Tailoring high-voltage, high-current thyristors for very high frequency switching

Author(s):  
Howard Sanders ◽  
John Waldron
Author(s):  
Bhuvaneswari C ◽  
R. Samuel Rajesh Babu

<p>Various Resonant Converters for high voltage and high power applications have been designed. Different Topologies of LLC, LCC, and CLL Resonant Converters have been simulated and compared for the same input voltage. The simulation was done at a very high frequency. The Output Power and the Efficiency of all the three Resonant Converters were calculated.With the results, it has been proved that LCC Resonant Converters were very much suited to give an output voltage of around 62 Kilovolts with a output power of 20 kilowatts.</p>


Author(s):  
R.Durga Rao, Et. al.

: in gas insulated substations, issue of very fast transient over voltages is very familiar problem because of its effects on live ultra-high voltage equipment. During switching events of disconnectors and circuit breakers prestrikes and restrikes occur due to which voltage transients propagate through gas insulated switchgear. Reflection retraction of these transients increases voltage magnitude and generates very high frequency oscillations. Mitigation or suppression of these voltage transients is important to protect equipment and their dielectric strength and insulation. Due to very high frequency stress, they wield on the apparatus and their magnitude (up to 3.5pu), they create an important problem in the design of ultra-high voltage Gas Insulated Substations. In this paper nanocrystalline based mitigation technique for VFTOs is presented. Nanocrystalline rings can be placed around inner conductor of GIS switchgear. This method of mitigation technique is investigated with four ultra-high voltage substations simulation test setup. Simulation results are presented in MATLAB/SIMULINK


1977 ◽  
Author(s):  
D. V. Campbell ◽  
William Kennebeck ◽  
A. Zanella ◽  
Paul Sexton

2021 ◽  
pp. 1-16
Author(s):  
Xu Hu ◽  
Bin Lin ◽  
Ping Wang ◽  
Hongguang Lyu ◽  
Tie-Shan Li

Abstract The very high frequency data exchange system (VDES) is promising in promoting electronic navigation (E-navigation) and improving navigation safety. The multiple access control (MAC) protocol is crucial to the transmission performance of VDES. The self-organising time division multiple access (SOTDMA) protocol, as the only access mode given by current recommendations, leads to a high rate of transmission collisions in the traditional automatic identification system (AIS), especially with heavy traffic loads. This paper proposes a novel feedback based time division multiple access (FBTDMA) protocol to address the problems caused by SOTDMA, such that collision of transmissions can be avoided in information transmission among vessels. Simulation results demonstrate that the proposed FBTDMA outperforms the traditional SOTDMA in terms of channel utilisation and throughput, and significantly reduces the transmission collision rate. The study is expected to provide insights into VDES standardisation and E-navigation modernisation.


Materials ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3360
Author(s):  
Yakir Dahan ◽  
Eldad Holdengreber ◽  
Elichai Glassner ◽  
Oz Sorkin ◽  
Shmuel E. Schacham ◽  
...  

A new measurement technique of electrical parameters of superconducting thin films at the Very High Frequency (VHF) range is described, based on resonators with microstrip (MS) structures. The design of an optimal resonator was achieved, based on a thorough theoretical analysis, which is required for derivation of the exact configuration of the MS. A theoretical model is presented, from which an expression for the attenuation of a MS line can be derived. Accordingly, simulations were performed, and an optimal resonator for the VHF range was designed and implemented. Production constraints of YBa2Cu3O7 (YBCO) limited the diameter of the sapphire substrate to 3″. Therefore, a meander configuration was formed to fit the long λ/4 MS line on the wafer. By measuring the complex input reflection coefficients of a λ/4 resonator, we extracted the quality factor, which is mainly affected by the dielectric and conductor attenuations. The experimental results are well fitted by the theoretical model. The dielectric attenuation was calculated using the quasi-static analysis of the MS line. An identical copper resonator was produced and measured to compare the properties of the YBCO resonator in reference to the copper one. A quality factor of ~6·105 was calculated for the YBCO resonator, three orders of magnitude larger than that of the copper resonator. The attenuation per unit length of the YBCO layer was smaller by more than five orders of magnitude than that of the copper.


2020 ◽  
Vol 48 (1) ◽  
pp. 47-100
Author(s):  
Melitta Gillmann

AbstractBased on a corpus study conducted using the GerManC corpus (1650–1800), the paper sketches the functional and sociosymbolic development of subordinate clause constructions introduced by the subjunctor da ‘since’ in different text genres. In the second half of the 17th and the first half of the 18th century, the da clauses were characterized by semantic vagueness: Besides temporal, spatial and causal relations, the subjunctor established conditional, concessive, and adversative links between clauses. The corpus study reveals that different genres are crucial to the readings of da clauses. Spatial and temporal usages, for example, occur more often in sermons than in other genres. The conditional reading, in contrast, strongly tends to occur in legal texts, where it displays very high frequency. This could be the reason why da clauses carry indexical meaning in contemporary German and are associated with formal language. Over the course of the 18th century, the causal usages increase in all genres. Surprisingly, these causal da clauses tend to be placed in front of the matrix clause despite the overall tendency of causal clauses to follow the matrix clause.


Sign in / Sign up

Export Citation Format

Share Document