Ion diffusion-controlled thermally stimulated processes in X-ray irradiated halide crystals

2002 ◽  
Vol 157 (6-12) ◽  
pp. 755-759 ◽  
Author(s):  
V. Ziraps ◽  
V. Graveris ◽  
P. Kulis ◽  
I. Tale
Keyword(s):  
Ion Diffusion ◽  
X Ray ◽  
Diffusion Controlled

Ion diffusion-controlled thermally stimulated processes in x-ray irradiated halide crystals

2003 ◽  
Vol 158 (8) ◽  
pp. 567-571 ◽  
Author(s):  
V. Ziraps ◽  
V. Graveris ◽  
P. Kulis ◽  
I. Tale
Keyword(s):  
Ion Diffusion ◽  
X Ray ◽  
Diffusion Controlled

A TEM investigation of a hyper-eutectic lead-tin alloy

1988 ◽  
Vol 46 ◽  
pp. 562-563
Author(s):  
John A. Sutliff
Keyword(s):  
Volume Diffusion ◽  
Eutectic Mixture ◽  
Precipitation Reaction ◽  
Directionally Solidified ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Diffusion Controlled ◽  
Discontinuous Precipitation Reaction ◽  
Controlled Precipitation

Near-eutectic Pb-Sn alloys are important solders used by the electronics industry. In these solders, the eutectic mixture, which solidifies last, is the important microstructural consituent. The orientation relation (OR) between the eutectic phases has previously been determined for directionally solidified (DS) eutectic alloys using x-ray diffraction or electron chanelling techniques. In the present investigation the microstructure of a conventionally cast, hyper-eutectic Pb-Sn alloy was examined by transmission electron microscopy (TEM) and the OR between the eutectic phases was determined by electron diffraction. Precipitates of Sn in Pb were also observed and the OR determined. The same OR was found in both the eutectic and precipitation reacted materials. While the precipitation of Sn in Pb was previously shown to occur by a discontinuous precipitation reaction,3 the present work confirms a recent finding that volume diffusion controlled precipitation can also occur.Samples that are representative of the solder's cast microstructure are difficult to prepare for TEM because the alloy is multiphase and the phases are soft.

Structural, Optical, Photocatalytic and Electrochemical Studies of PbS Nanoparticles

2020 ◽  
Vol 61 ◽  
pp. 18-31 ◽  
Author(s):  
Peter A. Ajibade ◽  
Abimbola E. Oluwalana
Keyword(s):  
Particle Sizes ◽  
X Ray Diffraction ◽  
Lead Sulphide ◽  
Electron Transfer Process ◽  
Sem Images ◽  
Pbs Nanoparticles ◽  
X Ray ◽  
Diffusion Controlled ◽  
Reversible Redox ◽  
Diffraction Patterns

Oleic acid (OA) and octadecylamine (ODA) capped lead sulphide (PbS) nanoparticles were prepared at 150, 190 and 230 °C. X-ray diffraction patterns indicates that the synthesized PbS nanoparticles were in the rock cubic salt crystalline phase. The particle sizes of the as-prepared PbS nanoparticles are in the range 2.91–10.05 nm for OA-PbS(150), 24.92–39.98 nm for ODA-PbS(150), 9.26 – 29.08 nm for OA-PbS(190), 34.54 – 48.04 nm for ODA-PbS(190), 17.96–88.07 nm for OA-PbS(230) and 53.60 – 94.42 nm for ODA-PbS(230). SEM images revealed flaky and agglomerated spherical like morphology for the nanoparticles. The energy bandgap of the PbS nanoparticles are in the range 4.14 – 4.25 eV, OA-PbS(230) have the lowest bandgap of 4.14 eV while ODA-PbS(150) have the highest bandgap of 4.25 eV. The PbS nanoparticles were used as photocatalyst for the degradation of Rhodamine B and OA-PbS(150) showed efficiency of 44.11% after 360 mins. Cyclic voltammetry of the PbS nanoparticles showed a reversible redox reaction and linear Randles-Sevcik plots indicates electron transfer process is diffusion controlled.

scholarly journals [FeII(L•)2][TCNQF4•−]2: A Redox-Active Double Radical Salt

2019 ◽  
Vol 72 (10) ◽  
pp. 769 ◽  
Author(s):  
Ian A. Gass ◽  
Jinzhen Lu ◽  
Ruchika Ojha ◽  
Mousa Asadi ◽  
David W. Lupton ◽  
...  
Keyword(s):  
Fourier Transform ◽  
Radical Anion ◽  
Electrochemical Studies ◽  
X Ray Diffraction ◽  
Neutral Radical ◽  
X Ray ◽  
Redox Active ◽  
Diffusion Controlled ◽  
Radical Salt ◽  
Radical Ligand

The reaction of [FeII(L•)2][BF4]2 with LiTCNQF4 results in the formation of [FeII(L•)2][TCNQF4•−]2·2CH3CN (1) (L• is the neutral aminoxyl radical ligand 4,4-dimethyl-2,2-di(2-pyridyl)oxazolidine-N-oxide; TCNQF4 is 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane). Single-crystal X-ray diffraction; Raman, Fourier-transform infrared (FTIR) and ultraviolet–visible spectroscopies; and electrochemical studies are all consistent with the presence of a low-spin FeII ion, the neutral radical form (L•) of the ligand, and the radical anion TCNQF4•−. 1 is largely diamagnetic and the electrochemistry shows five well-resolved, diffusion-controlled, reversible one-electron processes.

