scholarly journals Study of the Leidenfrost Effect on Heterogeneous Surfaces of Complex Structure

2021 ◽  
Vol 2039 (1) ◽  
pp. 012017
Author(s):  
P G Makarov ◽  
A V Artamonov ◽  
A S Dmitriev

Abstract This work is devoted to a research of water droplets that are put in-between two parallel metal strings the distance between which is comparable to linear size of the droplet. Strings are heated by Joule heating to temperatures that exceed critical temperatures of nucleate and film boiling. Different configurations of strings’ side surface have been tested: smooth and with winding made of the same material (intermittent and uninterrupted). Experiments have shown that droplets on these types of surface do not boil away quickly or fall down. Instead they displayed behavior that can be described as floating, either stable or with directed motion, depending on surface structure or relief. Multiple experiments have shown that it is quite similar to Leidenfrost effect demonstrated on a flat overheated surface by liquids.

2004 ◽  
Vol 85 (11) ◽  
pp. 2864-2866 ◽  
Author(s):  
Lin Geng ◽  
Jie Zhang ◽  
Qing-Chang Meng ◽  
Cong-Kai Yao

2020 ◽  
Vol 8 (16) ◽  
pp. 7889-7896 ◽  
Author(s):  
Shun Wang ◽  
Hailong Li ◽  
Hu Duan ◽  
Yingtao Cui ◽  
Heng Sun ◽  
...  

This study discovered a “seesaw effect” in the underlying physics of the directional bouncing behavior of a droplet on superhydrophobic heterogeneous surfaces, leading to projectile motion.


2020 ◽  
Author(s):  
J. Benedikt Schmidt ◽  
Julian Hofmann ◽  
Fabian Tenzer ◽  
Jan Breitenbach ◽  
Cameron Tropea ◽  
...  

Abstract Drop rebound after collision with a very hot substrate is usually attributed to the Leidenfrost effect, [1-5] characterized by intensive film boiling in a thin vapour gap between the liquid and substrate. Similarly, drop impact onto a cold superhydrophobic substrate [6-8] leads to a complete drop rebound, despite partial wetting of the substrate. We have studied the repellent properties of hot smooth hydrophilic substrates in the nucleate boiling, non-Leidenfrost regime and discovered that the thermally induced repellency is associated with vapour percolation on the substrate. The wetting structure in the presence of the percolating vapour rivulets is analogous to the Cassie-Baxter wetting mode, [9] which is a necessary condition for the repellency in the isothermal case. The theoretical predictions for the threshold temperature for vapour percolation agree well with the experimental data for drop rebound and correspond to the minimum heat flux when spray cooling.


2021 ◽  
Vol 4 (1) ◽  
Author(s):  
J. Benedikt Schmidt ◽  
Julian Hofmann ◽  
Fabian M. Tenzer ◽  
Jan Breitenbach ◽  
Cameron Tropea ◽  
...  

AbstractDrop rebound after collision with a very hot substrate is usually attributed to the Leidenfrost effect, characterized by intensive film boiling in a thin vapour gap between the liquid and substrate. Similarly, drop impact onto a cold superhydrophobic substrate leads to a complete drop rebound, despite partial wetting of the substrate. Here we study the repellent properties of hot smooth hydrophilic substrates in the nucleate boiling, non-Leidenfrost regime and discover that the thermally induced repellency is associated with vapour percolation on the substrate. The wetting structure in the presence of the percolating vapour rivulets is analogous to the Cassie-Baxter wetting mode, which is a necessary condition for the repellency in the isothermal case. The theoretical predictions for the threshold temperature for vapour percolation agree well with the experimental data for drop rebound and correspond to the minimum heat flux when spray cooling.


1991 ◽  
Vol 69 (8-9) ◽  
pp. 1007-1031 ◽  
Author(s):  
C. A. Chang ◽  
J.-P. St.-Maurice

A set of two-dimensional nonlinear calculations has been done to simulate the auroral region electrojet and to examine the effect of the electric field on the dynamics and thermodynamics of the thermosphere. A large number of physical and dynamical processes in the ionosphere have been considered, including the ion-drag force, the Coriolis force, gravitation, Joule heating, viscous heating and viscous work, solar extreme ultraviolet heating, thermal conduction, and cooling to space owing to infrared radiation of different species. Navier–Stokes equations for a compressible, viscous and thermal conducting fluid flow with source terms have been solved by a MacCormack explicit, alternative forward-backward finite differencing scheme in spherical coordinates. Results have been recorded at various time intervals for three hours simulation time, for altitudes between 80 and 450 km, and from the north pole to the equator. In addition to a strong zonal drift motion and to the basic upward and meridional motion away from the heated region, we obtain a complex structure of waves involving meridional and vertical winds, as well as the density and temperature fields. This computation suggests that waves play a much more important role than ordinary diffusion of energy and momentum is spreading the effects of the disturbances away from the electrojet region. The net result is that there is, strictly speaking, no steady state reached by the neutrals except for the bulk of the zonal flow. A second major feature that we obtain is that nonlinear terms can often dominate the momentum equation, which can reduce the magnitude of the zonal flow by a considerable amount, and can displace the region of maximum neutral flow away from where the electrojet is. The nonlinear terms are also responsible for the formation of a neutral density 'hole' at nonelectrojet latitudes. This hole is found below the region where Joule heating reaches its peak value and is used to enhance the neutral densities at high altitudes on a global scale.


