scholarly journals SPECTROPHOTOMETRIC STUDIES OF PENETRATION

1929 ◽  
Vol 12 (3) ◽  
pp. 407-418 ◽  
Author(s):  
Marian Irwin

The rate of diffusion through the non-aqueous layer of the protoplasm depends largely on the partition coefficients mentioned above. Since these cannot be determined we have employed an artificial system in which chloroform is used in place of the non-aqueous layer of the protoplasm. The partition coefficients may be roughly determined by shaking up the aqueous solutions with chloroform and analyzing with the spectrophotometer (which is necessary with methylene blue because we are dealing with mixtures). This will show what dyes may be expected to pass through the protoplasm into the vacuole in case it behaves like the artificial system. From these results we may conclude that the artificial system and the living cell act almost alike toward methylene blue and azure B, which supports the notion of non-aqueous layers in the protoplasm. There is a close resemblance between Valonia and the artificial system in their behavior toward these dyes at pH 9.5. In the case of Nitella, on the other hand, with methylene blue solution at pH 9.2 the sap in the artificial system takes up relatively more azure B (absorption maximum at 650 mµ) than the vacuole of the living cell (655 mµ). But both take up azure B much more rapidly than methylene blue. A comparison cannot be made between the behavior of the artificial system and that of the living cell at pH 5.5 since in the latter case there arises a question of injury to cells before enough dye is collected in the sap for analysis.

1930 ◽  
Vol 14 (1) ◽  
pp. 19-29 ◽  
Author(s):  
Marian Irwin

Glass electrode measurements of the pH value of the sap of cells of Nitella show that azure B in the form of free base penetrates the vacuoles and raises the pH value of the sap to about the same degree as the free base of the dye added to the sap in vitro, but the dye salt dissolved in the sap does not alter the pH value of the sap. It is concluded that the dye penetrates the vacuoles chiefly in the form of free base and not as salt. The dye from methylene blue solution containing azure B free base as impurity penetrates and accumulates in the vacuole. This dye must be azure B in the form of free base, since it raises the pH value of the sap to about the same extent as the free base of azure B dissolved in the sap in vitro. The dye absorbed by the chloroform from methylene blue solution behaves like the dye penetrating the vacuole. These results confirm those of spectrophotometric analysis previously published. Crystal violet exists only in one form between pH 5 and pH 9.2, and does not alter the pH value of the sap at the concentrations used. It does not penetrate readily unless cells are injured. A theory of "multiple partition coefficients" is described which explains the mechanism of the behavior of living cells to these dyes. When the protoplasm is squeezed into the sap, the pH value of the mixture is higher than that of the pure sap. The behavior of such a mixture to the dye is very much like that of the sap except that with azure B and methylene blue the rise in the pH value of such a mixture is not so pronounced as with sap when the dye penetrates into the vacuoles. Spectrophotometric measurements show that the dye which penetrates from methylene blue solution has a primary absorption maximum at 653 to 655 mµ (i.e., is a mixture of azure B and methylene blue, with preponderance of azure B) whether we take the sap alone or the sap plus protoplasm. These results confirm those previously obtained with spectrophotometric measurements.


1927 ◽  
Vol 10 (6) ◽  
pp. 927-948 ◽  
Author(s):  
Marian Irwin

When uninjured cells of Valonia are placed in methylene blue dissolved in sea water it is found, after 1 to 3 hours, that at pH 5.5 practically no dye penetrates, while at pH 9.5 more enters the vacuole. As the cells become injured more dye enters at pH 5.5, as well as at pH 9.5. No dye in reduced form is found in the sap of uninjured cells exposed from 1 to 3 hours to methylene blue in sea water at both pH values. When uninjured cells are placed in azure B solution, the rate of penetration of dye into the vacuole is found to increase with the rise in the pH value of the external dye solution. The partition coefficient of the dye between chloroform and sea water is higher at pH 9.5 than at pH 5.5 with both methylene blue and azure B. The color of the dye in chloroform absorbed from methylene blue or from azure B in sea water at pH 5.5 is blue, while it is reddish purple when absorbed from methylene blue and azure B at pH 9.5. Dry salt of methylene blue and azure B dissolved in chloroform appears blue. It is shown that chiefly azure B in form of free base is absorbed by chloroform from methylene blue or azure B dissolved in sea water at pH 9.5, but possibly a mixture of methylene blue and azure B in form of salt is absorbed from methylene blue at pH 5.5, and azure B in form of salt is absorbed from azure B in sea water at pH 5.5. Spectrophotometric analysis of the dye shows the following facts. 1. The dye which is absorbed by the cell wall from methylene blue solution is found to be chiefly methylene blue. 2. The dye which has penetrated from methylene blue solution into the vacuole of uninjured cells is found to be azure B or trimethyl thionine, a small amount of which may be present in a solution of methylene blue especially at a high pH value. 3. The dye which has penetrated from methylene blue solution into the vacuole of injured cells is either methylene blue or a mixture of methylene blue and azure B. 4. The dye which is absorbed by chloroform from methylene blue dissolved in sea water is also found to be azure B, when the pH value of the sea water is at 9.5, but it consists of azure B and to a less extent of methylene blue when the pH value is at 5.5. 5. Methylene blue employed for these experiments, when dissolved in sea water, in sap of Valonia, or in artificial sap, gives absorption maxima characteristic of methylene blue. Azure B found in the sap collected from the vacuole cannot be due to the transformation of methylene blue into this dye after methylene blue has penetrated into the vacuole from the external solution because no such transformation detectable by this method is found to take place within 3 hours after dissolving methylene blue in the sap of Valonia. These experiments indicate that the penetration of dye into the vacuole from methylene blue solution represents a diffusion of azure B in the form of free base. This result agrees with the theory that a basic dye penetrates the vacuole of living cells chiefly in the form of free base and only very slightly in the form of salt. But as soon as the cells are injured the methylene blue (in form of salt) enters the vacuole. It is suggested that these experiments do not show that methylene blue does not enter the protoplasm, but they point out the danger of basing any theoretical conclusion as to permeability on oxidation-reduction potential of living cells from experiments made or the penetration of dye from methylene blue solution into the vacuole, without determining the nature of the dye inside and outside the cell.


