MODULUS REDUCTION AND DAMPING CURVES FOR SAND OF SOUTH-EAST COAST OF INDIA

2012 ◽  
Vol 06 (04) ◽  
pp. 1250016
Author(s):  
V. JAYA ◽  
G. R. DODAGOUDAR ◽  
A. BOOMINATHAN
Keyword(s):  
Shear Modulus ◽  
Triaxial Test ◽  
Damping Ratio ◽  
Triaxial Tests ◽  
Hyperbolic Model ◽  
Cyclic Triaxial Test ◽  
Cyclic Triaxial ◽  
Wide Range ◽  
Predictive Relationships ◽  
Modulus Reduction

Adequate information on dynamic soil properties, especially strain dependent shear modulus (G) and damping ratio (ξ) for each soil layer are the essential input data for seismic ground response analysis and soil-structure interaction studies. In the present study, the shear modulus and damping ratio of sand are estimated for a wide range of strains based on undrained strain-controlled cyclic triaxial tests. The bender elements are also utilized in the cyclic triaxial test to estimate the low strain shear modulus. For this purpose, the soil samples are taken from a nuclear power plant site located at the south-east coastal region of India. Based on the experimental results, an empirical expression is developed to calculate the maximum shear modulus, G max as function of void ratio and effective confining stress. Predictive relationships are also developed for estimating normalized shear modulus and damping ratio curves for the sand. The predictive relationships are based on the hyperbolic model and cyclic triaxial test results. The developed modulus reduction and damping ratio curves from the predictive relationships are compared with the previously available curves in the literature.

The Mexico Earthquake of September 19, 1985—General Soil Conditions and Clay Properties in the Valley of Mexico

1988 ◽  
Vol 4 (4) ◽  
pp. 731-752 ◽  
Author(s):  
M. P. Romo ◽  
A. Jaime ◽  
D. Reséndiz
Keyword(s):  
Shear Modulus ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Damping Ratio ◽  
Free Field ◽  
Elastic Behavior ◽  
Triaxial Tests ◽  
Soil Conditions ◽  
Hyperbolic Model ◽  
Lake Zone

We present and discuss the results of resonant column and cyclic triaxial tests on clay samples obtained from different sites within the Lake zone in the Valley of Mexico. Of particular interest are the nearly elastic behavior and low damping ratio even for shear strain amplitudes as high as 0.3 (%). A hyperbolic model reproduces adequately well the resulting shear modulus vs strain curves. Degradation of shear modulus caused by load repetition is negligible for strains lower than about 1 (%) but increases significantly for higher strains. A power-type expression fits well the modulus degradation vs number of cycles curves. Results from static triaxial tests indicate that for compression stress paths the induced pore water pressure is uniquely related to axial strains. Analyses of ground motions show that one dimensional wave propagation models may be used to predict free field seismic motions in most parts of the Lake zone.

scholarly journals Shear modulus and damping ratio of a nonplastic silt at large shear strains

2019 ◽  
Vol 92 ◽  
pp. 08007
Author(s):  
Alper Sezer ◽  
Eyyub Karakan ◽  
Nazar Tanrinian
Keyword(s):  
Shear Modulus ◽  
Relative Density ◽  
Shear Strain ◽  
Stress Ratio ◽  
Damping Ratio ◽  
Cyclic Stress ◽  
Triaxial Tests ◽  
Cyclic Triaxial ◽  
Cyclic Triaxial Tests ◽  
Cyclic Stress Ratio

Site response analyses and solution of dynamic soil-structure interaction problems need determination of variation of shear modulus and damping ratio with shear strain. Since many studies in literature concern evaluation of behavior of sands and silty sands, a series of cyclic triaxial tests were performed to determine the variation of shear modulus and damping ratio of a nonplastic silt with shear strain. Stress controlled cyclic triaxial tests on silt specimens of initial relative densities ranging among 30%, 50% and 70% were performed. Tests were carried out on identical samples under different CSR levels, and the confining pressure was selected as 100 kPa. Variation of shear modulus and damping ratio of silts with cyclic stress ratio amplitude, relative density and number of cycles were investigated. It was understood that soil relative density and cyclic stress ratio amplitude has a significant influence on shear modulus and damping ratio of silts. It was also observed that, as the cyclic stress ratio amplitude is increased, greater shear modulus and lower damping ratio values were obtained.