On the Mechanism of Milling Induced Disordering in AlFe

1996 ◽  
Vol 460 ◽  
Author(s):  
M. T. Clavaguera-Mora ◽  
J. Zhu ◽  
M. Meyer ◽  
L. Mendoza-Zelis ◽  
F. H. Sanchez ◽  
...  
Keyword(s):  
Long Range ◽  
Milling Time ◽  
Continuous Heating ◽  
X Ray Diffraction ◽  
Mechanical Grinding ◽  
Scanning Calorimetry ◽  
X Ray ◽  
Diffusion Controlled ◽  
Transmission Mössbauer Spectroscopy ◽  
Kinetics Of

ABSTRACTThe evolution of the B2-AlFe phase during mechanical grinding in Ar has been examined as a function of milling time by X-Ray diffraction, transmission Mössbauer spectroscopy and differential scanning calorimetry. Short and long range disorder was observed to increase with the mechanical treatment up to the attainment of a steady state. The evolution of the long range order parameter and of the local atomic configurations at Fe sites were analyzed in terms of possible mechanisms for milling induced disordering. The kinetics of the thermal reordering was studied under continuous heating and isothermal calorimetrie regimes. Modeling of the reordering processes by diffusion controlled growth of pre-existing ordered grains is presented as well as the estimated values of both the enthalpy and the activation energy of the reordering process. The results are consistent with a non uniform distribution of disorder throughout the sample and will be compared with preceding information on related systems.

Ion Irradiation Effects in Solid Oxide Fuel Cell Electrolytes

2003 ◽  
Vol 801 ◽  
Author(s):  
Jeremy Cheng ◽  
Rojana Pornprasertsuk ◽  
Yuji Saito ◽  
Fritz B. Prinz
Keyword(s):  
Ion Irradiation ◽  
Depth Profiling ◽  
Surface Conductance ◽  
Dislocation Network ◽  
Ion Diffusion ◽  
X Ray Diffraction ◽  
Saturation Point ◽  
X Ray ◽  
Cell Electrolytes ◽  
Fuel Cell Electrolytes

ABSTRACTSingle crystal Ytrria-stabilized Zirconia was irradiated with Xe2+ and Xe3+ ions at 320 and 450 keV over a range of doses from 1013 to 1016 ions/cm2. Damage appears as a 150 nm surface layer with a dense dislocation network. The X-ray diffraction pattern shows an increasing lattice expansion with increasing dose that reaches a saturation point. Ion irradiation increases the surface conductance of the material; this effect is removed with certain post-treatments. Preliminary isotope depth profiling indicates enhanced ion diffusion in the damaged layer.

scholarly journals Study on the Phase Transformation Kinetics of Sol-Gel DrivedTiO2Nanoparticles

2010 ◽  
Vol 2010 ◽  
pp. 1-5 ◽  
Author(s):  
H. Mehranpour ◽  
M. Askari ◽  
M. Sasani Ghamsari ◽  
H. Farzalibeik
Keyword(s):  
Activation Energy ◽  
Phase Transformation ◽  
Sol Gel ◽  
Rutile Phase ◽  
Transformation Kinetics ◽  
X Ray ◽  
Prepared Nanoparticles ◽  
Phase Transformation Kinetics ◽  
Diffusion Controlled ◽  
Kinetics Of

Titanium dioxide nanopowders were synthesized by the diffusion controlled sol-gel process (LaMer model) and characterized by DTA-TG, XRD, and SEM. The preparedTiO2nanoparticles have uniform size and morphology, and the phase transformation kinetics of obtained material was studied by interpretation of the X-ray diffraction patterns peaks on the base of Avrami equation. The stating point of anatase-rutile phase transformation temperature in the prepared nanoparticles was found between 100 and200°C. A decreasing trend on the intensity of X-ray peaks of anatase phase was observed up to600°Cwhen the presence of the rutile phase became predominant. Results indicated that the transition kinetics of the diffusion controlled prepared nanoparticles was begun at low temperature, and it can be concluded that the nucleation and growth sites in these particles were more than other. However, it has been found that the nucleation activation energy of rutile phase was 20 kj/mol, and it is the lowest reported activation energy.

The Composition Effect on the Nanocrystallization of Finemet Amorphous Alloys

1996 ◽  
Vol 457 ◽  
Author(s):  
J. Zhu ◽  
T. Pradell ◽  
N. Clavaguera ◽  
M. T. Clavaguera-Mora
Keyword(s):  
Amorphous Alloys ◽  
Nucleation And Growth ◽  
Secondary Crystallization ◽  
Composition Effect ◽  
Phase Precipitation ◽  
X Ray Diffraction ◽  
Initial Composition ◽  
Scanning Calorimetry ◽  
X Ray ◽  
Diffusion Controlled

ABSTRACTDifferential Scanning Calorimetry (DSC), X-ray Diffraction (XRD), Neutron Diffraction (ND) and Mössbauer Spectroscopy (MS) were used to study the nanocrystallization process of Fe73.5Cu1Nb3Si22.5–xBx (x=5, 7, 8, 9 and 12) amorphous alloys. Both the temperature range and the activation energy of Fe(Si) phase precipitation from the amorphous martrix increase with the initial B composition. The initial Si composition influences the mechanism of the nanocrystallization: for the Si rich samples, the beginning of nucleation and growth processes is interface controlled, for the B rich samples it is diffusion controlled. Secondary crystallization from the remaining amorphous is mainly Fe3B and Fe2B, the ratio of Fe3B/Fe2B being dependent on the initial composition too.

Sign in / Sign up

Export Citation Format

Share Document