Development and Positioning Accuracy Assessment of Precise Point Positioning Algorithms Based on GLONASS Code-Pseudorange Measurements

AbstractIn addition to Global Positioning System (GPS) constellation, the number of Global Navigation Satellite System (GLONASS) satellites is increasing; it is now possible to evaluate and analyze the position accuracy with both the GPS and GLONASS constellation. In this article, statistical analysis of static precise point positioning (PPP) using GPS-only, GLONASS-only, and combined GPS/GLONASS modes is evaluated. Observational data of 10 whole days from 10 International GNSS Service (IGS) stations are used for analysis. Position accuracy in east, north, up components, and carrier phase/code residuals is analyzed. Multi-GNSS PPP open-source package is used for the PPP performance analysis. The analysis also provides the GNSS researchers the understanding of the observational data processing algorithm. Calculation statistics reveal that standard deviation (STD) of horizontal component is 3.83, 13.80, and 3.33 cm for GPS-only, GLONASS-only, and combined GPS/GLONASS PPP solutions, respectively. Combined GPS/GLONASS PPP achieves better positioning accuracy in horizontal and three-dimensional (3D) accuracy compared with GPS-only and GLONASS-only PPP solutions. The results of the calculation show that combined GPS/GLONASS PPP improves, on an average, horizontal accuracy by 12.11% and 60.33% and 3D positioning accuracy by 10.39% and 66.78% compared with GPS-only and GLONASS-only solutions, respectively. In addition, the results also demonstrate that GPS-only solutions show an improvement of 54.23% and 62.54% compared with GLONASS-only PPP mode in horizontal and 3D components, respectively. Moreover, residuals of GLONASS ionosphere-free code observations are larger than the GPS code residuals. However, phase residuals of GPS and GLONASS phase observations are of the same magnitude.

Download Full-text

GPS AND GLONASS COMBINED STATIC PRECISE POINT POSITIONING (PPP)

ISPRS - International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences ◽

10.5194/isprs-archives-xli-b1-483-2016 ◽

2016 ◽

Vol XLI-B1 ◽

pp. 483-488 ◽

Cited By ~ 1

Author(s):

D. Pandey ◽

R. Dwivedi ◽

O. Dikshit ◽

A. K. Singh

Keyword(s):

Precise Point Positioning ◽

Rapid Development ◽

Three Dimensional ◽

Global Navigation Satellite Systems ◽

Open Pit ◽

Positioning Accuracy ◽

Dilution Of Precision ◽

Satellite Visibility ◽

Point Positioning ◽

Gps Observations

With the rapid development of multi-constellation Global Navigation Satellite Systems (GNSSs), satellite navigation is undergoing drastic changes. Presently, more than 70 satellites are already available and nearly 120 more satellites will be available in the coming years after the achievement of complete constellation for all four systems- GPS, GLONASS, Galileo and BeiDou. The significant improvement in terms of satellite visibility, spatial geometry, dilution of precision and accuracy demands the utilization of combining multi-GNSS for Precise Point Positioning (PPP), especially in constrained environments. Currently, PPP is performed based on the processing of only GPS observations. Static and kinematic PPP solutions based on the processing of only GPS observations is limited by the satellite visibility, which is often insufficient for the mountainous and open pit mines areas. One of the easiest options available to enhance the positioning reliability is to integrate GPS and GLONASS observations. This research investigates the efficacy of combining GPS and GLONASS observations for achieving static PPP solution and its sensitivity to different processing methodology. Two static PPP solutions, namely standalone GPS and combined GPS-GLONASS solutions are compared. The datasets are processed using the open source GNSS processing environment <i>gLAB</i> 2.2.7 as well as <i>magicGNSS</i> software package. The results reveal that the addition of GLONASS observations improves the static positioning accuracy in comparison with the standalone GPS point positioning. Further, results show that there is an improvement in the three dimensional positioning accuracy. It is also shown that the addition of GLONASS constellation improves the total number of visible satellites by more than 60% which leads to the improvement of satellite geometry represented by Position Dilution of Precision (PDOP) by more than 30%.

