Effect surface treatment of recycled concrete aggregate on properties of fresh and hardened concrete

2013 ◽  
Author(s):  
Sallehan Ismail ◽  
Mahyuddin Ramli
Keyword(s):  
Surface Treatment ◽  
Recycled Concrete ◽  
Concrete Aggregate ◽  
Hardened Concrete ◽  
Recycled Concrete Aggregate

EFFECT OF RECYCLED CONCRETE AGGREGATE QUALITY ON PROPERTIES OF CONCRETE

2020 ◽  
Vol 15 (2) ◽  
pp. 57-69
Author(s):  
Daniel Hatungimana ◽  
Şemsi Yazıcı ◽  
Ali Mardani-Aghabaglou
Keyword(s):  
Tensile Strength ◽  
Compressive Strength ◽  
Water Absorption ◽  
Recycled Concrete ◽  
Recycled Aggregates ◽  
Concrete Aggregate ◽  
Hardened Concrete ◽  
Recycled Concrete Aggregate ◽  
Waste Concrete ◽  
Concrete Production

ABSTRACT The possibility of the use of recycled aggregates from the construction industry in green concrete production is of increasing importance to reduce the negative environmental impact associated with construction and demolition wastes. The objective of this study is to investigate the effect of recycled concrete aggregate (RCA) quality on the properties of hardened concrete properties such as compressive strength, splitting tensile strength, density, water absorption capacity and porosity accessible to water. The RCA used in this study was obtained from the crushing of waste concrete with two different compressive strengths (LRCA obtained from the crushing of waste concrete having compressive strengths below 30 MPa and HRCA obtained from the crushing of waste concrete having compressive strengths above 30 MPa). The natural coarse limestone aggregate was 100% replaced with coarse LRCA and HRCA. As a result of the study, the use of 100% HRCA and %100 LRCA instead of limestone coarse aggregate in the concrete adversely affected its mechanical and physical properties. In addition, HRCA showed better performance in terms of compressive strength, tensile strength, water absorption and porosity compared to the use of LRCA. Furthermore, the percentage of adhered mortar on the surface of LRCA and HRCA was analyzed using a computerized micro tomography device, and it was found that the percentages of attached mortar and aggregates are 61% and 35.5% for LRCA, whilst the attached mortar and aggregate contents for HRCA are 45.9% and 53.7%, respectively.

scholarly journals Mechanical Properties of Concrete with Recycled Concrete Aggregate and Fly Ash

Recycling ◽  
2021 ◽  
Vol 6 (2) ◽  
pp. 23
Author(s):  
Ihab Katar ◽  
Yasser Ibrahim ◽  
Mohammad Abdul Malik ◽  
Shabir Hussain Khahro
Keyword(s):  
Compressive Strength ◽  
Water Absorption ◽  
Tensile Tests ◽  
Recycled Concrete ◽  
Concrete Aggregate ◽  
Hardened Concrete ◽  
Recycled Concrete Aggregate ◽  
Replacement Level ◽  
Split Tensile Strength ◽  
Hardened State

Recycled concrete aggregate (RCA) collected from the demolition of old reinforced concrete structures can be reused to prepare structural and non-structural concrete, thereby protecting the environment by preserving natural resources. This study explores RCA’s use, collected from the crushed concrete of different building projects in Riyadh, to manufacture fresh self-compacting concrete (SCC) and investigate its properties in the fresh and hardened state. Four SCC mixes were prepared by replacing natural aggregate (NA) with RCA at 0%, 25%, 50%, and 75% replacement levels. The water-cement (w/c) ratio was maintained constant at 0.38 for all the mixes. Slump Flow, J-ring, and V-funnel tests were performed on the SCC mixes in the fresh state, and the compressive strength of hardened concrete was determined after seven, 14, and 28 days. Water absorption and split tensile tests were also carried out for all the mixes. The findings revealed that it is possible to reach compressive strengths higher than 40 MPa at 28 days for RCA replacement level of 75% by using a superplasticizer and low w/c ratio. The decrease in compressive strength concerning the SCC-NA mix was 25% for 75% replacement level. The highest split tensile strength at 28 days was around 3.3 MPa for a 50% replacement level. The lowest water absorption was 3.2% for SCC-NA, which was gradually increased and was highest at 5.6% for 75% replacement level.

