Bis(4-methylpiperidine-1-carbodithioato)-lead(II) and Bis(4-benzylpiperidine-1-carbodithioato)-lead(II) as Precursors for Lead Sulphide Nano Photocatalysts for the Degradation of Rhodamine B

Bis(4-methylpiperidine-1-carbodithioato)-lead(II) and bis(4-benzylpiperidine-1-carbodithioato)-lead(II) were prepared and their molecular structures elucidated using single crystal X-ray crystallography and spectroscopic techniques. The compounds were used as precursors for the preparation of lead sulphide nano photocatalysts for the degradation of rhodamine B. The single crystal structures of the lead(II) dithiocarbamate complexes show mononuclear lead(II) compounds in which each lead(II) ion coordinates two dithiocarbamato anions in a distorted tetrahedral geometry. The compounds were thermolyzed at 180 ℃ in hexadecylamine (HDA), octadecylamine (ODA), and trioctylphosphine oxide (TOPO) to prepare HDA, ODA, and TOPO capped lead sulphide (PbS) nanoparticles. Powder X-ray diffraction (pXRD) patterns of the lead sulphide nanoparticles were indexed to the rock cubic salt crystalline phase of lead sulphide. The lead sulphide nanoparticles were used as photocatalysts for the degradation of rhodamine B with ODA-PbS1 achieving photodegradation efficiency of 45.28% after 360 min. The photostability and reusability studies of the as-prepared PbS nanoparticles were studied in four consecutive cycles, showing that the percentage degradation efficiency decreased slightly by about 0.51–1.93%. The results show that the as-prepared PbS nanoparticles are relatively photostable with a slight loss of photodegradation activities as the reusability cycles progress.

Synthesis and Characterization of Nanoparticles and Thin Films of PbS by a High-performance Procedure Using CBD

In this research, nanoparticles and nanostructured thin films of lead sulfide are synthesized by using physicochemical methods at room conditions or suchlike conditions, at short reaction times; furthermore, is used simple laboratory equipment and a simplified experimental configuration. Both syntheses do not employ, ammonium or ammonia to elaborate PbS. The main used precursors for both processes are lead acetate, as the lead source, polyethyleneimine as the complexing agent, and thioacetamide, as the sulfur source. Acetylacetone has been employed as a dispersant agent to elaborate PbS nanoparticles. While the sodium hydroxide maintains a high pH, to elaborate PbS thin films. The characterizations reveal the existence of PbS nanoparticles whose size is smaller than 10nm and with a band gap of 3.35 eV. On the other hand, the resulting thin film is made up of PbS little crystallites of 22 nm in a homogeneous way and its band gap is 1.85 eV.

Fabrication of Room Temperature Resistive Ethanol Gas Sensor Based on ZnO Nanorods Decorated with PbS Nanoparticles

A resistive ethanol gas sensor with a high sensitivity has been proposed. The fabricated gas sensor has a very promising response and recovery at room temperature. The proposed sensor has been fabricated by depositing sensitive nanostructured material on printed circuit board interdigitated electrodes. As the sensitive material, ZnO nanorods of high uniformity have been synthesized by hydrothermal method and then decorated by PbS nanoparticles. The synthesized decorated nanorods were characterized by X-ray diffraction and scanning electron microscope which confirmed the formation of the desired nanostructures. The ethanol gas sensing properties of the ZnO nanorods decorated with PdS nanoparticles was measured in a test chamber. The minimum ethanol concentration detected by the sensor has been 10 ppm. The results showed the higher sensitivity of the proposed sensor to the ethanol at room temperature compared to similar works.

Metal Accumulation Using a Bacterium (K-142) Identified from Environmental Microorganisms by the Screening of Au Nanoparticles Synthesis

The use of technology that uses organisms to synthesize metal nanoparticles is necessary to maintain a sustainable society. In this study, we investigated and screened the microorganisms isolated from environmental water by quantifying the reproducibility of synthetic Au nanoparticles and the ability of large amount synthesis. The microorganism (K-142) of the Bacillus genus showed the best activity in the investigation. K-142 can also synthesize Ag, CdS and PbS nanoparticles, and the deposition efficiency of Ag, Al, Cd, Cu, and Pb was about 64.8–99.2%. According to the observation results under the microscope after fluorescent staining, K-142 could survive after being treated with 0.5 mM metal solution for 24 h. Therefore, it is expected that K-142, which is easy to cultivate, would also have a high ability to reduce and deposit metal substances. K-142 can be applied to the concentration and recovery of heavy metals in environmental water, thereby opening up channels for biological water purification.