scholarly journals Aircraft measurements of aerosol distribution, warm cloud microphysical properties, and their relationship over the Eastern Loess Plateau in China

Tellus B ◽  
2019 ◽  
Vol 71 (1) ◽  
pp. 1663994
Author(s):  
Junxia Li ◽  
Peiren Li ◽  
Gang Ren ◽  
Liang Yuan ◽  
Yiyu Li ◽  
...  
Keyword(s):  
Loess Plateau ◽  
Aircraft Measurements ◽  
Microphysical Properties ◽  
Warm Cloud ◽  
Aerosol Distribution

scholarly journals Vertical Distributions of Aerosol and Cloud Microphysical Properties and the Aerosol Impact on a Continental Cumulus Cloud Based on Aircraft Measurements From the Loess Plateau of China

2022 ◽  
Vol 9 ◽  
Author(s):  
Zhaoxin Cai ◽  
Zhanqing Li ◽  
Peiren Li ◽  
Junxia Li ◽  
Hongping Sun ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Water Content ◽  
Loess Plateau ◽  
Cloud Droplet ◽  
Vertical Profiles ◽  
Aircraft Measurements ◽  
Cumulus Cloud ◽  
The Loess Plateau ◽  
Cumulus Clouds ◽  
Microphysical Properties

Based on aircraft measurements of aerosols and continental cumulus clouds made over the Loess Plateau of China (Xinzhou, Shanxi Province) on 30 July 2020, this study focuses on the vertical profiles of microphysical properties of aerosols and cumulus clouds, and use them to study aerosol-cloud interactions. During the study period, the boundary layer was stable with a height ∼1,500 m above sea level. Aerosols in the boundary layer mainly came from local emissions, while aerosols above this layer were mostly dust aerosols transported over long distances. Vertical profiles of aerosols and cloud condensation nuclei were obtained, and aerosol activation ratios at different supersaturation (SS) levels ranged from 0.16 to 0.32 at 0.2% SS and 0.70 to 0.85 at 0.8% SS. A thick cumulus cloud in the development stage was observed from the bottom to the top with the horizontal dimension of 10 km by 7 km, the cloud-base height of 2,450 m (15.8°C), and the cloud-top height of 5,400 m (−3°C). The maximum updraft velocity near the cloud top was 13.45 m s−1, and the maximum downdraft velocity occuring in the upper-middle part of the cloud was 4.44 ms−1. The temperature inside the cloud was higher than the outside, with their difference being positively correlated with the cloud water content. The temperature lapse rate inside the cloud was about −6.5°C km−1. The liquid water content and droplet effective radius (Re) increased with increasing height. The cloud droplet number concentration (Nc) increased first then decreased, peaking in the middle and lower part of the cloud, the average values of Nc and Re were 767.9 cm−3 and 5.17 μm, respectively. The cloud droplet spectrum had a multi-peak distribution, with the first appearing at ∼4.5 μm. SS in the cloud first increased then decreased with height. The maximum SS is ∼0.7% appearing at ∼3,800 m. The conversion rate of intra-cloud aerosols to cloud droplets was between 0.2 and 0.54, with the ratio increasing gradually with increasing height. The cloud droplet spectral dispersion and Nc were positively correlated. The aerosol indirect effect (AIE) was estimated to be 0.245 and 0.16, based on Nc and Re, respectively. The cloud droplet dispersion mainly attenuated the AIE, up to ∼34.7%.

scholarly journals Multi-wavelength Raman lidar, sunphotometric and aircraft measurements in combination with inversion models for the estimation of the aerosol optical and physico-chemical properties over Athens, Greece

2012 ◽  
Vol 5 (1) ◽  
pp. 589-625
Author(s):  
R. E. Mamouri ◽  
A. Papayannis ◽  
V. Amiridis ◽  
D. Müller ◽  
P. Kokkalis ◽  
...  
Keyword(s):  
Water Vapor ◽  
Chemical Properties ◽  
Urban Site ◽  
Aircraft Measurements ◽  
Raman Lidar ◽  
Lidar System ◽  
Aerosol Composition ◽  
Microphysical Properties ◽  
Multi Wavelength

