Study of epoxy shielding material with barium sulphate for development of radiation protection materials in low-dose diagnostic X-ray

Author(s):  
Nuttapong Danthanavat ◽  
Manus Mongkolsuk ◽  
Gunjanaporn Tochaikul ◽  
Soontaree Sriwongta ◽  
Atitaya Piyajaroenporn ◽  
...  
2006 ◽  
Vol 79 (5) ◽  
pp. 870-880 ◽  
Author(s):  
V. S. Nisha ◽  
Rani Joseph

Abstract Currently radiopaque polymers are of great interest to medicine and dentistry because of their wide area of applications such as catheters, surgical tools, dental products, radiation shielders etc. Lead has historically been used as the shielding material, but not without health and environmental concerns. In this work, we have prepared radiopaque materials from natural rubber (NR) through different routes. Natural rubber was iodinated and characterized using UV-VIS spectroscopy, thermo gravimetric analysis and clinical X-ray techniques. The physical properties of Iodinated NR compounds prepared at ambient and high temperatures were studied. The low temperature cured samples showed better radiopacity and conductivity than high temperature cured samples. Radiopaque NR was prepared using radiopacifiers like barytes, barium sulphate, zinc oxide and active zinc oxide. The physical properties of the NR vulcanizates with different radiopacifiers were studied. Clinical X-ray techniques have been used to confirm the radiopacity. The optical density of the samples were measured and compared with that of conventionally used lead shield.


Author(s):  
T. Oikawa ◽  
N. Mori ◽  
T. Katoh ◽  
Y. Harada ◽  
J. Miyahara ◽  
...  

The “Imaging Plate”(IP) is a highly sensitive image recording plate for X-ray radiography. It has been ascertained that the IP has superior properties and high practicability as an image recording material in a TEM. The sensitivity, one of the properties, is about 3 orders higher than that of conventional photo film. The IP is expected to be applied to low dose techniques. In this paper, an estimation of the quantum noise on the TEM image which appears in case of low electron dose on the IP is reported.In this experiment, the JEM-2000FX TEM and an IP having the same size as photo film were used.Figure 1 shows the schematic diagram of the total system including the TEM used in this experiment. In the reader, He-Ne laser light is scanned across the IP, then blue light is emitted from the IP.


Author(s):  
John A. Hunt ◽  
Richard D. Leapman ◽  
David B. Williams

Interactive MASI involves controlling the raster of a STEM or SEM probe to areas predefined byan integration mask which is formed by image processing, drawing or selecting regions manually. EELS, x-ray, or other spectra are then acquired while the probe is scanning over the areas defined by the integration mask. The technique has several advantages: (1) Low-dose spectra can be acquired by averaging the dose over a great many similar features. (2) MASI can eliminate the risks of spatial under- or over-sampling of multiple, complicated, and irregularly shaped objects. (3) MASI is an extremely rapid and convenient way to record spectra for routine analysis. The technique is performed as follows:Acquire reference imageOptionally blank beam for beam-sensitive specimensUse image processor to select integration mask from reference imageCalculate scanning path for probeUnblank probe (if blanked)Correct for specimen drift since reference image acquisition


Author(s):  
T.W. Jeng ◽  
W. Chiu

With the advances in preparing biological materials in a thin and highly ordered form, and in maintaining them hydrated under vacuum, electron crystallography has become an important tool for biological structure investigation at high resolution (1,2). However, the electron radiation damage would limit the capability of recording reflections with low intensities in an electron diffraction pattern. It has been demonstrated that the use of a low temperature stage can reduce the radiation damage effect and that one can expose the specimen with a higher dose in order to increase the signal contrast (3). A further improvement can be made by selecting a proper photographic emulsion. The primary factors in evaluating the suitability of photographic emulsion for recording low dose diffraction patterns are speed, fog level, electron response at low electron exposure, linearity, and usable range of exposure. We have compared these factors with three photographic emulsions including Kodak electron microscopic plate (EMP), Industrex AA x-ray film (AA x-ray) and Kodak nuclear track film (NTB3).


2020 ◽  
Author(s):  
S. Economides ◽  
C.J. Hourdakis ◽  
C. Pafilis ◽  
G. Simantirakis ◽  
P. Tritakis ◽  
...  

This paper concerns an analysis regarding the performance of X-ray equipment as well as the radiological safety in veterinary facilities. Data were collected from 380 X-ray veterinary facilities countrywide during the on-site regulatory inspections carried out by the Greek Atomic Energy Commission. The analysis of the results shows that the majority of the veterinary radiographic systems perform within the acceptable limits; moreover, the design and shielding of X-ray rooms as well as the applied procedures ensure a high level of radiological safety for the practitioners, operators and the members of the public. An issue that requires specific attention in the optimization process for the proper implementation of veterinary radiology practices in terms of radiological safety is the continuous training of the personnel. The above findings and the regulatory experience gained were valuable decision-making elements regarding the type of the regulatory control of veterinary radiology practices in the new radiation protection framework.


2021 ◽  
pp. 2004391
Author(s):  
Youbin Li ◽  
Mingyang Jiang ◽  
Zhiming Deng ◽  
Songjun Zeng ◽  
Jianhua Hao
Keyword(s):  
Low Dose ◽  
X Ray ◽  

Sign in / Sign up

Export Citation Format

Share Document