A wideband Colpitts VCO with 30% continuous frequency tuning range using a tunable phase shifter

Author(s):  
Ying Chen ◽  
K Mouthaan ◽  
M Geurts
Author(s):  
Titus Oyedokun ◽  
Riana H. Geschke ◽  
Tinus Stander

Abstract We present a tunable planar groove gap waveguide (PGGWG) resonant cavity at Ka-band. The cavity demonstrates varactor loading and biasing without bridging wires or annular rings, as commonly is required in conventional substrate-integrated waveguide (SIW) resonant cavities. A detailed co-simulation strategy is also presented, with indicative parametric tuning data. Measured results indicate a 4.48% continuous frequency tuning range of 32.52–33.98 GHz and a Qu tuning range of 63–85, corresponding to the DC bias voltages of 0–16 V. Discrepancies between simulated and measured results are analyzed, and traced to process variation in the multi-layer printed circuit board stack, as well as unaccounted varactor parasitics and surface roughness.


2011 ◽  
Vol 2011 ◽  
pp. 1-7 ◽  
Author(s):  
Yusaku Ito ◽  
Kenichi Okada ◽  
Kazuya Masu

This paper proposes a novel wideband LC-based voltage-controlled oscillator (VCO) for multistandard transceivers. The proposed VCO has a core LC-VCO and a tuning-range extension circuit, which consists of switches, a mixer, dividers, and variable gain combiners with a spurious rejection technique. The experimental results exhibit 0.98 to 6.6 GHz continuous frequency tuning with −206 dBc/Hz of FoMT, which is fabricated by using a 0.18 μm CMOS process. The frequency tuning range (FTR) is 149%, and the chip area is 800 μm × 540 μm.


Electronics ◽  
2021 ◽  
Vol 10 (8) ◽  
pp. 889
Author(s):  
Xiaoying Deng ◽  
Peiqi Tan

An ultra-low-power K-band LC-VCO (voltage-controlled oscillator) with a wide tuning range is proposed in this paper. Based on the current-reuse topology, a dynamic back-gate-biasing technique is utilized to reduce power consumption and increase tuning range. With this technique, small dimension cross-coupled pairs are allowed, reducing parasitic capacitors and power consumption. Implemented in SMIC 55 nm 1P7M CMOS process, the proposed VCO achieves a frequency tuning range of 19.1% from 22.2 GHz to 26.9 GHz, consuming only 1.9 mW–2.1 mW from 1.2 V supply and occupying a core area of 0.043 mm2. The phase noise ranges from −107.1 dBC/HZ to −101.9 dBc/Hz at 1 MHz offset over the whole tuning range, while the total harmonic distortion (THD) and output power achieve −40.6 dB and −2.9 dBm, respectively.


Author(s):  
Iman Kundu ◽  
Paul Dean ◽  
Alexander Valavanis ◽  
Joshua R. Freeman ◽  
Mark C. Rosamond ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document