Cell wall thickness and composition are related to photosynthesis in Antarctic mosses

2021 ◽  
Author(s):  
Margalida Roig‐Oliver ◽  
Cyril Douthe ◽  
Josefina Bota ◽  
Jaume Flexas
2014 ◽  
Vol 11 (1) ◽  
pp. 51
Author(s):  
Mohd Helmy Ibrahim ◽  
Mohd Nazip Suratman ◽  
Razali Abd Kader

Trees planted from agroforestry practices can become valuable resources in meeting the wood requirements of many nations. Gliricidia sepium is an exotic species introduced to the agricultural sector in Malaysia mainly for providing shade for cocoa and coffee plantations. This study investigates its wood physical properties (specific gravity and moisture content) and fibre morphology (length, lumen diameter and cell wall thickness) of G. sepium at three intervals according to age groups ( three, five and seven years of ages). Specific gravity (0.72) was significantly higher at seven years ofage as compared to five (0.41) and three (0.35) years age group with a mean of 0.43 (p<0.05). Mean moisture content was 58.3% with no significant difference existing between the tree age groups. Fibre diameter (22.4 mm) was significantly lower (p<0.05) for the trees which were three years of age when compared to five and seven years age groups (26.6 mm and 24. 7 mm), respectively. Means of fibre length, lumen diameter and cell wall thickness were 0.83 mm, 18.3 mm, and 6.2 mm, respectively, with no significant differences detected between trees in all age groups. Further calculation on the coefficient of suppleness and runkel ratio suggest that wood from G.sepium may have the potential for insulation board manufacturing and paper making. However, future studies should experiment the utilisation of this species for these products to determine its full potential.


2021 ◽  
pp. 026248932110068
Author(s):  
Youming Chen ◽  
Raj Das ◽  
Hui Wang ◽  
Mark Battley

In this study, the microstructure of a SAN foam was imaged using a micro-CT scanner. Through image processing and analysis, variations in density, cell wall thickness and cell size in the foam were quantitatively explored. It is found that cells in the foam are not elongated in the thickness (or rise) direction of foam sheets, but rather equiaxed. Cell walls in the foam are significantly straight. Density, cell size and cell wall thickness all vary along the thickness direction of foam sheets. The low density in the vicinity of one face of foam sheets leads to low compressive stiffness and strength, resulting in the strain localization observed in our previous compressive tests. For M80, large open cells on the top face of foam sheets are likely to buckle in compressive tests, therefore being another potential contributor to the strain localization as well. The average cell wall thickness measured from 2D slice images is around 1.4 times that measured from 3D images, and the average cell size measured from 2D slice images is about 13.8% smaller than that measured from 3D images. The dispersions of cell wall thickness measured from 2D slice images are 1.16–1.20 times those measured from 3D images. The dispersions of cell size measured from 2D slice images are 1.12–1.36 times those measured from 3D images.


2003 ◽  
Vol 33 (10) ◽  
pp. 1905-1914 ◽  
Author(s):  
Irina P Panyushkina ◽  
Malcolm K Hughes ◽  
Eugene A Vaganov ◽  
Martin AR Munro

We reconstructed air temperature for two periods in the growth season from cell dimension and cell number variability in cross-dated tree rings of Larix cajanderi Mayr. from northeastern Siberia. Thirteen tree-ring chronologies based on cell size, cell wall thickness, and cell number were developed for AD 1642–1993. No clear evidence was found of an age-related trend in cell dimensions in the sampled materials, but cell numbers were correlated with cambial age. The chronologies contain strong temperature signals associated with the timing of xylem growth. We obtained reliable reconstructions of mean June temperature from the total cell number and July–September temperature from the cell wall thickness of latewood. June temperature and July–September temperature covaried for most of the period from AD 1642 to AD 1978. After that time, June temperature became cooler relative to July–September temperature. This difference caused disproportional changes in earlywood tracheids because of the late start of growth and cool conditions in June followed by warming during the rest of the season. The identification of this unusual recent change has shown that intraseasonal resolution may be achieved by cell dimension and cell number chronologies.


2001 ◽  
Vol 31 (11) ◽  
pp. 2049-2057 ◽  
Author(s):  
Tongli Wang ◽  
Sally N Aitken

Variation in xylem anatomy among selected populations of lodgepole pine (Pinus contorta Dougl. ex Loud. var. latifolia Engelm.) was examined using digital image analysis based on an annual growth ring (age 10) per tree. Four subpopulations were selected using the following criteria for height growth and wood density: (i) fast growth and high density; (ii) slow growth and high density; (iii) fast growth and low density; and (iv) slow growth and low density. Significant differences were found among subpopulations for several anatomical parameters including tracheid density, lumen size, and cell wall thickness that may affect the economic value and utilization of wood. Principal component analysis indicate that the first four principal components (PCs) were associated with (i) ring area (PC1), (ii) earlywood density (PC2), (iii) latewood density (PC3), and (iv) lumen shape in earlywood (PC4), suggesting that these aspects of wood properties and growth are controlled by different sets of genes. Relative contributions of total number of tracheids, tracheid lumen size, and cell wall thickness to ring area and correlations between cell wall area proportion and X-ray density are discussed.


