In a paper on “Molecular Electro-Magnetic Induction,” presented to the Royal Society March 7, 1881 (p. 524), I gave a description of the induction currents produced by the torsion of an iron wire, and the method by which they are rendered evident. The electro-magnetic induction balance there described is so remarkably sensitive to the slightest internal strain in anywise submitted to it, that I at once perceived that the instrument could not only determine any mechanical strain such as torsion or longitudinal stress, but that it might indicate the nature and cause of internal strains. Upon putting the question to it, does the passage of electricity through a wire produce a change in its structure ? the answer came, it does, and that to a very considerable extent; for an iron wire adjusted to perfect zero, and which would remain free from any strain for days, becomes instantaneously changed by the first passage of a current from a single cell of Daniell’a battery; the wire has now a permanent twist in a direction coinciding with that of the current, which can be brought again to zero by mechanically untwisting the wire, or undoing that which the passage of electricity has caused. Before describing the new phenomenon, I will state that the only modification required in the apparatus, is a switch or key by means of which the telephone upon the wire circuit is thrown out of this circuit, and the current from a separate battery of two bichromate cells passed through the wire alone, at the same time, care being taken that no current passes through the coil, but that its circuit should remain open during the passage of the electric current through the wire under observation an extra switch on this circuit provides for this. The reason for not allowing two currents to react upon each other, is to avoid errors of observation which may be due to this cause alone. When, however, we take an observation, the battery is upon the coil and the telephone upon the wire alone ; an experiment thus consists of two operations; First, all external communications interrupted, and an electric current passed through the wire; and, second, the electric current taken off the wire, and all ordinary communications restored. As this is done rapidly by means of the switches, very quick observations can be made, or if, desired the effects of both currents can be observed at the same instant. Now, if I place upon the stress bridge a soft iron wire ½ millim. diameter, 25 centims. long, I find, if no previous strain existed in the wire, a perfect zero, and I can make it so either by turning it slightly backwards or forwards, or by heating the wire to a red heat. If I now give a torsion to this wire, I find that its maximum value is with 40° torsion, and that this torsion represents or produces electric currents whose value in sonometric degrees is 50; each degree of torsion up to 40 produces a regular increase, so that once knowing the value of any wire, we can predict from any sonometric readings the value in torsion, or the amount of torsion in the opposite direction it would require to produce a perfect zero.
II. The measurement of magnetic hysteresis
