Simulation of liquid transfer between the plate and the groove

2020 ◽  
Vol 34 (30) ◽  
pp. 2050331
Author(s):  
Nan Zhou ◽  
Jiayi Zhao ◽  
Shuo Chen ◽  
Yang Liu ◽  
Kaixuan Zhang
Keyword(s):  
Transfer Rate ◽  
Dissipative Particle Dynamics ◽  
Surface Wettability ◽  
Breakup Process ◽  
Many Body ◽  
The Core ◽  
Groove Structure ◽  
Liquid Transfer ◽  
Core Problem ◽  
Dynamics Method

The transfer of the liquid from groove to plate is significantly affected by the breakup process of liquid bridge, which is the core problem of gravure. In this paper, many-body dissipative particle dynamics method (MDPD) is used to simulate the behaviors of the stretching liquid cylinder between the plate and the groove, and the influence of surface wettability, stretching velocity and groove structure on the liquid cylinder rupture and the transfer rate of liquid are studied. The results show that both of the slipping velocity of the contact line on the plate and the thinning velocity of the liquid cylinder determine the breakup state of the liquid bridges and the liquid transfer rate from the groove to the plate. In the cases with the same surface wettability, at high hydrophilicity surface, the transfer rate increases firstly and then decreases with the increase of the stretching velocity. In the cases with different surface wettability of the plate and the groove, reducing the stretching velocity and the inclination angle of the groove are helpful to pull the liquid out of the groove and increase the transfer rate, and it could also be achieved by increasing the wettability of the plate and decreasing the wettability of the groove. This study provides some new insights into the effects of surface wettability, stretching velocity and groove structure on the dynamics of breakup process and liquid transfer in stretching.

ELECTROWETTING-INDUCED DROPLET JUMPING SIMULATION USING MANY-BODY DISSIPATIVE PARTICLE DYNAMICS

2019 ◽  
Author(s):  
Ting Liu ◽  
Anupam Mishra ◽  
Mohsen Torabi ◽  
Ahmed A. Hemeda ◽  
James Palko ◽  
...  
Keyword(s):  
Dissipative Particle Dynamics ◽  
Particle Dynamics ◽  
Many Body

In a word, I’ve been there

2019 ◽  
pp. 246-256
Author(s):  
A. K. Zholkovsky
Keyword(s):  
The State ◽  
Female Characters ◽  
Political Situation ◽  
The Core ◽  
The Relationship ◽  
Core Problem ◽  
Typical Solution

In his article, A. Zholkovsky discusses the contemporary detective mini-series Otlichnitsa [A Straight-A Student], which mentions O. Mandelstam’s poem for children A Galosh [Kalosha]: more than a fleeting mention, this poem prompts the characters and viewers alike to solve the mystery of its authorship. According to the show’s plot, the fact that Mandelstam penned the poem surfaces when one of the female characters confesses her involvement in his arrest. Examining this episode, Zholkovsky seeks structural parallels with the show in V. Aksyonov’s Overstocked Packaging Barrels [Zatovarennaya bochkotara] and even in B. Pasternak’s Doctor Zhivago [Doktor Zhivago]: in each of those, a member of the Soviet intelligentsia who has developed a real fascination with some unique but unattainable object is shocked to realize that the establishment have long enjoyed this exotic object without restrictions. We observe, therefore, a typical solution to the core problem of the Soviet, and more broadly, Russian cultural-political situation: the relationship between the intelligentsia and the state, and the resolution is not a confrontation, but reconciliation.

Many-body dissipative particle dynamics study of the local slippage over superhydrophobic surfaces

2021 ◽  
Vol 33 (7) ◽  
pp. 072001
Author(s):  
Liuzhen Ren ◽  
Haibao Hu ◽  
Luyao Bao ◽  
Mengzhuo Zhang ◽  
Jun Wen ◽  
...  
Keyword(s):  
Dissipative Particle Dynamics ◽  
Particle Dynamics ◽  
Superhydrophobic Surfaces ◽  
Many Body ◽  
Local Slippage

scholarly journals Solubilization of Charged Porphyrins in Interpolyelectrolyte Complexes: A Computer Study

Polymers ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 502
Author(s):  
Karel Šindelka ◽  
Zuzana Limpouchová ◽  
Karel Procházka
Keyword(s):  
Dissipative Particle Dynamics ◽  
Water Soluble ◽  
Coarse Grained ◽  
Core Shell ◽  
Computer Study ◽  
Interpolyelectrolyte Complex ◽  
The Core ◽  
Porphyrin Derivatives ◽  
Oppositely Charged ◽  
Positively Charged

