Time-Domain Analysis of Wind-Induced Response of a Suspension Bridge in Comparison With the Full-Scale Measurements

2017 ◽  
Author(s):  
Jungao Wang ◽  
Etienne Cheynet ◽  
Jasna Bogunović Jakobsen ◽  
Jónas Snæbjörnsson
Keyword(s):  
Standard Deviation ◽  
Time Domain ◽  
Measurement Data ◽  
Suspension Bridge ◽  
Time Domain Analysis ◽  
Domain Analysis ◽  
Full Scale ◽  
Buffeting Response ◽  
Non Linear ◽  
The Time Domain

The present study compares the buffeting response of a suspension bridge computed in the time-domain with full-scale measurement data. The in-service Lysefjord Bridge is used as a study case, which allows a unique comparison of the computational results with full-scale buffeting bridge response observed during a one year monitoring period. The time-domain analysis is performed using a finite element approach. Turbulent wind field is simulated according to the governing bridge design standard in Norway for three different terrain categories. The time-domain analysis indicates that the non-linear components of the wind loading are of limited importance in the present case, contributing by less than 5% to the standard deviation of the lateral displacement. The contribution of the buffeting loads on the main cables, hangers and towers to the lateral dynamic response of the bridge girder is about 6%. With the time-domain method, mode coupling as well as the influence of cables and towers are well captured in the simulation results. The buffeting response, estimated in terms of the standard deviation of acceleration, is found to be in good agreement with the field measurement data. Comparison suggests that the proposed numerical method, with the non-linear force model, is able to predict the bridge response reasonably well.

Comparison of Time and Frequency Domain Analysis With Full Scale Data for the Horn Mountain Spar During Hurricane Isidore

2006 ◽  
Author(s):  
Arcandra Tahar ◽  
John Halkyard ◽  
Mehernosh Irani
Keyword(s):  
Frequency Domain ◽  
Time Domain ◽  
Time Domain Analysis ◽  
Domain Analysis ◽  
Frequency Domain Analysis ◽  
Full Scale ◽  
Frequency Domain Method ◽  
Drag Forces ◽  
The Time Domain ◽  
Scale Data

The Horn Mountain Spar is located in 1,654 m of water about 135 km from Venice, Louisiana in the Gulf of Mexico. The facility was instrumented extensively to measure key spar and riser response parameters (Edwards et. al. 2003). Halkyard et. al. (2004) and Tahar et. al. (2005) have compared measured spar responses such as motion and mooring line tensions with numerical predictions. This paper extends the work done on comparison of the full scale data during hurricane Isidore. All previous numerical simulations were based on a time domain analysis procedure. One concern related to this method is that it is computationally intensive and time consuming. In the initial stages of a project, a frequency domain solution may be an effective tool compared with a fully coupled time domain analysis. The present paper compares results of time domain and frequency domain simulations with field measurements. Particular attention has been placed on the importance of the phase relationship between motion and excitation force. In the time domain analysis, nonlinear drag forces are applied at the instantaneous position. Whereas in the frequency domain analysis, nonlinear drag forces are stochastically linearized and solutions are obtained by an iterative procedure. The time domain analysis has better agreement with the field data compared to the frequency domain. Overall, however, the frequency domain method is still promising for a quick and approximate estimation of relevant statistics. With advantages in terms of CPU time, the frequency domain method can be recommended as a tool in pre-front end engineering design or in a phase where an iterative nature of design of an offshore structure takes place.

Concrete Modeling for Extreme Wave Slam Events

2017 ◽  
Author(s):  
Kasper Wåsjø ◽  
Terje P. Stavang ◽  
Tore H. Søreide
Keyword(s):  
Time Domain ◽  
Linear Time ◽  
Limit State ◽  
Material Model ◽  
Time Domain Analysis ◽  
Domain Analysis ◽  
Capacity Control ◽  
Extreme Wave ◽  
Conventional Design ◽  
Non Linear

