Gasification of Coal and Dairy Manure With Air-Steam as Oxidizing Agent

Author(s):  
Gerardo Gordillo ◽  
Kalyan Annamalai

The animal waste from feedlots (called feedlot biomass, FB) and dairy farms (called dairy biomass, DB) can contribute to surface or ground water contamination and air pollution problems with the release of greenhouse gases (CH4). In the present study, the feasibility of onsite gasification of DB with an air-steam mixture for production of H2 rich syngas (a mixture of H2 and CO) is considered. The composition of gases produced by DB is predicted using a) mass conservation and b) chemical equilibrium for adiabatic systems where heat produced by partial oxidation is used to strip H2 from steam. Coal is used as standard fuel for comparison of gasification performance of DB with coal. A model is developed to estimate the ideal production of CH4, H2, CO, CO2, N2 and H2S, and other compounds are assumed to be in trace amounts. The parameters investigated are equivalence ratio (1 to 10), air-steam ratio (0.1 to 1), and reaction temperature (600–1500 K). With the predicted composition of gases, the HHV of gas mixtures and the energy conversion efficiency are estimated. The predicted results show that higher ERs yield to elevated concentrations of CO and CH4, high HHV mixtures and energy conversion efficiency, and low percentages of H2 and CO2. On the other hand, lower air-steam ratios produce more H2, CO2, and CH4 but less CO under equilibrium or mass conservation methods. The results suggest that it is possible to obtain concentrations of H2 from 0 to 50%, CO from 0 to 45%, and CH4 from 0 to 45% approximately. The current results provide operational parameters for a gasifier fired with DB and a mixture of air and steam as oxidizers. Experiments are currently in progress to determine the actual composition of gases released from gasifier.

2021 ◽  
Author(s):  
Xianhao Zhao ◽  
Tianyu Tang ◽  
Quan Xie ◽  
like gao ◽  
Limin Lu ◽  
...  

The cesium lead halide perovskites are regarded as effective candidates for light-absorbing materials in solar cells, which have shown excellent performances in experiments such as promising energy conversion efficiency. In...


2017 ◽  
Vol 46 (18) ◽  
pp. 5872-5879 ◽  
Author(s):  
Mandvi Saxena ◽  
Tanmoy Maiti

Increasing electrical conductivity in oxides, which are inherently insulators, can be a potential route in developing oxide-based thermoelectric power generators with higher energy conversion efficiency.


Author(s):  
Robson L. Silva ◽  
Bruno V. Sant′Ana ◽  
José R. Patelli ◽  
Marcelo M. Vieira

This paper aims to identify performance improvements in cooker-top gas burners for changes in its original geometry, with aspect ratios (ARs) ranging from 0.25 to 0.56 and from 0.28 to 0.64. It operates on liquefied petroleum gas (LPG) and five thermal power (TP) levels. Considering the large number of cooker-top burners currently being used, even slight improvements in thermal performance resulting from a better design and recommended operating condition will lead to a significant reduction of energy consumption and costs. Appropriate instrumentation was used to carry out the measurements and methodology applied was based on regulations from INMETRO (CONPET program for energy conversion efficiency in cook top and kilns), ABNT (Brazilian Technical Standards Normative) and ANP—National Agency of Petroleum, Natural Gas (NG) and Biofuels. The results allow subsidizing recommendations to minimum energy performance standards (MEPS) for residential use, providing also higher energy conversion efficiency and/or lower fuel consumption. Main conclusions are: (i) Smaller aspect ratios result in the same heating capacity and higher efficiency; (ii) higher aspect ratios (original burners) are fuel consuming and inefficient; (iii) operating conditions set on intermediate are lower fuel consumption without significant differences in temperature increases; (iv) Reynolds number lower than 500 provides higher efficiencies.


2008 ◽  
Vol 78 (4) ◽  
Author(s):  
Y. Nodera ◽  
S. Kawata ◽  
N. Onuma ◽  
J. Limpouch ◽  
O. Klimo ◽  
...  

RSC Advances ◽  
2016 ◽  
Vol 6 (87) ◽  
pp. 83802-83807 ◽  
Author(s):  
Yu Hou ◽  
Shuang Yang ◽  
Chunzhong Li ◽  
Huijun Zhao ◽  
Hua Gui Yang

An energy conversion efficiency of 8.31% is reached by using a cemented photoanode for dye-sensitized solar cells, attaining a 31.1% improvement over the standard Degussa P25 sample.


Sign in / Sign up

Export Citation Format

Share Document