Mechanisms of Enhanced Heat Transfer for Oscillating Circular Cylinders

Volume 1 ◽  
2004 ◽  
Author(s):  
Tait Pottebaum ◽  
Mory Gharib
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Vortex Formation ◽  
Cross Flow ◽  
Circular Cylinders ◽  
Transfer Enhancement ◽  
Heated Cylinder ◽  
Wide Range ◽  
Temperature And Velocity Fields ◽  
Oscillating Circular Cylinders

Experiments were conducted to determine the relationship between wake structure and heat transfer for an oscillating circular cylinder in cross-flow. An internally heated cylinder was suspended in a water tunnel and oscillated transverse to the freestream. The cylinder’s heat transfer coefficient was measured over a wide range of oscillation amplitudes and frequencies. By comparing these results to the known wake mode regions in the amplitude-frequency plane, relationships between wake mode and heat transfer were identified. Representative cases were investigated further by using digital particle image thermometry/velocimetry (DPIT/V) to simultaneously measure the temperature and velocity fields in the near-wake. This revealed more detail about the mechanisms of heat transfer enhancement. The dynamics of the vortex formation process, including the trajectories of the vortices during roll-up, are the primary cause of the heat transfer enhancement.

Large Eddy Simulations of Staggered Parallel-Plate Flows

2005 ◽  
Author(s):  
M. V. Pham ◽  
F. Plourde ◽  
S. K. Doan
Keyword(s):  
Heat Transfer ◽  
Numerical Simulations ◽  
Heat Transfer Enhancement ◽  
Parallel Plate ◽  
Large Scale ◽  
Primary Objective ◽  
Transfer Enhancement ◽  
Turbulent Structures ◽  
Wide Range ◽  
Large Eddy

Heat transfer enhancement is a subject of major concern in numerous fields of industry and research. Having received undivided attention over the years, it is still studied worldwide. Given the exponential growth of computing power, large-scale numerical simulations are growing steadily more realistic, and it is now possible to obtain accurate time-dependent solutions with far fewer preliminary assumptions about the problems. As a result, an increasingly wide range of physics is now open for exploration. More specifically, it is time to take full advantage of large eddy simulation technique so as to describe heat transfer in staggered parallel-plate flows. In fact, from simple theory through experimental results, it has been demonstrated that surface interruption enhances heat transfer. Staggered parallel-plate geometries are of great potential interest, and yet many numerical works dedicated to them have been tarnished by excessively simple assumptions. That is to say, numerical simulations have generally hypothesized lengthwise periodicity, even though flows are not periodic; moreover, the LES technique has not been employed with sufficient frequency. Actually, our primary objective is to analyze turbulent influence with regard to heat transfers in staggered parallel-plate fin geometries. In order to do so, we have developed a LES code, and numerical results are compared with regard to several grid mesh resolutions. We have focused mainly upon identification of turbulent structures and their role in heat transfer enhancement. Another key point involves the distinct roles of boundary restart and the vortex shedding mechanism on heat transfer and friction factor.

Heat transfer enhancement in microchannels with cross-flow synthetic jets

2010 ◽  
Vol 49 (3) ◽  
pp. 504-513 ◽  
Author(s):  
T.T. Chandratilleke ◽  
D. Jagannatha ◽  
R. Narayanaswamy
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Cross Flow ◽  
Synthetic Jets ◽  
Transfer Enhancement

Investigations on the Heat Transfer and Flow Characteristics in a Trapezoid Duct for Turbine Blade Leading Edge

2018 ◽  
Author(s):  
Hai-yong Liu ◽  
Cun-liang Liu ◽  
Lin Ye
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Enhancement ◽  
Cross Flow ◽  
Side Wall ◽  
Swirl Flow ◽  
Transfer Enhancement ◽  
Impingement Cooling ◽  
Exit Side ◽  
Target Wall ◽  
The Cross