Abstract. A novel procedure has been developed to retrieve, simultaneously, the optical, microphysical and chemical properties of tropospheric aerosols with a multi-wavelength Raman lidar system in the troposphere over an urban site (Athens, Greece: 37.9° N, 23.6° E, 200 m a.s.l.) using data obtained during the European Space Agency (ESA) THERMOPOLIS project which took place between 15–31 July 2009 over the Greater Athens Area (GAA). We selected to apply our procedure for a case study of intense aerosol layers occurred on 20–21 July 2009. The National Technical University of Athens (NTUA) EOLE 6-wavelength Raman lidar system has been used to provide the vertical profiles of the optical properties of aerosols (extinction and backscatter coefficients, lidar ratio) and the water vapor mixing ratio. An inversion algorithm was used to derive the mean aerosol microphysical properties (mean effective radius – reff), single-scattering albedo (ω) and mean complex refractive index (m) at selected heights in the 2–3 km height region. We found that reff was 0.3–0.4 μm, ω at 532 nm ranged from 0.63 to 0.88 and m ranged from 1.45 + 0.015i to 1.56 + 0.05i, in good accordance with in situ aircraft measurements. The final data set of the aerosol microphysical properties along with the water vapor and temperature profiles were incorporated into the ISORROPIA model to infer an in situ aerosol composition consistent with the retrieved m and ω values. The retrieved aerosol chemical composition in the 2–3 km height region gave a variable range of sulfate (0–60%) and organic carbon (OC) content (0–50%), although the OC content increased (up to 50%) and the sulfate content dropped (up to 30%) around 3 km height; in connection with the retrieved low ω value (0.63), indicates the presence of absorbing biomass burning smoke mixed with urban haze. Finally, the retrieved aerosol microphysical properties were compared with column-integrated sunphotometer data.

Investigation of the Vertical Structure of Warm-Cloud Microphysical Properties Using the Cloud Evolution Diagram, CFODD, Simulated by a Three-Dimensional Spectral Bin Microphysical Model

2012 ◽  
Vol 69 (6) ◽  
pp. 2012-2030 ◽  
Author(s):  
Yousuke Sato ◽  
Takashi Y. Nakajima ◽  
Teruyuki Nakajima
Keyword(s):  
Vertical Structure ◽  
Three Dimensional ◽  
Global Scale ◽  
Observation Data ◽  
Time Step ◽  
Microphysical Properties ◽  
Warm Cloud ◽  
Dominant Process ◽  
Microphysical Processes ◽  
Cloud Evolution

Abstract This paper investigates the vertical structure of warm-cloud microphysical properties using a three-dimensional (3D) spectral bin microphysical model. A time series of contoured frequency by optical depth diagrams (CFODDs), which were proposed by previous studies, are calculated for the first time by a 3D model assuming two types of aerosol conditions (i.e., polluted and pristine). This contrasts with previous studies that obtained CFODDs using either a two-dimensional model or an accumulation of monthly and global observation data. The results show that the simulated CFODDs are characterized by distinctive patterns of radar reflectivities, similar to the patterns often observed by satellite remote sensing, even though the calculation domain of this study is limited to an area of 30 × 30 km2, whereas the satellite observations are of a global scale. A cloud microphysical box model is then applied to the simulated cloud field at each time step to identify the dominant process for each of the patterns. The results reveal that the wide variety of satellite-observed CFODD patterns can be attributed to different microphysical processes occurring in multiple cloud cells at various stages of the cloud life cycle.

scholarly journals Comparing parameterized versus measured microphysical properties of tropical convective cloud bases during the ACRIDICON–CHUVA campaign

2017 ◽  
Vol 17 (12) ◽  
pp. 7365-7386 ◽  
Author(s):  
Ramon Campos Braga ◽  
Daniel Rosenfeld ◽  
Ralf Weigel ◽  
Tina Jurkat ◽  
Meinrat O. Andreae ◽  
...  
Keyword(s):  
Cloud Condensation Nuclei ◽  
Convective Cloud ◽  
Cloud Base ◽  
Aircraft Measurements ◽  
Cloud Drop ◽  
Convective Clouds ◽  
Microphysical Properties ◽  
Cloud Water Content ◽  
Satellite Retrievals ◽  
Vertical Evolution