2004 ◽  
Vol 94 (5) ◽  
pp. 438-445 ◽  
Author(s):  
Andrea Ficke ◽  
David M. Gadoury ◽  
Robert C. Seem ◽  
Dale Godfrey ◽  
Ian B. Dry

Grape berries are highly susceptible to powdery mildew 1 week after bloom but acquire ontogenic resistance 2 to 3 weeks later. We recently demonstrated that germinating conidia of the grape powdery mildew pathogen (Uncinula necator) cease development before penetration of the cuticle on older resistant berries. The mechanism that halts U. necator at that particular stage was not known. Several previous studies investigated potential host barriers or cell responses to powdery mildew in berries and leaves, but none included observation of the direct effect of these factors on pathogen development. We found that cuticle thickness increased with berry age, but that ingress by the pathogen halted before formation of a visible penetration pore. Cell wall thickness remained unchanged over the first 4 weeks after bloom, the time during which berries progressed from highly susceptible to nearly immune. Autofluorescent polyphenolic compounds accumulated at a higher frequency beneath appressoria on highly susceptible berries than on highly resistant berries; and oxidation of the above phenolics, indicated by cell discoloration, developed at a significantly higher frequency on susceptible berries. Beneath the first-formed appressoria of all germinated conidia, papillae occurred at a significantly higher frequency on 2- to 5-day-old berries than on 30- to 31-day-old fruit. The relatively few papillae observed on older berries were, in most cases (82.8 to 97.3%), found beneath appressoria of conidia that had failed to produce secondary hyphae. This contrasted with the more abundantly produced papillae on younger berries, where only 35.4 to 41.0% were located beneath appressoria of conidia that had failed to produce secondary hyphae. A pathogenesis-related gene (VvPR-1) was much more highly induced in susceptible berries than in resistant berries after inoculation with U. necator. In contrast, a germin-like protein (VvGLP3) was expressed within 16 h of inoculation in resistant, but not in susceptible berries. Our results suggest that several putative barriers to infection, i.e., cuticle and cell wall thickness, antimicrobial phenolics, and two previously described pathogenesis-related proteins, are not principal causes in halting pathogen ingress on ontogenically resistant berries, but rather that infection is halted by one or more of the following: (i) a preformed physical or biochemical barrier near the cuticle surface, or (ii) the rapid synthesis of an antifungal compound in older berries during the first few hours of the infection process.


Author(s):  
Lukasz Wejnerowski ◽  
Slawek Cerbin ◽  
Maria K. Wojciechowicz ◽  
Marcin K. Dziuba

<p>Recent studies have shown that the filamentous cyanobacterium <em>Aphanizomenon gracile</em> Lemmermann, strain SAG 31.79, consists of two types of filaments that differ in thickness. These two types are known to vary in resistance to <em>Daphnia</em> <em>magna</em> grazing: thin filaments (&lt;2.5 µm) are more vulnerable to grazing than the thick ones (&gt;2.5 µm). In this study, we investigated whether the difference in the vulnerability to grazing of thin and thick filaments is a result of different thickness of their cell walls, a filament stiffness determinant. We expected thick filaments to have thicker cell walls than the thin ones. Additionally, we analysed whether cell wall thickness correlates with filament thickness regardless of the filament type. A morphometric analysis of cell walls was performed using transmission electron micrographs of ultra-thin sections of the batch-cultured cyanobacterial material.  Our study revealed that the thin type of filaments had thinner cell walls than the thick filaments. Moreover, cell wall thickness was positively correlated with filament thickness. TEM (transmission electron microscopy) observations also revealed that the thin type of filaments was often at different stages of autocatalytic cell destruction, which was mainly manifested in the increase in cell vacuolization and degradation of the cytoplasm content. Based on our findings, we assume that previously reported higher resistance of thick filaments to <em>Daphnia</em> grazing results from greater stiffness and excellent physiological conditions of thick filaments. </p>


1993 ◽  
Vol 73 (1) ◽  
pp. 111-122 ◽  
Author(s):  
B. P. Goplen ◽  
R. E. Howarth ◽  
G. L. Lees

A modified nylon bag technique, described in detail in this paper, appears to be an effective method of selecting for a lower initial rate of digestion (IRD) in alfalfa. Breeding for reduced IRD in alfalfa resulted in a 15% reduction in 4-h dry matter disappearance (DMD) after three cycles of selection (ultimate goal of 25–30 % reduction for a bloat-safe alfalfa). No further reduction in IRD occurred with a 4th cycle of selection. The IRD characteristic appears to be expressed at early stages of vegetative growth (pre-bud to early bud) and not at a more advanced stage of maturity (mid-bud to early bloom). The IRD characteristic also appears to be subject to environmental influence. Alfalfa plants selected for reduced IRD have consistently thicker cell walls compared to the unselected alfalfa check cv. Beaver. The advanced cycle 4 LIRD synthetic is being increased for subsequent pasture trials and assessment of bloat reduction. Key words: Nylon bag technique, cell rupture, pasture bloat, initial rate of digestion, cell wall thickness


Sign in / Sign up

Export Citation Format

Share Document