Download Full-text

Multi-GNSS Combined Precise Point Positioning Using Additional Observations with Opposite Weight for Real-Time Quality Control

Remote Sensing ◽

10.3390/rs11030311 ◽

2019 ◽

Vol 11 (3) ◽

pp. 311 ◽

Cited By ~ 3

Author(s):

Wenju Fu ◽

Guanwen Huang ◽

Yuanxi Zhang ◽

Qin Zhang ◽

Bobin Cui ◽

...

Keyword(s):

Quality Control ◽

Real Time ◽

Precise Point Positioning ◽

Satellite System ◽

Convergence Time ◽

Navigation Satellite ◽

Positioning Accuracy ◽

Global Navigation ◽

Point Positioning ◽

Global Navigation Satellite

The emergence of multiple global navigation satellite systems (multi-GNSS), including global positioning system (GPS), global navigation satellite system (GLONASS), Beidou navigation satellite system (BDS), and Galileo, brings not only great opportunities for real-time precise point positioning (PPP), but also challenges in quality control because of inevitable data anomalies. This research aims at achieving the real-time quality control of the multi-GNSS combined PPP using additional observations with opposite weight. A robust multiple-system combined PPP estimation is developed to simultaneously process observations from all the four GNSS systems as well as single, dual, or triple systems. The experiment indicates that the proposed quality control can effectively eliminate the influence of outliers on the single GPS and the multiple-system combined PPP. The analysis on the positioning accuracy and the convergence time of the proposed robust PPP is conducted based on one week’s data from 32 globally distributed stations. The positioning root mean square (RMS) error of the quad-system combined PPP is 1.2 cm, 1.0 cm, and 3.0 cm in the east, north, and upward components, respectively, with the improvements of 62.5%, 63.0%, and 55.2% compared to those of single GPS. The average convergence time of the quad-system combined PPP in the horizontal and vertical components is 12.8 min and 12.2 min, respectively, while it is 26.5 min and 23.7 min when only using single-GPS PPP. The positioning performance of the GPS, GLONASS, and BDS (GRC) combination and the GPS, GLONASS, and Galileo (GRE) combination is comparable to the GPS, GLONASS, BDS and Galileo (GRCE) combination and it is better than that of the GPS, BDS, and Galileo (GCE) combination. Compared to GPS, the improvements of the positioning accuracy of the GPS and GLONASS (GR) combination, the GPS and Galileo (GE) combination, the GPS and BDS (GC) combination in the east component are 53.1%, 43.8%, and 40.6%, respectively, while they are 55.6%, 48.1%, and 40.7% in the north component, and 47.8%, 40.3%, and 34.3% in the upward component.

Download Full-text

Single-Frequency Precise Point Positioning Using Multi-Constellation GNSS: GPS, GLONASS, Galileo and BeiDou

GEOMATICA ◽

10.5623/cig2016-203 ◽

2016 ◽

Vol 70 (2) ◽

pp. 113-122 ◽

Cited By ~ 1

Author(s):

Mahmoud Abd Rabbou ◽

Ahmed El-Rabbany

Keyword(s):

Urban Areas ◽

Precise Point Positioning ◽

Cost Effective ◽

Convergence Time ◽

Single Frequency ◽

Dual Frequency ◽

Positioning Accuracy ◽

Point Positioning ◽

Beidou Satellites ◽

Gnss Observations

Single-frequency precise point positioning (PPP) presents a cost-effective positioning technique for a large number of users. However, it possesses low positioning accuracy and convergence time compared with the dual-frequency PPP. Single-frequency PPP commonly employs GPS satellite systems that suffer from poor satellite geometry, especially in dense urban areas. We develop a new single-frequency PPP model that combines the observations of current GNSS constellations, including GPS, GLONASS, Galileo and Beidou. The MGEX IGS final precise products are utilized to account for the orbital and clock errors, while the IGS final global ionospheric maps (GIM) model is used to correct for the ionospheric delay. The GNSS inter-system biases are treated as additional unknowns in the estimation process. The con tri bution of the additional GNSS observations to single-frequency PPP is assessed through solution comparison with its traditional GPS-only counterpart. Various GNSS combinations are considered in the assessment, including GPS/GLONASS, GPS/Galileo, GPS/BeiDou and all-constellation GNSS. It is shown that the additional GNSS observations enhance the PPP solution accuracy and convergence time in comparison with the tra di tional GPS-only solution. Except for stations with a sufficient number of tracked BeiDou satellites, both Galileo and BeiDou have marginal effects on the positioning accuracy due to their limited number of satel lites. However, for stations with a sufficient number of visible BeiDou satellites, an average of 40% PPP accuracy improvement is obtained. The major contribution to the PPP accuracy enhancement is obtained from GLONASS satellite observations.

