Anomalous grazing-incidence small-angle X-ray scattering of Ga2O3-based nanoparticles

2018 ◽  
Vol 51 (2) ◽  
pp. 436-445 ◽  
Author(s):  
Christine Revenant

Grazing-incidence small-angle X-ray scattering (GISAXS) performed at several X-ray energies in the vicinity of the absorption edge of a considered element is called anomalous GISAXS (AGISAXS). This emerging technique takes advantage of the variation of the scattering factor near an absorption edge, allowing the morphology of multi-component nanomaterials to be unraveled. The selected model system for AGISAXS simulations is mainly an In2O3layer containing Ga2O3-based nanoparticles. The transmission coefficients at the different X-ray energies near the GaKedge are identical at one specific incident angle (near the critical angle). Hence, it could be relevant to perform AGISAXS at this incident angle in order to cancel the transmission modification as the X-ray energy changes. For buried nanoparticles, grazing-incidence effects are negligible with respect to the anomalous element-specific contribution provided that the experiments are performed at energies a few electronvolts below the absorption edge. Interestingly, AGISAXS has a clearly different intensity behaviorversusX-ray energy for an embedded monodisperse spherical particle, a hole and a core–shell particle. Hence, AGISAXS can be used to unambiguously distinguish such embedded particles. Moreover, even for a dense layer of core–shell nanoparticles on a substrate, anomalous effects are much larger than grazing effects as the X-ray energy changes. Finally, it is shown that experimental anomalous scattering can be significant and can be satisfactorily simulated.

2006 ◽  
Vol 39 (5) ◽  
pp. 749-751 ◽  
Author(s):  
Byeongdu Lee ◽  
Chieh-Tsung Lo ◽  
Soenke Seifert ◽  
Randall E. Winans

Grazing-incidence small-angle X-ray scattering (GISAXS) patterns of a silver behenate composite film, which has a typical layered structure, are described. The peak position of the film in the GISAXS pattern was varied depending on the incident angle, which was well described by taking into account the refraction and the reflection effects. Since the refractive index of samples depends on sample preparation, it is recommended that the measurement of silver behenate as a standard be done in conventional transmission mode to avoid any complexity.


2012 ◽  
Vol 208 (1) ◽  
pp. 231-244 ◽  
Author(s):  
P. Andreazza ◽  
H. Khelfane ◽  
O. Lyon ◽  
C. Andreazza-Vignolle ◽  
A. Y. Ramos ◽  
...  

2008 ◽  
Vol 41 (1) ◽  
pp. 134-142 ◽  
Author(s):  
Byeongdu Lee ◽  
Chieh-Tsung Lo ◽  
P. Thiyagarajan ◽  
Dong R. Lee ◽  
Zhongwei Niu ◽  
...  

The multiple scattering effects present in grazing-incidence small-angle X-ray scattering (GISAXS) data and interference between them are addressed theoretically as well as experimentally with measurement of a series of patterns at different incident angles, referred to as `incident-angle-resolved GISAXS' (IAR-GISAXS). X-ray reflectivity (XR), GISAXS and IAR-GISAXS of virus particles on Si-substrate supported-polystyrene films have been measured and all the data have been analyzed with appropriate formalisms. It was found that under certain conditions it is possible to extract the correct structural features of the materials from the GISAXS/IAR-GISAXS data using the kinematic SAXS formalisms, without the need to use the distorted-wave Born approximation. Furthermore, the Kiessig fringes in GISAXS enable the measurement of the average distance between the particle and the substrate, similar to the measurement of film thickness using the fringes in the XR data. It is believed that the methods developed here will expand the application of GISAXS as they enable the application of model-independent and kinematic SAXS theories to nanostructured two-dimensional ordered films.


Catalysts ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 730
Author(s):  
Erik Sarnello ◽  
Tao Li

Enzyme immobilization techniques are widely researched due to their wide range of applications. Polymer–protein core–shell nanoparticles (CSNPs) have emerged as a promising technique for enzyme/protein immobilization via a self-assembly process. Based on the desired application, different sizes and distribution of the polymer–protein CSNPs may be required. This work systematically studies the assembly process of poly(4-vinyl pyridine) and bovine serum albumin CSNPs. Average particle size was controlled by varying the concentrations of each reagent. Particle size and size distributions were monitored by dynamic light scattering, ultra-small-angle X-ray scattering, small-angle X-ray scattering and transmission electron microscopy. Results showed a wide range of CSNPs could be assembled ranging from an average radius as small as 52.3 nm, to particles above 1 µm by adjusting reagent concentrations. In situ X-ray scattering techniques monitored particle assembly as a function of time showing the initial particle growth followed by a decrease in particle size as they reach equilibrium. The results outline a general strategy that can be applied to other CSNP systems to better control particle size and distribution for various applications.


2014 ◽  
Vol 115 (20) ◽  
pp. 204311 ◽  
Author(s):  
Nie Zhao ◽  
Chunming Yang ◽  
Qian Zhang ◽  
Xueming Lu ◽  
Yuzhu Wang ◽  
...  

1999 ◽  
Vol 86 (12) ◽  
pp. 6763-6769 ◽  
Author(s):  
Markus Rauscher ◽  
Rogerio Paniago ◽  
Hartmut Metzger ◽  
Zoltan Kovats ◽  
Jan Domke ◽  
...  

2007 ◽  
Vol 78 (11) ◽  
pp. 113910 ◽  
Author(s):  
M. A. Singh ◽  
M. N. Groves ◽  
M. S. Müller ◽  
I. J. Stahlbrand ◽  
D.-M. Smilgies

2010 ◽  
Vol 22 (47) ◽  
pp. 474003 ◽  
Author(s):  
Hiroshi Okuda ◽  
Masayuki Kato ◽  
Keiji Kuno ◽  
Shojiro Ochiai ◽  
Noritaka Usami ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document