Experience from model tests has initiated a growing attention towards extreme wave slam as a critical load situation for offshore large volume structures. Most of the problem is related to the local slam pressure, which may go up to several MPa’s for 100-year and 10 000-year waves. The paper deals with modeling techniques for marine concrete structures under extreme slam loading from waves where dynamic effects together with material softening play a major role for the response. Different analysis approaches for ultimate limit state (ULS) and accidental limit state (ALS) controls are discussed in view of reliability philosophy as basis for conventional design approach. The present paper is devoted to the local impact scenario and the alternative approaches for response and capacity control involving non-linear time domain analyses. Conventional design schemes as based on linear elastic models for response calculation together with code specified capacity control often come out more conservative than non-linear approach. The paper demonstrates by case studies how softening of the structure in general reduces the response in terms of section forces. A key issue when going from conventional linear approaches into non-linear techniques is to still keep an acceptable reliability level on the capacity control. Load and material factors are normally based on structures with limited non-linearity where linear response modeling is representative. Implementing non-linear material model in time domain analysis has a major challenge in limiting the sensitivity in response and capacity calculation. The paper demonstrates the way material model of concrete affects the section forces to go into local capacity control, and concludes on needed sensitivity analyses. Practical approaches on the concrete slam problem together with resulting utilizations from the control are demonstrated. The full non-linear technique by response and capacity control in one analysis is also handled, using average material parameters and justifying safety factors for the effect of implementing characteristic lower strength of concrete in the capacity. The paper ends up in a recommendation on non-linear time domain analysis procedure for typically slam problems. A discussion is also given on applicable design codes with attention to non-linear analysis.

Numerical Simulation on Mooring Performance of LNG-FPSO System in Realistic Seas

2005 ◽  
Author(s):  
Yoshiyuki Inoue ◽  
Md. Kamruzzaman
Keyword(s):  
Time Domain ◽  
Oil And Gas ◽  
Three Dimensional ◽  
Time Domain Analysis ◽  
Analysis Tool ◽  
Motion Response ◽  
Non Linear ◽  
Floating System ◽  
Exciting Forces ◽  
The Time Domain

The LNG-FPSO concept is receiving much attention in recent years, due to its active usage to exploit oil and gas resources. The FPSO offloads LNG to an LNG carrier that is located close to the FPSO, and during this transfer process two large vessels are in close proximity to each other for daylong periods of time. Due to the presence of neighboring vessel, the motion response of both the vessels will be affected significantly. Hydrodynamic interactions related to wave effects may result in unfavorable responses or the risk of collisions in a multi-body floating system. Not only the motion behavior but also the second order drift forces are influenced by the neighboring structures due to interactions of the waves among the structures. A study is made on the time domain analysis to assess the behavior and the operational capability of the FPSO system moored in the sea having an LNG carrier alongside under environmental conditions such as waves, wind and currents. This paper presents an analysis tool to predict the dynamic motion response and non-linear connecting and mooring forces on a parallel-connected LNG-FPSO system due to non-linear exciting forces of wave, wind and current. Simulation for the mooring performance is also investigated. The three-dimensional source-sink technique has been applied to obtain the radiation forces and the transfer function of wave exciting forces on floating multi-bodies. The hydrodynamic interaction effect between the FPSO and the LNG carrier is included to calculate the hydrodynamic forces. For the simulation of a random sea and also for the generation of time depended wind velocity, a fully probabilistic simulation technique has been applied. Wind and current loads are estimated according to OCIMF. The effects of variations in wave, wind and current loads and direction on the slowly varying oscillations of the LNG and FPSO are also investigated in this paper. Finally, some conclusions are drawn based on the numerical results obtained from the present time domain simulations.

On the Parallelization of a Harmonic Balance Compressible Navier-Stokes Solver for Wind Turbine Aerodynamics

2011 ◽  
Author(s):  
Adrian Jackson ◽  
M. Sergio Campobasso ◽  
Mohammad H. Baba-Ahmadi
Keyword(s):  
Flow Field ◽  
Domain Decomposition ◽  
Wind Turbine ◽  
Time Domain ◽  
Harmonic Balance ◽  
Unsteady Aerodynamics ◽  
Time Domain Analysis ◽  
Domain Analysis ◽  
Navier Stokes ◽  
The Time Domain

The paper discusses the parallelization of a novel explicit harmonic balance Navier-Stokes solver for wind turbine unsteady aerodynamics. For large three-dimensional problems, the use of a standard MPI parallelization based on the geometric domain decomposition of the physical domain may require an excessive degree of partitioning with respect to that needed when the same aerodynamic analysis is performed with the time-domain solver. This occurrence may penalize the parallel efficiency of the harmonic balance solver due to excessive communication among MPI processes to transfer halo data. In the case of the harmonic balance analysis, the necessity of further grid partitioning may arise because the memory requirement of each block is higher than for the time-domain analysis: it is that of the time-domain analysis multiplied by a variable proportional to the number of complex harmonics used to represent the sought periodic flow field. A hybrid multi-level parallelization paradigm for explicit harmonic balance Navier-Stokes solvers is presented, which makes use of both distributed and shared memory parallelization technologies, and removes the need for further domain decomposition with respect to the case of the time-domain analysis. The discussed parallelization approaches are tested on the multigrid harmonic balance solver being developed by the authors, considering various computational configurations for the CFD analysis of the unsteady flow field past the airfoil of a wind tubine blade in yawed wind.

Sign in / Sign up

Export Citation Format

Share Document