Long-Term Exposure to Sulfur Dioxide, Sulfuric Acid Mist, Fly Ash, and Their Mixtures

1975 ◽  
Vol 30 (5) ◽  
pp. 254-262 ◽  
Author(s):  
Yves C. Alarie ◽  
Alexis A. Krumm ◽  
William M. Busey ◽  
Charles E. Ulrich ◽  
Robert J. Kantz
2017 ◽  
Vol 14 (7) ◽  
pp. 562-571 ◽  
Author(s):  
Chih-Hsiang Chien ◽  
Alexandros Theodore ◽  
Chufan Zhou ◽  
Chang-Yu Wu ◽  
Yu-Mei Hsu ◽  
...  

2011 ◽  
Vol 261-263 ◽  
pp. 306-312
Author(s):  
Hong Guang Min ◽  
Zhi Gang Song ◽  
Yan Tao Li ◽  
Yi Jie Shen

A long term immersion test of mortar in sulfuric acid is carried out to investigate the effects of fly ash (FA) and silica fume (SF) on anti-corrosion characteristics. The mortar specimens have water to binder ratios (W/B) ranging from 0.5 to 0.7 and are divided into two series. Series one uses admixture of FA with replacement ratio from 0~0.3 and series two uses admixture of SF with replacement ratio from 0~0.1. The specimens are soaked in sulfuric acid with a pH value of 3.50 for 150 days. The portable pH meter is used to monitor the pH changing of the soak solution. The titrating sulfuric acid with concentration of 0.125mol/l is added to maintain the original pH value of the solution and then sulfuric acid consumption of specimens is recorded. A partial correlation analysis of experiment results shows that the effects of FA and SF on mortar resistance to sulfuric acid would change with the water binder ratio.


2015 ◽  
Vol 286 ◽  
pp. 517-524 ◽  
Author(s):  
Yuehong Shu ◽  
Xiangyu Wei ◽  
Yu Fang ◽  
Bingyan Lan ◽  
Hongyu Chen

1973 ◽  
Vol 27 (4) ◽  
pp. 251-253 ◽  
Author(s):  
Yves Alarie ◽  
Robert J. Kantz ◽  
Charles E. Ulrich ◽  
Alexis A. Krumm ◽  
William M. Busey

1979 ◽  
Vol 19 (2) ◽  
pp. 244-257 ◽  
Author(s):  
James D. Fenters ◽  
Jeannie N. Bradof ◽  
C. Aranyi ◽  
K. Ketels ◽  
R. Ehrlich ◽  
...  

Author(s):  
John M. Preston ◽  
W. Reid Watson ◽  
Charles B. Jones

Modern combustion steam-electric plants are designed to recover as much heat as economically feasible from the combustion products. As a part of the continuing effort by utilities to increase plant efficiency, extracting low quality heat from the flue gas stream prior to discharge through the stack to the environment has become economically attractive. “Economic feasibility” is strongly dependent on the cost of the fuel as well as quality of the heat recovered. The economic feasibility of deploying low-temperature economizers to cool flue gas from coal-fired steam-electric plants to a temperature well below the sulfuric acid mist dew point is not commonly practiced but could have a number of salutary effects on unit operations including reduction in fuel use, reduction in water, reduction in fly ash resistivity upstream of cold-side electrostatic precipitators and enhanced mercury oxidation/capture. Using a theoretical 600 MW (nominal) coal fired facility an additional 30.8 MW of electrical output is available with the installation of a Low Temperature Economizer. This represents a 1% improvement in the plant heat rate with an attractive payback period. The components required for this heat recovery sub-system are readily available and the technology has matured to a point where uncertainties are minimized. In addition to improving the operation of the plant, Low Temperature Economizer can reduce emissions of SOx, NOx, Hg, PM and CO2. In a difficult regulatory environment reducing emissions while increasing plant performance is extremely beneficial. Furthermore Low Temperature Economizer lowers the volume of scrubber water required. Cooling the flue gas leaving the air heater below the acid mist dew point is not commonly practiced. The corrosion potential of the condensed sulfuric acid is a major materials selection/maintenance challenge as is the potential for gas-side fouling of the heat exchange surface with fly ash.


2017 ◽  
Vol 142 ◽  
pp. 3307-3312 ◽  
Author(s):  
Yubo Zhang ◽  
Yu Yan ◽  
Jianhua Liu ◽  
Qingwen Qi ◽  
Lei Deng ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document