2014 ◽  
Vol 608 ◽  
pp. 224-229 ◽  
Author(s):  
Potjanaporn Chaengchawi ◽  
Karn Serivalsatit ◽  
Pornapa Sujaridworakun

A visible-light responsive CdS/ZnO nanocomposite photocatalyst was successfully synthesized by precipitation of CdS nanoparticles, using Cd (NO3)2 and Na2S as starting materials, on ZnO nanoparticles and then calcined at 400°C for 2 hours. The effects of the mole ratio of CdS and ZnO in the composites on their phase, morphology, and surface area were investigated by X-ray Diffraction (XRD), scanning electron microscope (SEM), Brunauer Emmett Teller method (BET), respectively. The photocatalytic degradation of methylene blue solution in the presence of composite products under visible-light irradiation was investigated. The results showed that the mole ratio of CdS and ZnO played a significant role on photocatalytic performance. The highest photocatalytic activity was obtained from the CdS/ZnO nanocomposite with mole ratio of 1:4, which is higher than that of pure CdS and pure ZnO.


2013 ◽  
Vol 668 ◽  
pp. 13-16
Author(s):  
Qing Shan Li ◽  
Biao Zhan ◽  
Wei Hong ◽  
Guang Zhong Xing

Opal as a carrier, tetrabutyl titanate as a titanium source, TiO2 loaded on opal was prepared by sol-gel technique. The photocatalysts were characterized by XRD, TEM and UV-VIS absorption spectrum. Their photocatalytic activities were examined by the photocatalytic decolorization of methylene blue solution under UV light irradiation. The effects of calcination temperature, the amount of TiO2 loading and pH on photocatalytic activities were discussed. The results show that TiO2 supported on opal induced enhancement of photocatalytic decolorization rant and TiO2 doping is about 30 wt. % with 92.15% of decolorization rate at 700°C.


1987 ◽  
Vol 8 (3) ◽  
pp. 59-60
Author(s):  
Ichiro TANABE ◽  
Hiroshi FUJIMURA ◽  
Tatsuo OTANI ◽  
Yukinori OKAZAKI ◽  
Tadayoshi TAKEMOTO ◽  
...  

2018 ◽  
Vol 18 (3) ◽  
pp. 403 ◽  
Author(s):  
Eko Sri Kunarti ◽  
Indriana Kartini ◽  
Akhmad Syoufian ◽  
Karolina Martha Widyandari

Synthesis of magnetic photocatalyst, Fe3O4/TiO2-Co, with characterization and photoactivity examination have been conducted. The synthesis was initiated by preparation of Fe3O4 particles using coprecipitation method. The Fe3O4 particles were then coated with TiO2-Co at a various ratio of Fe3O4:TiO2 and concentration of Co(II) dopant. The Fe3O4/TiO2-Co was characterized by FTIR, XRD, TEM, SEM-EDX, VSM, and SR UV-visible methods. Photoactivity of the Fe3O4/TiO2-Co was carried out using methylene blue as a target molecule in degradation reaction within a batch system. By using optimum conditions, the degradation of methylene blue solution was performed under exposure to UV, visible light and dark condition. Results showed that the Fe3O4/TiO2-Co formation was confirmed by the presence of Fe3O4 and anatase diffraction peaks in the X-ray diffractogram. SR UV-Vis spectra indicated that the Fe3O4/TiO2-Co was responsive to visible light. Band gap energy of the Fe3O4/TiO2-Co with dopant concentration of 1; 5; 10 and 15% were 3.22; 3.12; 3.09 and 2.81 eV, respectively. The methylene blue solution can be well photodegraded at a pH of 10 for 210 min. The Fe3O4/TiO2-Co has the highest ability to methylene blue photodegradation with dopant concentration of 10% gave degradation yield of 80.51 and 95.38% under UV and visible irradiation, respectively.


Author(s):  
Digvijay Verma ◽  
Vinay Kumar Singh ◽  
Rinku Bharati ◽  
Shyam Kishore ◽  
Seshu Lavania

In the present study, the cyanophycean diversity of the Lakhimpur-Khiri district, northern Uttar Pradesh, India, has been investigated for the first time. Algae samples were collected in plastic bottles and preserved in 3-4% formalin from Lakhimpur-Khiri district of northern Uttar Pradesh in different seasons from 2015 to 2016. The field photographs of the selected localities were also taken and the location of each site noted down. For the Microscopic study of Cyanophycean algae, the samples were stained with 1 % aqueous methylene blue solution according to the standard method. The observations and photomicrography were done with help of Nikon Labophot-11 microscope. A total of 31 cyanophycean algal taxa have been recorded from different water bodies of Lakhimpur-Khiri. These algal taxa belong to 14 genera and 9 families of the division Cyanophyata. Of these, Oscillatoria (7), Phormidium (4) and Lyngbya (3) are abundant.


Sign in / Sign up

Export Citation Format

Share Document