Author(s):  
Cedric Aberle ◽  
Mark Lewis ◽  
Gan Yu ◽  
Nan Lei ◽  
Jie Xu

The Leidenfrost effect is a well-known heat transfer phenomenon, which predicts that liquid droplets will show prolonged evaporation time when they are placed on a hot surface with a temperature higher than a critical value. This effect is due to film boiling, where a vapor film helps insulate the drop from the hot surface. In this paper, we show that specially engineered droplets — liquid marbles — can exhibit Leifenfrost effect at any temperature above the boiling point without experiencing any transition. Liquid marbles are spheres with a liquid core that are coated with hydrophobic particles. When brought into contact with a solid surface, liquid marbles are completely nonwetting due to the fact that the hydrophobic powder is in between the liquid and solid surface. Liquid marbles may be used as excellent microreservoirs for biosample handling and chemical reagent manipulation. In our study, liquid marbles are synthesized by coating water droplets with graphite particles. We investigate the thermal evaporation of the fabricated graphite liquid marbles on a hot substrate at prescribed temperatures, and compare the results with pure water droplets. The evaporation time of both liquid marbles and water droplets are recorded at various temperatures. If the temperature is above the Leidenfrost point, the evaporation of both liquid marbles and water droplets are prolonged with similar amount of time (about 100s), which indicates that similar physics might at play in both cases: heat transfer is impeded by a thin layer of vapor. If the temperature is below the Leidenfrost point, water droplets evaporate a hundred times faster. This is because the vapor film cannot self-sustain and levitate the droplet anymore. On the other hand, liquid marbles still evaporate slowly with the same level of time as Leidenfrost evaporation times, which indicates that the Leidenfrost effect still takes effect for liquid marbles even below the critical temperature. This might be due to the fact that the coating of the liquid marble helps levitate the liquid core, maintaining a layer of insulating vapor. In the end, we report detailed deformation of liquid marbles during evaporation. This coating-assisted Leidenfrost phenomenon could be useful in many applications where film boiling is desired. The strong thermal robustness of graphite liquid marbles over a wide temperature range, together with the inert reactivity, electrical conductivity and superior lubrication properties of graphite, make graphite liquid marbles potentially useful in a wealth of applications in microfluidics and lab on a chip devices.


Author(s):  
Sanford H. Vernick ◽  
Anastasios Tousimis ◽  
Victor Sprague

Recent electron microscope studies have greatly expanded our knowledge of the structure of the Microsporida, particularly of the developing and mature spore. Since these studies involved mainly sectioned material, they have revealed much internal detail of the spores but relatively little surface detail. This report concerns observations on the spore surface by means of the transmission electron microscope.


Author(s):  
Robert M. Glaeser ◽  
Thea B. Scott

The carbon-replica technique can be used to obtain information about cell-surface structure that cannot ordinarily be obtained by thin-section techniques. Mammalian erythrocytes have been studied by the replica technique and they appear to be characterized by a pebbly or “plaqued“ surface texture. The characteristic “particle” diameter is about 200 Å to 400 Å. We have now extended our observations on cell-surface structure to chicken and frog erythrocytes, which possess a broad range of cellular functions, and to normal rat lymphocytes and mouse ascites tumor cells, which are capable of cell division. In these experiments fresh cells were washed in Eagle's Minimum Essential Medium Salt Solution (for suspension cultures) and one volume of a 10% cell suspension was added to one volume of 2% OsO4 or 5% gluteraldehyde in 0.067 M phosphate buffer, pH 7.3. Carbon replicas were obtained by a technique similar to that employed by Glaeser et al. Figure 1 shows an electron micrograph of a carbon replica made from a chicken erythrocyte, and Figure 2 shows an enlarged portion of the same cell.


Author(s):  
S. S. Breese ◽  
H. L. Bachrach

Models for the structure of foot-and-mouth disease virus (FMDV) have been proposed from chemical and physical measurements (Brown, et al., 1970; Talbot and Brown, 1972; Strohmaier and Adam, 1976) and from rotational image-enhancement electron microscopy (Breese, et al., 1965). In this report we examine the surface structure of FMDV particles by high resolution electron microscopy and compare it with that of particles in which the outermost capsid protein VP3 (ca. 30, 000 daltons) has been split into smaller segments, two of which VP3a and VP3b have molecular weights of about 15, 000 daltons (Bachrach, et al., 1975).Highly purified and concentrated type A12, strain 119 FMDV (5 mg/ml) was prepared as previously described (Bachrach, et al., 1964) and stored at 4°C in 0. 2 M KC1-0. 5 M potassium phosphate buffer at pH 7. 5. For electron microscopy, 1. 0 ml samples of purified virus and trypsin-treated virus were dialyzed at 4°C against 0. 2 M NH4OAC at pH 7. 3, deposited onto carbonized formvar-coated copper screens and stained with phosphotungstic acid, pH 7. 3.


Author(s):  
D. Johnson ◽  
P. Moriearty

Since several species of Schistosoma, or blood fluke, parasitize man, these trematodes have been subjected to extensive study. Light microscopy and conventional electron microscopy have yielded much information about the morphology of the various stages; however, scanning electron microscopy has been little utilized for this purpose. As the figures demonstrate, scanning microscopy is particularly helpful in studying at high resolution characteristics of surface structure, which are important in determining host-parasite relationships.


Sign in / Sign up

Export Citation Format

Share Document