Physico-chemical properties of power transformer oil mixtures

Author(s):  
H. Moulai ◽  
I. Khelfane ◽  
A. Yahiat ◽  
T. Toudja ◽  
A. Nacer ◽  
...  
2020 ◽  
Vol 62 (4) ◽  
pp. 222-231
Author(s):  
C Ranga ◽  
A Kumar ◽  
R Chandel

In the present work, a new electrothermal combined stress test cell has been designed and fabricated to conduct accelerated electrothermal ageing. The fabricated test cell includes all possible real working conditions of the transformers. The effects of accelerated electrothermal ageing on the performance of power transformers with thermally upgraded Kraft (TUK), Nomex-910 and Nomex-410 solid dielectrics in conjunction with mineral oil have been investigated. The accelerated electrothermal ageing has been performed for a temperature range of 100°C to 220°C, along with 10 kV electrical stress. Subsequently, several electrical, thermal, mechanical and chemical properties of transformer oil and different paper dielectrics have been determined. It has been observed from the diagnostic test results that Nomex impregnated mineral oil samples have better electrothermal performance as well as oxidation stability when compared to the thermally upgraded Kraft oil samples. Therefore, Nomex insulating materials in conjunction with mineral oil are suggested as alternative solid dielectrics for power transformers in order to achieve better oxidation stability, improved thermal performance for long service runs and reduced operating and maintenance costs. It is envisioned that the present experimental study will be very beneficial to utility managers and end-users of power transformers.


2013 ◽  
Vol 664 ◽  
pp. 632-637
Author(s):  
Tahar Toudja ◽  
Hocine Moulai ◽  
Azzeddine Nacer ◽  
Abdeslem Beldjillali ◽  
Nadia Saidi ◽  
...  

This work aims at the characterization of power transformer oil mixtures by using dc charging currents measurements for long field application times. The principle of this approach is inspired from the technique of measurements carried out on solid dielectrics used in high voltage insulation. It will be applied to characterize mixtures between two compatible oils of different provenances and ages. The obtained results are conclusive and reinforce those obtained by classical physicochemical methods of characterization. For the purpose, we intent to link between the space charge behavior in the insulation and its several characteristics. Moreover, in addition to the fact that the obtained results are in good agreement with the physicochemical characteristics, the charging currents reported at room temperature enabled us to determine the mixture resistivity and charge carriers' mobility.


1985 ◽  
Vol 34 (9) ◽  
pp. 713-717
Author(s):  
Hideo NAKAJIMA ◽  
Yasuhiko MACHIDA ◽  
Muneo TANAKA ◽  
Hajime MATSUDA

2019 ◽  
Vol 124 ◽  
pp. 05005
Author(s):  
I.D. Gizzatova ◽  
V.K. Kozlov ◽  
D.M. Valiullina

During the operation of transformers, the insulating oil is aging, therefore, there is the deterioration of its insulating properties, which is determined by multiple physico-chemical processes. The most dangerous factor, from the point of view of preserving the operational reliability and resource of a power transformer, is the moisture content of the insulation. Most methods for determining moisture content have measurement errors. These errors are largely dependent on impurities that are contained in the oil. The modified Fisher method proposed in the article allows determining the amount of impurities in the oil and the absolute moisture content. Conducted research allows also to determine the composition of impurities, to reveal the relationship between impurities and some parameters of transformer oil.


2013 ◽  
Vol 14 (4) ◽  
pp. 297-302 ◽  
Author(s):  
Veresha Dukhi ◽  
Ajay Bissessur ◽  
Catherine Jane Ngila ◽  
Nelson Mutatina Ijumba

Abstract The blending of transformer oil (used mainly as an insulating oil) with appropriate synthetic antioxidants, such as BHT (2,6-di-tert-butyl-4-methylphenol) and DBP (2,6-di-tert-butylphenol) have been previously reported. This article is focused on the use of antioxidant extracts from turmeric (Curcuma longa), a natural source. Turmeric is well known for its antimicrobial, antioxidant and anticarcinogenic properties owing to the active nature of its components. Extracts from powdered turmeric were subsequently blended into naphthenic-based uninhibited virgin transformer oil, hereinafter referred to as extract-oil blends (E-OB). Thin-layer chromatography (TLC) of the oil blends revealed that five components extracted from turmeric powder were successfully blended into the oil. Subsequent gas chromatography–mass spectrometry (GC–MS) analysis confirmed the presence of the compounds: curcumene, sesquiphellandrene, ar-turmerone, turmerone and curlone. Thermogravimetric analysis (TGA) of the extract-oil blends, containing various levels of extracts, revealed an average temperature shift of ∼8.21°C in the initial onset of degradation in comparison to virgin non-blended oil. The 2,2-diphenyl-1-picrylhydrazyl (DPPH) assay showed that an increase in the mass aliquot of turmeric extracts in the transformer oil increased the free radical scavenging activity of the oil. Electrical properties of the oil investigated showed that the dissipation factor in the blended oil was found to be lower than that of virgin transformer oil. Evidently, a lower dissipation value renders the oil blend as a superior insulator over normal virgin non-blended oil. This investigation elucidated improved physico-chemical properties of transformer oil blended with turmeric antioxidant extracts.


Author(s):  
H. Gross ◽  
H. Moor

Fracturing under ultrahigh vacuum (UHV, p ≤ 10-9 Torr) produces membrane fracture faces devoid of contamination. Such clean surfaces are a prerequisite foe studies of interactions between condensing molecules is possible and surface forces are unequally distributed, the condensate will accumulate at places with high binding forces; crystallites will arise which may be useful a probes for surface sites with specific physico-chemical properties. Specific “decoration” with crystallites can be achieved nby exposing membrane fracture faces to water vopour. A device was developed which enables the production of pure water vapour and the controlled variation of its partial pressure in an UHV freeze-fracture apparatus (Fig.1a). Under vaccum (≤ 10-3 Torr), small container filled with copper-sulfate-pentahydrate is heated with a heating coil, with the temperature controlled by means of a thermocouple. The water of hydration thereby released enters a storage vessel.


1990 ◽  
Vol 63 (03) ◽  
pp. 499-504 ◽  
Author(s):  
A Electricwala ◽  
L Irons ◽  
R Wait ◽  
R J G Carr ◽  
R J Ling ◽  
...  

SummaryPhysico-chemical properties of recombinant desulphatohirudin expressed in yeast (CIBA GEIGY code No. CGP 39393) were reinvestigated. As previously reported for natural hirudin, the recombinant molecule exhibited abnormal behaviour by gel filtration with an apparent molecular weight greater than that based on the primary structure. However, molecular weight estimation by SDS gel electrophoresis, FAB-mass spectrometry and Photon Correlation Spectroscopy were in agreement with the theoretical molecular weight, with little suggestion of dimer or aggregate formation. Circular dichroism studies of the recombinant molecule show similar spectra at different pH values but are markedly different from that reported by Konno et al. (13) for a natural hirudin-variant. Our CD studies indicate the presence of about 60% beta sheet and the absence of alpha helix in the secondary structure of recombinant hirudin, in agreement with the conformation determined by NMR studies (17)


1963 ◽  
Vol 79 (2) ◽  
pp. 263-293 ◽  
Author(s):  
E.M. Savitskii ◽  
V.F. Terekhova ◽  
O.P. Naumkin

Sign in / Sign up

Export Citation Format

Share Document