Abstract. The objective of this study is to validate parameterizations that were recently developed for satellite retrievals of cloud condensation nuclei supersaturation spectra, NCCN(S), at cloud base alongside more traditional parameterizations connecting NCCN(S) with cloud base updrafts and drop concentrations. This was based on the HALO aircraft measurements during the ACRIDICON–CHUVA campaign over the Amazon region, which took place in September 2014. The properties of convective clouds were measured with a cloud combination probe (CCP), a cloud and aerosol spectrometer (CAS-DPOL), and a CCN counter onboard the HALO aircraft. An intercomparison of the cloud drop size distributions (DSDs) and the cloud water content (CWC) derived from the different instruments generally shows good agreement within the instrumental uncertainties. To this end, the directly measured cloud drop concentrations (Nd) near cloud base were compared with inferred values based on the measured cloud base updraft velocity (Wb) and NCCN(S) spectra. The measurements of Nd at cloud base were also compared with drop concentrations (Na) derived on the basis of an adiabatic assumption and obtained from the vertical evolution of cloud drop effective radius (re) above cloud base. The measurements of NCCN(S) and Wb reproduced the observed Nd within the measurements uncertainties when the old (1959) Twomey's parameterization was used. The agreement between the measured and calculated Nd was only within a factor of 2 with attempts to use cloud base S, as obtained from the measured Wb, Nd, and NCCN(S). This underscores the yet unresolved challenge of aircraft measurements of S in clouds. Importantly, the vertical evolution of re with height reproduced the observation-based nearly adiabatic cloud base drop concentrations, Na. The combination of these results provides aircraft observational support for the various components of the satellite-retrieved methodology that was recently developed to retrieve NCCN(S) under the base of convective clouds. This parameterization can now be applied with the proper qualifications to cloud simulations and satellite retrievals.

scholarly journals Comparisons of Warm Cloud Properties Obtained from Satellite, Ground, and Aircraft Measurements during APEX Intensive Observation Period in 2000 and 2001

2005 ◽  
Vol 83 (6) ◽  
pp. 1085-1095 ◽  
Author(s):  
Takashi Y. NAKAJIMA ◽  
Akihiro UCHIYAMA ◽  
Tamio TAKAMURA ◽  
Naoya TSUJIOKA ◽  
Toshihiko TAKEMURA ◽  
...  
Keyword(s):  
Aircraft Measurements ◽  
Cloud Properties ◽  
Warm Cloud ◽  
Intensive Observation ◽  
Observation Period

scholarly journals Multi-wavelength Raman lidar, sun photometric and aircraft measurements in combination with inversion models for the estimation of the aerosol optical and physico-chemical properties over Athens, Greece

2012 ◽  
Vol 5 (7) ◽  
pp. 1793-1808 ◽  
Author(s):  
R. E. Mamouri ◽  
A. Papayannis ◽  
V. Amiridis ◽  
D. Müller ◽  
P. Kokkalis ◽  
...  
Keyword(s):  
Water Vapor ◽  
Chemical Properties ◽  
Urban Site ◽  
Aircraft Measurements ◽  
Raman Lidar ◽  
Lidar System ◽  
Aerosol Composition ◽  
Microphysical Properties ◽  
Multi Wavelength

Abstract. A novel procedure has been developed to retrieve, simultaneously, the optical, microphysical and chemical properties of tropospheric aerosols with a multi-wavelength Raman lidar system in the troposphere over an urban site (Athens, Greece: 37.9° N, 23.6° E, 200 m a.s.l.) using data obtained during the European Space Agency (ESA) THERMOPOLIS project, which took place between 15–31 July 2009 over the Greater Athens Area (GAA). We selected to apply our procedure for a case study of intense aerosol layers that occurred on 20–21 July 2009. The National Technical University of Athens (NTUA) EOLE 6-wavelength Raman lidar system has been used to provide the vertical profiles of the optical properties of aerosols (extinction and backscatter coefficients, lidar ratio) and the water vapor mixing ratio. An inversion algorithm was used to derive the mean aerosol microphysical properties (mean effective radius (reff), single-scattering albedo ω) and mean complex refractive index (m)) at selected heights in the 2–3 km height region. We found that reff was 0.14–0.4 (±0.14) μm, ω was 0.63–0.88 (±0.08) (at 532 nm) and m ranged from 1.44 (±0.10) + 0.01 (±0.01)i to 1.55 (±0.12) + 0.06 (±0.02)i, in good agreement (only for the reff values) with in situ aircraft measurements. The water vapor and temperature profiles were incorporated into the ISORROPIA II model to propose a possible in situ aerosol composition consistent with the retrieved m and ω values. The retrieved aerosol chemical composition in the 2–3 km height region gave a variable range of sulfate (0–60%) and organic carbon (OC) content (0–50%), although the OC content increased (up to 50%) and the sulfate content dropped (up to 30%) around 3 km height; the retrieved low ω value (0.63), indicates the presence of absorbing biomass burning smoke mixed with urban haze. Finally, the retrieved aerosol microphysical properties were compared with column-integrated sun photometer CIMEL data.

Sign in / Sign up

Export Citation Format

Share Document