A high-efficiency and high-gain, plastic packaged GaN HEMT for 3.5-GHz-band LTE base stations

2016 ◽  
Author(s):  
N. Kosaka ◽  
S. Fujiwara ◽  
A. Okamura ◽  
K. Chomei ◽  
Y. Sasaki ◽  
...  
Keyword(s):  
High Efficiency ◽  
High Gain ◽  
Base Stations ◽  
Gan Hemt

ISM 2.45 GHz band high-efficient 15 W GaN HEMT power amplifier: design validation

2019 ◽  
Vol 11 (7) ◽  
pp. 546-553 ◽  
Author(s):  
Marcin Góralczyk ◽  
Wojciech Wojtasiak
Keyword(s):  
Output Power ◽  
Power Amplifier ◽  
High Efficiency ◽  
Power Level ◽  
High Gain ◽  
Output Power Level ◽  
Tuning Method ◽  
Gan Hemt ◽  
High Efficient ◽  
Amplifier Design

AbstractThis paper describes the development of a power amplifier operating over a 2.4–2.5 GHz frequency range with the output power level more than 15 W and 60% PAE. The transistor applied was the 10 W (13 W Psat) power GaN HEMT (CGH40010F from Wolfspeed) recommended up to 6 GHz. A harmonic tuning method was used to achieve even 30% more output power than the CGH40010 transistor was specified to deliver while maintaining high gain and high efficiency. Furthermore, an accuracy analysis of amplifier design was also conducted. It included validation and correction of the available transistor models as well as validation of the models of microstrip circuits implemented in ADS. Finally, it was concluded that both the mentioned sources of errors contributed at a similar level.

scholarly journals A fully integrated broadband, high-gain, high-power and high-efficiency UHF amplifier using GaAs HBT and GaN HEMT

2017 ◽  
Vol 14 (18) ◽  
pp. 20170639-20170639
Author(s):  
Ruirong Hao ◽  
Xiaodong Zhang ◽  
Feng Wang ◽  
Huai Gao ◽  
Jianchun Cheng ◽  
...  
Keyword(s):  
High Power ◽  
High Efficiency ◽  
High Gain ◽  
Fully Integrated ◽  
Gan Hemt

scholarly journals High-Efficiency Polarizer Reflectarray Antennas for Data Transmission Links from a CubeSat

Electronics ◽  
2021 ◽  
Vol 10 (15) ◽  
pp. 1802
Author(s):  
Eduardo Martinez-de-Rioja ◽  
Daniel Martinez-de-Rioja ◽  
Rafael López-Sáez ◽  
Ignacio Linares ◽  
Jose A. Encinar
Keyword(s):  
Circular Polarization ◽  
Data Transmission ◽  
High Efficiency ◽  
High Gain ◽  
Dual Band ◽  
Left Handed ◽  
Linearly Polarized ◽  
Flat Profile ◽  
First Time ◽  
Collimated Beam

This paper presents two designs of high-efficiency polarizer reflectarray antennas able to generate a collimated beam in dual-circular polarization using a linearly polarized feed, with application to high-gain antennas for data transmission links from a Cubesat. First, an 18 cm × 18 cm polarizer reflectarray operating in the 17.2–22.7 GHz band has been designed, fabricated, and tested. The measurements of the prototype show an aperture efficiency of 52.7% for right-handed circular polarization (RHCP) and 57.3% for left-handed circular polarization (LHCP), both values higher than those previously reported in related works. Then, a dual-band polarizer reflectarray is presented for the first time, which operates in dual-CP in the frequency bands of 20 GHz and 30 GHz. The proposed antenna technology enables a reduction of the complexity and cost of the feed chain to operate in dual-CP, as a linear-to-circular polarizer is no longer required. This property, combined with the lightweight, flat profile and low fabrication cost of printed reflectarrays, makes the proposed antennas good candidates for Cubesat applications.

scholarly journals Ka-Band Lightweight High-Efficiency Wideband 3D Printed Reflector Antenna

2017 ◽  
Vol 2017 ◽  
pp. 1-7 ◽  
Author(s):  
Yu Zhai ◽  
Ding Xu ◽  
Yan Zhang
Keyword(s):  
High Efficiency ◽  
Near Field ◽  
Side Lobe ◽  
High Gain ◽  
Reflector Antenna ◽  
Field Analysis ◽  
Side Lobe Level ◽  
Ka Band ◽  
3D Printed ◽  
Reflecting Surface

This paper presents a lightweight, cost-efficient, wideband, and high-gain 3D printed parabolic reflector antenna in the Ka-band. A 10 λ reflector is printed with polylactic acid- (PLA-) based material that is a biodegradable type of plastic, preferred in 3D printing. The reflecting surface is made up of multiple stacked layers of copper tape, thick enough to function as a reflecting surface (which is found 4 mm). A conical horn is used for the incident field. A center-fed method has been used to converge the energy in the broadside direction. The proposed antenna results measured a gain of 27.8 dBi, a side lobe level (SLL) of −22 dB, and a maximum of 61.2% aperture efficiency (at 30 GHz). A near-field analysis in terms of amplitude and phase has also been presented which authenticates the accurate spherical to planar wavefront transformation in the scattered field.

scholarly journals Design of a High Gain Compact Circular Microstrip Patch Antenna for X-Band

2018 ◽  
Vol 7 (2.6) ◽  
pp. 168
Author(s):  
Madhukant Patel ◽  
Veerendra Singh Jadaun ◽  
Kanhiya Lal ◽  
Piyush Kuchhal
Keyword(s):  
Patch Antenna ◽  
Microstrip Antenna ◽  
High Efficiency ◽  
High Gain ◽  
Microstrip Patch Antenna ◽  
Radar Sensors ◽  
Microstrip Patch ◽  
X Band ◽  
Circular Patch Antenna ◽  
Power Radiation

This paper presents design a High Gain Small Size Microstrip Patch Antenna for X-Band applications such as Moving target RADAR sensor, Motion detector, Microwave camera, Ground Penetration RADAR sensors, wall penetration scanners and many medical applications. Now we have to selected circular geometry of micro strip patch antenna because circular geometry overcomes edge effect of antenna. The proposed antenna is designed to operate for X-band at the centre frequency of 10 GHz. The proposed Circular patch antenna is compact and easy to body mount with a high efficiency. The compactness makes it a better choice as compare with other antenna in the X-band. The proposed antenna shows a very sharp return loss of -46 dB at 10 GHz having narrow pattern with a good gain of 4.7 dBi. This enables its use in high directional applications. The paper represents the designing steps, and the simulation result obtained. The software used here for this circular shaped microstrip antenna is IE3D. Various parameters such as gain, power, radiation pattern, and S11 of the antenna are mentioned.

Sign in / Sign up

Export Citation Format

Share Document