speed, accuracy and cost of computerized record linkage are discussed.


Author(s):  
Jie Zhu ◽  
Soo Sien Seah ◽  
Irene Tee ◽  
Bing Hai Liu ◽  
Eddie Er ◽  
...  

Abstract In this paper, we describe automated FIB for TEM sample preparation using iFast software on a Helios 450HP dual-beam system. A robust iFast automation recipe needs to consider as many variables as possible in order to ensure consistent sample quality and high success rate. Variations mainly come from samples of different materials, structures, surface patterns, surface topography and surface charging. The recipe also needs to be user-friendly and provide high flexibility by allowing users to choose preferable working parameters for specific types of samples, such as: grounding, protective layer coating, milling steps, and final TEM lamella thickness/width. In addition to the iFast recipe, other practical factors affecting automation success rate are also discussed and highlighted.


Author(s):  
Marina Vasilenko ◽  
Marina Vasilenko ◽  
Elena Goncharova ◽  
Elena Goncharova ◽  
Yury Rubanov ◽  
...  

The surfaces of building materials of hydrotechnical constructions undergo the process of algae biofouling. The degree of damage depends on the environmental factors that are affect-ed by the level of anthropogenic load areas. Modeling the biofouling process of concrete with algae under laboratory conditions has allowed determining their impact on the building ma-terial, accompanied by changes in chemical and mineralogical composition of the surface of products. The microscopic examination of sample’s surfaces and evaluation of the effective-ness of various ions leaching from building materials shows the results of "algal attack" relat-ed to the acceleration of biodegradation of materials under the influence of aggressive meta-bolic products, mechanical action neoplasms, creating optimal conditions for the development of subsequent aerobic microbial decomposers. To clarify the nature of chemical processes in the system “algocenosis – concrete” the changes of chemical and phase (mineralogical) com-position of the surface layer of concrete sample were studied. The effect that algae produce on hydraulic engineering constructions is due to the fact that these organisms, belonging to phototrophs and standing at the beginning of the food chain, initiate new microbial growth.


Author(s):  
Marina Vasilenko ◽  
Marina Vasilenko ◽  
Elena Goncharova ◽  
Elena Goncharova ◽  
Yury Rubanov ◽  
...  

The surfaces of building materials of hydrotechnical constructions undergo the process of algae biofouling. The degree of damage depends on the environmental factors that are affect-ed by the level of anthropogenic load areas. Modeling the biofouling process of concrete with algae under laboratory conditions has allowed determining their impact on the building ma-terial, accompanied by changes in chemical and mineralogical composition of the surface of products. The microscopic examination of sample’s surfaces and evaluation of the effective-ness of various ions leaching from building materials shows the results of "algal attack" relat-ed to the acceleration of biodegradation of materials under the influence of aggressive meta-bolic products, mechanical action neoplasms, creating optimal conditions for the development of subsequent aerobic microbial decomposers. To clarify the nature of chemical processes in the system “algocenosis – concrete” the changes of chemical and phase (mineralogical) com-position of the surface layer of concrete sample were studied. The effect that algae produce on hydraulic engineering constructions is due to the fact that these organisms, belonging to phototrophs and standing at the beginning of the food chain, initiate new microbial growth.


2020 ◽  
Vol 169 ◽  
pp. 102915 ◽  
Author(s):  
L.M. Martínez Álvarez ◽  
L.A.M. Ruberto ◽  
J.M. Gurevich ◽  
W.P. Mac Cormack

Sign in / Sign up

Export Citation Format

Share Document