Dental enamel is the most highly mineralised and hardest biological tissue in human body [1]. Dental enamel is made of hydroxylapatite (HAP) - Ca5(PO4)3(OH), which is hexagonal (6/m). The lattice parameters are a = b = 0.9418 nm und c = 0.6875 nm [1]. Although HAP is a very hard mineral, it can be dissolved easily in a process which is known as enamel demineralization by lactic acid produced by bacteria. Also the direct consumption of acid (e.g. citric, lactic or phosphoric acid in soft drinks) can harm the dental enamel in a similar way. These processes can damage the dental enamel. It will be dissolved completely and a cavity occurs. The cavity must then be cleaned and filled. It exists a lot of dental fillings, like gold, amalgam, ceramics or polymeric materials. After filling other dangers can occur: The mechanical properties of the materials used to fill cavities can differ strongly from the ones of the dental enamel itself. In the worst case, the filling of a tooth can damage the enamel of the opposite tooth by chewing if the interaction of enamel and filling is not equivalent, so that the harder fillings can abrade the softer enamel of the healthy tooth at the opposite side. This could be avoided if the anisotropic mechanical properties of dental enamel would be known in detail, hence then another filling could be searched or fabricated as an equivalent opponent for the dental enamel with equal properties. To find such a material, one has to characterise the properties of dental enamel first in detail for the different types of teeth (incisor, canine, premolar and molar). This is here exemplary done for a human incisor tooth by texture analysis with the program MAUD from 2D synchrotron transmission images [2,3,4].
Assessment of climatic processability of polymeric materials used in the repair of machines in the Arctic