To evaluate the application of the impingement cooling in a trapezoidal duct, particularly the influence on internal cooling of the cross flow and swirl flow. Experimental and numerical studies have been performed. The experiment focuses on the heat transfer characteristics in the duct, when the numerical simulation focuses on the flow characteristics. Four Reynolds numbers (10000, 20000, 30000 and 40000), six cross flow mass flow ratios (0, 0.1, 0.2, 0.3, 0.4 and 0.5) and two impingement angle (35° and 45°) are considered in both the experiment and the numerical simulation. The temperature on the target wall and the exit side wall is measured by the thermocouples, when the realizable k-ε turbulence model and enhanced wall treatment are performed using a commercial code Fluent. The results show that only part of the jets contribute in the heat transfer enhancement on the target wall, the other jets improve a large anticlockwise vortex occupied the upper part of the duct and drive strong swirl flow. The heat transfer on the exit side wall is enhanced by the swirl flow. The cross flow is induced in the duct by the outflow of the end exit hole. It deflects the jets and abates the impingement cooling on the target wall in the downstream region but has no evidently effect on the heat transfer on the exit side wall. Higher impingement angle helps to augment the impingement cooling on the target wall and improves the resistance ability of the jets against the effect of the cross flow. The heat transfer enhancement ability on the target wall and exit side wall in the present duct is compared to that of a smooth duct. The Nusselt number of the former is about 3 times higher than that of the latter. It indicates that the impingement and swirl play equally important roles in the heat transfer enhancement in the present duct. Empirical dimensionless correlations based on the present experiment data are presented in the paper.

Heat transfer enhancement using alumina and fly ash nanofluids in parallel and cross-flow concentric tube heat exchangers

2016 ◽  
Vol 89 (3) ◽  
pp. 414-424 ◽  
Author(s):  
Adnan Sözen ◽  
H. İbrahim Variyenli ◽  
M. Bahadır Özdemir ◽  
Metin Gürü ◽  
İpek Aytaç
Keyword(s):  
Heat Transfer ◽  
Fly Ash ◽  
Heat Transfer Enhancement ◽  
Heat Exchangers ◽  
Cross Flow ◽  
Transfer Enhancement

scholarly journals Investigation of the novelty of latent functionally thermal fluids as alternative to nanofluids in natural convective flows

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Zoubida Haddad ◽  
Farida Iachachene ◽  
Eiyad Abu-Nada ◽  
Ioan Pop
Keyword(s):  
Heat Transfer ◽  
Thermal Conductivity ◽  
Heat Transfer Enhancement ◽  
Volume Fraction ◽  
Heat Of Fusion ◽  
Transfer Enhancement ◽  
Maximum Heat ◽  
Thermal Fluids ◽  
Maximum Heat Transfer ◽  
Wide Range

AbstractThis paper presents a detailed comparison between the latent functionally thermal fluids (LFTFs) and nanofluids in terms of heat transfer enhancement. The problem used to carry the comparison is natural convection in a differentially heated cavity where LFTFs and nanofluids are considered the working fluids. The nanofluid mixture consists of Al2O3 nanoparticles and water, whereas the LFTF mixture consists of a suspension of nanoencapsulated phase change material (NEPCMs) in water. The thermophysical properties of the LFTFs are derived from available experimental data in literature. The NEPCMs consist of n-nonadecane as PCM and poly(styrene-co-methacrylic acid) as shell material for the encapsulation. Finite volume method is used to solve the governing equations of the LFTFs and the nanofluid. The computations covered a wide range of Rayleigh number, 104 ≤ Ra ≤ 107, and nanoparticle volume fraction ranging between 0 and 1.69%. It was found that the LFTFs give substantial heat transfer enhancement compared to nanofluids, where the maximum heat transfer enhancement of 13% was observed over nanofluids. Though the thermal conductivity of LFTFs was 15 times smaller than that of the base fluid, a significant enhancement in thermal conductivity was observed. This enhancement was attributed to the high latent heat of fusion of the LFTFs which increased the energy transport within the cavity and accordingly the thermal conductivity of the LFTFs.

Study on A Cross Flow Type of Heat Exchanger : counter flow version with heat transfer enhancement

2004 ◽  
Vol 2004.14 (0) ◽  
pp. 331-334
Author(s):  
Kazuhiko SATO ◽  
Hiroshi KUROTANI ◽  
Himsar Ambarita ◽  
Jun SUZUKI ◽  
Norihiko KAMADA ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Heat Exchanger ◽  
Heat Transfer Enhancement ◽  
Cross Flow ◽  
Transfer Enhancement ◽  
Counter Flow ◽  
Flow Type
Sign in / Sign up

Export Citation Format

Share Document