scholarly journals PHYSICOCHEMICAL PROPERTIES AND NUTRITIONAL VALUES OF Carissa Spinarum L. /”AGAM” FRUIT

2021 ◽  
Vol 21 (1) ◽  
pp. 826-834
Author(s):  
Zinabu Hailu Siyum ◽  
Tassew Alemayehu Meresa
2021 ◽  
pp. 1-10
Author(s):  
I. Paniagua-Martínez ◽  
F. Morales-Trejo ◽  
A. Rendón-Martínez ◽  
F. Gallardo-López ◽  
A. Ramírez-Martínez

The nutritional values of Atta mexicana (chicatana ants) are similar to those found in meat. As with other insects, consumers roast them for consumption and preservation. This process can generate beneficial changes in food; however, it can also cause the destruction of certain nutritional components. Thusly, the main objective of the present work was to analyse some of the main physicochemical properties of raw and roasted chicatana ants from one site located in the High Mountain region in the state of Veracruz. The roasting process was performed as it is normally carried out at the site from which the samples were taken. We also investigated the level of consumption and acceptance in several localities near this site by means of a survey. Significant differences among the protein and fat content due to the roasting process were observed (P>0.05). Roasting tests also revealed that colour change was linked to the loss of moisture and the increase of the temperature. Moreover, the process did not affect the fatty acid profile (P>0.05). Consumption and acceptance surveys revealed that the interviewees highly appreciate the taste of A. mexicana and that its consumption has decreased due to the decrease of the rain.


2019 ◽  
Vol 18 (03) ◽  
pp. 64-73
Author(s):  
Ruttarattanamongkol Khanitta

This work was conducted to evaluate the effect of drying methods on the nutritional values and physicochemical properties of unpeeled banana flour. Proximate, amylose content, phenolic compound, resistant starch, total dietary fibre, functional properties, pasting properties, and thermal properties of dried banana flour samples were evaluated. Three different drying methods of whole banana with the intact peel were studied including 1) hot-air unpeeled flour (HAU) (dried at 60oC for 2 h in hot-air chamber), 2) microwave-vacuum unpeeled flour (MVU) (36,000 W under vacuum -600 mmHg for 15 min in a pilot microwave-vacuum dryer), and 3) infrared unpeeled flour (IRU) (600 W for 15 min in infrared channel dryer). The HAU and MVU showed the highest yield. Drying methods did not affect the compositions of the flour but significantly affected the total dietary fibre, resistant starch, amylose content and phenolic compound of the flour. Among samples, HAU contained the highest nutritional values with outstanding functional properties, and pasting properties. The unpeeled banana flour can be utilized in various food products such as noodle, bakeries, snack or used as functional ingredients for nutritional purposes.


Foods ◽  
2020 ◽  
Vol 9 (12) ◽  
pp. 1781
Author(s):  
Eskindir Getachew Fentie ◽  
Shimelis Admassu Emire ◽  
Hundessa Dessalegn Demsash ◽  
Debebe Worku Dadi ◽  
Jae-Ho Shin

Traditional fermented alcoholic beverages are drinks produced locally using indigenous knowledge, and consumed near the vicinity of production. In Ethiopia, preparation and consumption of cereal- and fruit-based traditional fermented alcoholic beverages is very common. Tella, Borde, Shamita, Korefe, Cheka, Tej, Ogol, Booka, and Keribo are among the popular alcoholic beverages in the country. These beverages have equal market share with commercially produced alcoholic beverages. Fermentation of Ethiopian alcoholic beverages is spontaneous, natural and uncontrolled. Consequently, achieving consistent quality in the final product is the major challenge. Yeasts and lactic acid bacteria are the predominate microorganisms encountered during the fermentation of these traditional alcoholic beverages. In this paper, we undertake a review in order to elucidate the physicochemical properties, indigenous processing methods, nutritional values, functional properties, fermenting microorganisms and fermentation microbial dynamics of Ethiopian traditional alcoholic beverages. Further research will be needed in order to move these traditional beverages into large-scale production.


Author(s):  
A. Legrouri

The industrial importance of metal catalysts supported on reducible oxides has stimulated considerable interest during the last few years. This presentation reports on the study of the physicochemical properties of metallic rhodium supported on vanadium pentoxide (Rh/V2O5). Electron optical methods, in conjunction with other techniques, were used to characterise the catalyst before its use in the hydrogenolysis of butane; a reaction for which Rh metal is known to be among the most active catalysts.V2O5 powder was prepared by thermal decomposition of high purity ammonium metavanadate in air at 400 °C for 2 hours. Previous studies of the microstructure of this compound, by HREM, SEM and gas adsorption, showed it to be non— porous with a very low surface area of 6m2/g3. The metal loading of the catalyst used was lwt%Rh on V2Q5. It was prepared by wet impregnating the support with an aqueous solution of RhCI3.3H2O.