Using coarse-grained dissipative particle dynamics (DPD) with explicit electrostatics, we performed (i) an extensive series of simulations of the electrostatic co-assembly of asymmetric oppositely charged copolymers composed of one (either positively or negatively charged) polyelectrolyte (PE) block A and one water-soluble block B and (ii) studied the solubilization of positively charged porphyrin derivatives (P+) in the interpolyelectrolyte complex (IPEC) cores of co-assembled nanoparticles. We studied the stoichiometric mixtures of 137 A10+B25 and 137 A10−B25 chains with moderately hydrophobic A blocks (DPD interaction parameter aAS=35) and hydrophilic B blocks (aBS=25) with 10 to 120 P+ added (aPS=39). The P+ interactions with other components were set to match literature information on their limited solubility and aggregation behavior. The study shows that the moderately soluble P+ molecules easily solubilize in IPEC cores, where they partly replace PE+ and electrostatically crosslink PE− blocks. As the large P+ rings are apt to aggregate, P+ molecules aggregate in IPEC cores. The aggregation, which starts at very low loadings, is promoted by increasing the number of P+ in the mixture. The positively charged copolymers repelled from the central part of IPEC core partially concentrate at the core-shell interface and partially escape into bulk solvent depending on the amount of P+ in the mixture and on their association number, AS. If AS is lower than the ensemble average ⟨AS⟩n, the copolymer chains released from IPEC preferentially concentrate at the core-shell interface, thus increasing AS, which approaches ⟨AS⟩n. If AS>⟨AS⟩n, they escape into the bulk solvent.

A Many-Body Dissipative Particle Dynamics Study of Forced Water–Oil Displacement in Capillary

Langmuir ◽  
2011 ◽  
Vol 28 (2) ◽  
pp. 1330-1336 ◽  
Author(s):  
Chen Chen ◽  
Lin Zhuang ◽  
Xuefeng Li ◽  
Jinfeng Dong ◽  
Juntao Lu
Keyword(s):  
Dissipative Particle Dynamics ◽  
Particle Dynamics ◽  
Many Body ◽  
Oil Displacement

PERANCANGAN IDENTITAS VISUAL REBRANDING CITRA PERUSAHAAN CEMARA CERAMICS (DESIGN OF CEMARA CERAMICS VISUAL REBRANDING IDENTITY)

2021 ◽  
Vol 4 (1) ◽  
pp. 1
Author(s):  
Anak Agung Ngurah Gede Marhendra ◽  
Agung Eko Budiwaspada ◽  
Sangayu Ketut Laksemi Nilotama
Keyword(s):  
Design Thinking ◽  
Corporate Identity ◽  
Corporate Image ◽  
Visual Design ◽  
Stage Design ◽  
The Core ◽  
Visual Identity ◽  
The Creation ◽  
Strategy Design ◽  
Core Problem

<p>Abstract Design of Cemara Ceramics Visual Rebranding Identity aims to produce a concept strategy and visual rebranding of the Cemara Ceramics company and produce a Cemara Ceramics rebranding visual identity design in order to encourage the creation of a new identity image. The method in this design uses a 5-stage Design Thinking approach, namely Empathize, Define, Ideate, Prototype and Test. The result achieved is the design of the new Cemara Ceramics corporate identity. With the use of the design thinking method in this research, various problems related to the company image of Cemara Ceramics can be found. The core problem obtained is how to design a strategy and concept of visual identity rebranding to encourage the creation of a new corporate image of Cemara Ceramics.</p><p>Keywords: visual rebranding identity, concept strategy, design thinking</p><p>Abstrak Perancangan Identitas Visual Rebranding Citra Perusahaan Cemara Ceramics ini bertujuan untuk menghasilkan strategi konsep dan visual rebranding perusahaan Cemara Ceramics serta menghasilkan rancangan identitas visual rebranding Cemara Ceramics dalam rangka mendorong terciptanya citra identitas yang baru. Metode dalam perancangan ini menggunakan pendekatan 5 tahapan Design Thinking yaitu Empathize, Define, Ideate, Prototype dan Test. Hasil yang dicapai yaitu rancangan corporate identity Cemara Ceramics yang baru. Dengan adanya penggunaan metode design thinking pada penelitian ini dapat menemukan berbagai permasalahan terkait citra perusahaan Cemara Ceramics. Permasalahan inti yang didapat yaitu mengenai bagaimana merancang strategi dan konsep identitas visual rebranding untuk mendorong terciptanya citra baru perusahaan Cemara Ceramics.</p><p>Kata kunci: identitas visual rebranding, strategi konsep dan visual, design thinking</p>

A Many-Body Dissipative Particle Dynamics Study of Spontaneous Capillary Imbibition and Drainage

Langmuir ◽  
2010 ◽  
Vol 26 (12) ◽  
pp. 9533-9538 ◽  
Author(s):  
Chen Chen ◽  
Chunning Gao ◽  
Lin Zhuang ◽  
Xuefeng Li ◽  
Pingcang Wu ◽  
...  
Keyword(s):  
Dissipative Particle Dynamics ◽  
Particle Dynamics ◽  
Many Body ◽  
Capillary Imbibition
Sign in / Sign up

Export Citation Format

Share Document