Effect of Recycled Concrete Aggregate Properties on Mixture Proportions of Structural Concrete

2012 ◽  
Vol 2290 (1) ◽  
pp. 105-114 ◽  
Author(s):  
Liam Butler ◽  
Jeffrey S. West ◽  
Susan L. Tighe
Keyword(s):  
Compressive Strength ◽  
Water Demand ◽  
Coarse Aggregate ◽  
Cement Content ◽  
Recycled Concrete ◽  
Concrete Aggregate ◽  
Hardened Concrete ◽  
Recycled Concrete Aggregate ◽  
Aggregate Properties ◽  
Equivalent Control

This study focuses on characterizing several recycled concrete aggregate (RCA) sources, developing concrete mixture proportions that incorporate RCA as coarse aggregate, and investigating the effect of coarse aggregate properties on the main mixture proportion parameters [i.e., cement content, water demand, and water–cement (w/c) ratio]. Four aggregate types were investigated: one control virgin aggregate source and three RCAs produced from the crushing of hardened concrete. Numerous aggregate tests, including density, absorption, abrasion resistance, adhered mortar content, and crushing value, were performed. Fourteen mixture proportions were developed with the use of three mixture proportion scenarios (control, direct replacement, and strength based) and two compressive strength levels (40 and 60 MPa). The effect of RCA on compressive strength and workability was evaluated by replacement of natural coarse aggregate with RCA. Contrary to numerous studies, one of the RCA concretes (RCA-1) had compressive strengths up to 12% higher than the equivalent control mixture. Mixture proportions (water, cement, and w/c ratio) were later adjusted to ensure that the RCA concretes had compressive strength and slump values similar to the control concretes. Variations in water demand, cement content, and w/c ratio could then be directly attributed to the properties of the RCA source. RCA-1 concrete required less cement (and a higher w/c ratio) to achieve strengths and slumps similar to the control concrete. The findings and recommendations of this research will assist concrete producers, engineers, and field technicians involved in the selection of RCA sources in developing mixture proportions for structural-grade RCA concrete.

scholarly journals Properties of Concrete with Recycled Concrete Aggregate Containing Metallurgical Sludge Waste

Materials ◽  
2020 ◽  
Vol 13 (6) ◽  
pp. 1448 ◽  
Author(s):  
Jan Pizoń ◽  
Jacek Gołaszewski ◽  
Mohamed Alwaeli ◽  
Patryk Szwan
Keyword(s):  
Compressive Strength ◽  
Recycled Concrete ◽  
Concrete Aggregate ◽  
Hardened Concrete ◽  
Recycled Concrete Aggregate ◽  
Metallurgical Waste ◽  
Illegal Mining ◽  
Marine Sand ◽  
Sludge Waste ◽  
Natural Aggregates

Sand has been considered to be something of an immeasurable quantity. There are many indications that this view is no longer valid and that the limiting of natural aggregates usage is doubly justified. Firstly, the extraction of natural aggregates is expensive and has a huge impact on the environment. The main issues in sand and gravel mining are the large areas that are affected, ground water level changes, illegal mining, unsuitability of desert and marine sand, and costs of transport. Secondly, metallurgical waste can be used as a substitute for natural aggregates. This is doubly beneficial—the waste is recycled and the use of natural aggregates is reduced. Waste is stored in landfills that take up large areas and there is also the possibility of ground and groundwater pollution by hazardous compounds. The research presented in this article focuses on the technological conditions of using metallurgical waste in its original form and as a component of recycled concrete aggregate (RCA). The use of metallurgical sludge waste or crushed or round RCA to produce concrete deteriorates the consistency and does not significantly affect the air content and density of the concrete mix. RCA lowers the density of hardened concrete. Metallurgical sludge waste or RCA usage adversely affect the absorbability and permeability of concrete. Concrete containing metallurgical sludge waste is of higher compressive strength after 7 and 28 days, with up to 60% of waste as a sand replacement. RCA concrete achieved higher compressive strength also.

scholarly journals Physical, Deformation, and Stiffness Properties of Recycled Concrete Aggregate

2021 ◽  
Vol 13 (8) ◽  
pp. 4245
Author(s):  
Katarzyna Gabryś ◽  
Emil Soból ◽  
Wojciech Sas
Keyword(s):  
Recycled Concrete ◽  
Experimental Program ◽  
Concrete Aggregate ◽  
Test Results ◽  
Recycled Concrete Aggregate ◽  
Granulometric Analysis ◽  
Stiffness Properties ◽  
Grain Distribution ◽  
Natural Aggregates ◽  
Critical Reduction

The construction sector is currently struggling with the reuse of waste originating from the demolition and modernization of buildings and roads. Furthermore, old buildings are gradually being replaced by new structures. This brings a significant increase of concrete debris to waste landfills. To prevent this, many studies on the possibilities of recycling concrete, known as recycled concrete aggregate (RCA), have been done. To broaden the applicability of reused concrete, an understanding of its properties and engineering behavior is required. A difficulty in sustainable, proper management of RCA is the shortage of appropriate test results necessary to assess its utility. For this reason, in the present study, the physical, deformation, and stiffness properties of RCA with gravely grain distribution were analyzed carefully in the geotechnical laboratory. To examine the mentioned properties, an extensive experimental program was planned, which included the following studies: granulometric analysis, Proctor and oedometer tests, as well as resonant column tests. The obtained research results show that RCA has lower values of deformation and stiffness parameters than natural aggregates. However, after applying in oedometer apparatus repetitive cycles of loading/unloading/reloading, some significant improvement in the values of the parameters studied was noticed, most likely due to susceptibility to static compaction. Moreover, some critical reduction in the range of linear response of RCA to dynamic loading was observed.

Sign in / Sign up

Export Citation Format

Share Document