Download Full-text

Performance of Open Source Precise Point Positioning Software Using Single-Frequency GPS Data

Artificial Satellites ◽

10.2478/v10018-007-0008-2 ◽

2006 ◽

Vol 41 (2) ◽

pp. 79-86 ◽

Cited By ~ 1

Author(s):

Chalermchon Satirapod ◽

Somchai Kriengkraiwasin

Keyword(s):

Open Source ◽

Precise Point Positioning ◽

Main Tool ◽

Single Frequency ◽

Gps Data ◽

Differential Gps ◽

Satellite Clock ◽

Positioning Accuracy ◽

Point Positioning ◽

Station Location

Performance of Open Source Precise Point Positioning Software Using Single-Frequency GPS Data This research aims to assess the performance of GPS Precise Point Positioning (PPP) with code and carrier phase observations from L1 signal collected from geodetic GPS receiver around the world. A simple PPP software developed for processing the single frequency GPS data is used as a main tool to assess a positioning accuracy. The precise orbit and precise satellite clock corrections were introduced into the software to reduce the orbit and satellite clock errors, while ionosphere-free code and phase observations were constructed to mitigate the ionospheric delay. The remaining errors (i.e. receiver clock error, ambiguity term) are estimated using Extended Kalman Filter technique. The data retrieved from 5 IGS stations located in different countries were used in this study. In addition, three different periods of data were downloaded for each station. The obtained data were then cut into 5-min, 10-min, 15-min and 30-min data segments, and each data segment was individually processed with the developed PPP software to produce final coordinates. Results indicate that the use of 5-min data span can provide a horizontal positioning accuracy at the same level as a pseudorange-based differential GPS technique. Furthermore, results confirm effects of station location and seasonal variation on obtainable accuracies.

Download Full-text

Study on Multi-GNSS Precise Point Positioning Performance with Adverse Effects of Satellite Signals on Android Smartphone

Sensors ◽

10.3390/s20226447 ◽

2020 ◽

Vol 20 (22) ◽

pp. 6447

Author(s):

Hongyu Zhu ◽

Linyuan Xia ◽

Dongjin Wu ◽

Jingchao Xia ◽

Qianxia Li

Keyword(s):

Adverse Effects ◽

Precise Point Positioning ◽

Phase Error ◽

Three Dimensional ◽

Satellite System ◽

Dual Frequency ◽

Positioning Accuracy ◽

Noise Ratio ◽

Point Positioning ◽

Gnss Observations

The emergence of dual frequency global navigation satellite system (GNSS) chip actively promotes the progress of precise point positioning (PPP) technology in Android smartphones. However, some characteristics of GNSS signals on current smartphones still adversely affect the positioning accuracy of multi-GNSS PPP. In order to reduce the adverse effects on positioning, this paper takes Huawei Mate30 as the experimental object and presents the analysis of multi-GNSS observations from the aspects of carrier-to-noise ratio, cycle slip, gradual accumulation of phase error, and pseudorange residual. Accordingly, we establish a multi-GNSS PPP mathematical model that is more suitable for GNSS observations from a smartphone. The stochastic model is composed of GNSS step function variances depending on carrier-to-noise ratio, and the robust Kalman filter is applied to parameter estimation. The multi-GNSS experimental results show that the proposed PPP method can significantly reduce the effect of poor satellite signal quality on positioning accuracy. Compared with the conventional PPP model, the root mean square (RMS) of GPS/BeiDou (BDS)/GLONASS static PPP horizontal and vertical errors in the initial 10 min decreased by 23.71% and 62.06%, respectively, and the horizontal positioning accuracy reached 10 cm within 100 min. Meanwhile, the kinematic PPP maximum three-dimensional positioning error of GPS/BDS/GLONASS decreased from 16.543 to 10.317 m.

Download Full-text