1966 ◽  
Vol 16 (03/04) ◽  
pp. 526-540 ◽  
Author(s):  
E. A Beck ◽  
D. P Jackson

SummaryThe effects of trypsin and plasmin on the functional and physicochemical properties of purified human fibrinogen were observed at various stages of proteolysis. Concentrations of plasmin and trypsin that produced fibrinogenolysis at comparable rates as measured in a pH stat produced, at similar rates, loss of precipitability of fibrinogen by heat and ammonium sulphate and alterations in electrophoretic mobility on starch gel. Trypsin produced a more rapid loss of clottability of fibrinogen and a more rapid appearance of inhibitors of the thrombin-fibrinogen clotting system than did plasmin. Consistent differences were noted between the effects of trypsin and plasmin on the immunoelectrophoretic properties of fibrinogen during the early stages of proteolysis.These results are consistent with the hypothesis that trypsin initially reacts with the same peptide bonds of fibrinogen that are split by thrombin, but these same bonds do not appear to be split initially by plasmin. Measurement of the various functional and physico-chemical changes produced by the action of trypsin and plasmin on fibrinogen can be used to recognize various stages of proteolysis.


2020 ◽  
pp. 181-191
Author(s):  
M. Tkachenko ◽  
N. Borys ◽  
Ye. Kovalenko

The research aims to establish the eff ectiveness of granular chalk use produced by «Slavuta-Calcium» Ltd. under growing Poliska–90 winter wheat variety, changing the physicochemical properties of grey forest soil and the wheat productivity. It also aims to establish optimal dosis of «Slavuta-Calcium» granular chalk as the meliorant and mineral fertilizer for grey forest soil in the system of winter wheat fertilization. In the temporary fi eld studies, various doses of nutrients N60–90–120P30–45–60K60–90–120 combined with «Slavuta–Calcium» granular chalk in a dose of Ca230–460–690 kg/ha of the active substance were studied against the background of secondary plowing of rotation products – soybean biomass that averaged 2.34 t/ha. Granular chalk is a modern complex highly eff ective meliorant with the content of Ca – 37.7 and Mg – 0.2 %, the mass fraction of carbonates (CaCO3 + MgCO3) makes at least 95 %. It is characterized by a high level of solubility when interacting with moisture in soil. It has a form of white granules, the mass fraction of 4.0–6.0 mm in size granules makes not less than 90 % and the one of 1.0 mm in size makes less than 5 %. Reactivity – 97 %. The granular chalk is advisable to apply on acidic soils, as a highly concentrated calcium-magnesium fertilizer, with the former as the dominant fertilizer, to optimize the physicochemical properties of the soil, as well as the plant nutrition system, in particular, increasing the availability of an element for assimilation by plants and as long-term ameliorants. The eff ectiveness of the use of mineral fertilizers, in particular acidic nitrogen on highly and medium acidic soils, after chemical reclamation is increased by 30–50 %, and slightly acidic by 15–20 %. The increase in productivity of crops from the combined eff ects of nutrients and chalk granulated is usually higher than when separately applied. The eff ectiveness of the integrated action of these elements is manifested in the growth of plant productivity and the quality of the resulting products, as well as the optimization of physical chemical properties and soil buff ering in the long term. In order to optimize the physicochemical properties of the arable layer of gray forest soil and the productive nutrition of agricultural crops, winter wheat, in particular, biogenic elements should be used in doses N60-90-120P30-45- 60K60-90-120 with granulated chalk «Slavuta-Calcium» in doses of Ca230-460-690 kg/ha of active substance. Granulated chalk obtained as a result of industrial grinding of solid sedimentary carbonate rocks of natural origin, subsequently under the infl uence of the granulation process of the starting material contains Ca and Mg carbonates of at least 95 %, dense granules which facilitates convenient mechanized application, as well as chalk suitable for accurate metered application on the quest map. Key words: granular chalk, gray forest soil, chemical reclamation, crop productivity.


The authors' methodic for assessing the role of chemical and physic-chemical factors during the structure formation of gypsum stone is presented in the article. The methodic is also makes it possible to reveal the synergistic effect and to determine the ranges of variation of controls factors that ensure maximum values of such effect. The effect of a micro-sized modifier based on zinc hydro-silicates on the structure formation of building gypsum is analyzed and corresponding dependencies are found. It is shown that effects of influence of modifier on the properties of gypsum compositions are determined by chemical properties of modifier. Among the mentioned properties are sorption characteristics (which depend on the amount of silicic acid and its state) and physicochemical properties - the ability to act as a substrate during crystal formation. The proposed method can also be extended to other binding substances and materials. This article contributes to the understanding of the processes that occur during the structure formation of composites, which will make it possible to control the structure formation in the future, obtaining materials with a given set of properties.


Sign in / Sign up

Export Citation Format

Share Document