Optimal Orientation of a Liquid-Film Solar-Assisted Brine Concentrator

2008 ◽  
Vol 130 (2) ◽  
Author(s):  
Dae Hyun Kim ◽  
Bryan M. Jenkins

Recently, an open, liquid-film concentrator has been both theoretically and experimentally evaluated for increasing evaporation and concentration rates above those for simple solar evaporator basins (Kim, D. H., Jenkins, B. M., Yore, M. W., and Kim, N. J., 2007, “Salt Recovery From Agriculture Drainage Water Using a Liquid Film Solar-Assisted Concentrator: Simulation and Model Validation,” Sol. Energy, 81(10), pp. 1314–1321). For azimuth and tilt angles of the inclined brine concentrator where the maximum solar gain and mean wind direction are not in concurrence, the optimum orientation to maximize evaporation over a fixed interval of time was determined by simulation. Simulation was performed using ten years of hourly weather data for two different locations where wind blows mostly from the south and the north throughout the year, respectively (Davis and Five Points, CA) with different orientations and slope angles. Maximum annual evaporation for Davis occurred with the concentrator facing southwest and sloped at the latitude angle. At Five Points, maximum evaporation occurred with the inclined surface facing north even with the less favorable angle for solar absorption, indicating the importance of the wind speed-dependent mass transfer coefficient on overall performance. Additional experiments are needed to validate the simulations.

2017 ◽  
Vol 110 ◽  
pp. 01087
Author(s):  
Maria V. Bartashevich ◽  
Maxim G. Vlasenko ◽  
Andrey A. Pil’nik ◽  
Andrey A. Chernov

1982 ◽  
Vol 47 (3) ◽  
pp. 766-775 ◽  
Author(s):  
Václav Kolář ◽  
Jan Červenka

The paper presents results obtained by processing a series of published experimental data on heat and mass transfer during evaporation of pure liquids from the free board of a liquid film into the turbulent gas phone. The data has been processed on the basis of the earlier theory of mechanism of heat and mass transfer. In spite of the fact that this process exhibits a strong Stefan's flow, the results indicate that with a proper definition of the driving forces the agreement between theory and experiment is very good.


2003 ◽  
Vol 68 (11) ◽  
pp. 2080-2092 ◽  
Author(s):  
Martin Keppert ◽  
Josef Krýsa ◽  
Anthony A. Wragg

The limiting diffusion current technique was used for investigation of free convective mass transfer at down-pointing up-facing isosceles triangular surfaces of varying length and inclination. As the mass transfer process, copper deposition from acidified copper(II) sulfate solution was used. It was found that the mass transfer rate increases with inclination from the vertical to the horizontal position and decreases with length of inclined surface. Correlation equations for 7 angles from 0 to 90° were found. The exponent in the ShL-RaL correlation ranged from 0.247 for the vertical case, indicating laminar flow, to 0.32 for inclinations of 60 to 90°, indicating mixed or turbulent flow. The general correlation ShL = 0.358(RaL sin θ)0.30 for the RaL sin θ range from 7 × 106 to 2 × 1011 and inclination range from 15 to 90° was obtained.


Sign in / Sign up

Export Citation Format

Share Document