Vibration Suppression Motor Drive Control for Industrial Robot Using Notch Filter with Little Phase Error

2007 ◽  
Author(s):  
Toshimasa Miyazaki ◽  
Hisashi Kataoka ◽  
Somsawas Tungpataratanawong ◽  
Kiyoshi Ohishi ◽  
Seiichiro Katsura
Keyword(s):  
Vibration Suppression ◽  
Industrial Robot ◽  
Phase Error ◽  
Notch Filter ◽  
Motor Drive ◽  
Drive Control

A High Performance of Induction Motor Drive System

2020 ◽  
Vol 13 (8) ◽  
pp. 1129-1134
Author(s):  
Cuifeng Shen ◽  
Hanhua Yang
Keyword(s):  
Induction Motor ◽  
High Performance ◽  
Fuzzy Controller ◽  
Drive System ◽  
Motor Drive ◽  
Deterministic System ◽  
Induction Motor Drive ◽  
Paper Making ◽  
Drive Control ◽  
Motor Drive System

Background: A multi-motor synchronous drive control system is widely used in many fields, such as electric vehicle drive, paper making, and printing. Methods: On the basis of the optimized structure of ADRC, a fuzzy first-order active disturbance rejection controller was developed. Double channels compensation of extended state observer was employed to estimate and compensate the total disturbances, and an approximate linearization and deterministic system was obtained. As the parameters of ADRC are adjusted online by a fuzzy controller, the performance of the controller is effectively improved. Results: Based on the SIMATIC S7-300 induction motor control experimental platform, the performances of anti-interference and tracking performance are tested. Conclusion: The actual experimental results indicated that compared with PID control, induction motor drive system controlled by fuzzy ADRC has higher dynamic and static status and following performances and stronger anti-interference abilities.

High-Speed End Milling Using a Feedforward Control Architecture

1996 ◽  
Vol 118 (2) ◽  
pp. 178-187 ◽  
Author(s):  
E. D. Tung ◽  
M. Tomizuka ◽  
Y. Urushisaki
Keyword(s):  
High Speed ◽  
Feedforward Control ◽  
End Milling ◽  
Phase Error ◽  
Cutting Speed ◽  
Frequency Domain Analysis ◽  
Maximum Speed ◽  
Drive Control ◽  
Machining Errors ◽  
Feedforward Controller

Experiments are performed for end milling aluminum at 15,000 RPM spindle speed (1,508 m/min cutting speed) and up to 3 m/min table feedrate using an experimental machine tool control system. A digital feedforward controller for feed drive control incorporates the Zero Phase Error Tracking Controller (ZPETC) and feedforward friction compensation. The controller achieves near-perfect (±3 μm) tracking over a 26 mm trajectory with a maximum speed of 2 m/min. The maximum contouring error for a 26 mm diameter circle at this speed is less than 4 μm. Tracking and contouring experiments are conducted for table feedrates as high as 10 m/min. Frequency domain analysis demonstrates that the feedforward controller achieves a bandwidth of 10 Hz without phase distortion. In a direct comparison of accuracy, the machining errors in specimens produced by the experimental controller were up to 20 times smaller than the errors in specimens machined by an industrial CNC.

Sign in / Sign up

Export Citation Format

Share Document