Shear modulus reduction and damping ratio curves for earth core materials of dams

2019 ◽  
Vol 56 (1) ◽  
pp. 14-22 ◽  
Author(s):  
DongSoon Park ◽  
Tadahiro Kishida
Keyword(s):  
Shear Modulus ◽  
Dynamic Properties ◽  
Damping Ratio ◽  
Empirical Relationship ◽  
Embankment Dams ◽  
In Situ Data ◽  
Earth Core ◽  
Dynamic Analyses ◽  
Modulus Reduction ◽  
Core Materials

It is essential to obtain shear modulus reduction and damping ratio curves to perform dynamic analyses of earth-cored embankment dams. Many studies have been performed for dynamic properties of clayey soils, but they have been limited for earth core materials of dams. This study conducted resonant column tests to obtain shear modulus reduction (G/Gmax) and damping ratio (D) curves for 31 specimens (17 undisturbed and 14 remolded specimens) from 13 earth-cored embankment dams. Empirical G/Gmax and D curves are proposed for dynamic properties of clayey earth core materials. Fitting curves are provided by using the functional forms of the Ramberg–Osgood and Darendeli models. The observation shows that the undisturbed earth cores yield relatively higher G/Gmax and lower D curves than the remolded cores. G/Gmax curves of compacted earth cores are relatively higher than those of Vucetic and Dobry curves for a similar level of plasticity index. Uncertainty and bias are calculated by performing residual analysis, which shows that there is no clear bias in predicting G/Gmax and the uncertainties between undisturbed earth core materials and natural deposits are at a similar level. A proposed empirical relationship of G/Gmax and D curves for earth core materials can be utilized for dynamic analyses of embankment dams for cases where there is insufficient in situ data.

Shear modulus and damping of soft Bangkok clays

2002 ◽  
Vol 39 (5) ◽  
pp. 1201-1208 ◽  
Author(s):  
Supot Teachavorasinskun ◽  
Pipat Thongchim ◽  
Panitan Lukkunaprasit
Keyword(s):  
Shear Modulus ◽  
Seismic Analysis ◽  
Damping Ratio ◽  
Soft Clay ◽  
Cyclic Stress ◽  
Large Strains ◽  
Cyclic Triaxial ◽  
Stress History ◽  
Load Frequency ◽  
Equivalent Shear Modulus

The shear modulus and damping ratio of undisturbed Bangkok clay samples were measured using a cyclic triaxial apparatus. Although abundant literature on this topic exists, selection of the most suitable empirical correlation for a seismic analysis cannot be done unless site specific data are obtained. The apparatus used in this research can measure the stress–strain relationships from strain levels of about 0.01%. The equivalent shear modulus measured at these strains was about 80% of the value obtained from the shear wave velocity measurements. The degradation curves of the equivalent shear modulus fell into the ranges reported in the literature, for clay having similar plasticity. The damping ratios varied from about 4–5% at small strains (0.01%) to about 25–30% at large strains (10%). The effects of load frequency and cyclic stress history on the shear modulus and damping ratio were also investigated. An increase in load frequency from 0.1 to 1.0 Hz had no influence on the shear modulus characteristic, but it did result in a slight decrease in the damping ratio. The effects of the small amplitude cyclic stress history on the subsequently measured shear modulus and damping ratio were almost negligible when the changes in void ratio were taken into account.Key words: soft clay, shear modulus, damping ratio, cyclic triaxial test, cyclic stress history.

DEGRADATION EFFECT OF SEAWATER ON THE LONG-TERM DYNAMIC BEHAVIOR OF ARTIFICIALLY CEMENTED SAND

2013 ◽  
Vol 07 (04) ◽  
pp. 1350031 ◽  
Author(s):  
BO LI ◽  
YUANQIANG CAI ◽  
XIANGWU ZENG ◽  
LINYOU PAN
Keyword(s):  
Shear Modulus ◽  
Dynamic Behavior ◽  
Tap Water ◽  
Damping Ratio ◽  
Confining Pressure ◽  
Triaxial Tests ◽  
Resonant Column ◽  
Cyclic Triaxial Tests ◽  
Cemented Sand

The dynamic behavior of lightly cemented sand under long-term seawater attack was evaluated in this study. Resonant column and cyclic triaxial tests were employed to investigate the evolution of the shear modulus and damping ratio of cemented sand with respect to soaking period (SP), confining pressure, and cement content (CC). The results of this study show that the cementation of the sand is affected by soaking in seawater to a greater extent than by soaking in tap water. The shear modulus of the cemented sand soaked in seawater was smaller than that of the cemented sand soaked in tap water. The damping ratio increased significantly, as the SP increased and was greater for the cemented sand soaked in seawater than for the cemented sand soaked in tap water. The dynamic behavior of nonhomogenous specimens was examined. Crystallization of salts could be clearly observed and probably explains the evolution of the dynamic behavior of the cemented sand. Finally, the shear modulus was fitted using Rollins' Law [Rollins et al., 1998], which demonstrates that the parameters used in the equation can be reasonably fitted linearly over a range of SPs.

Sign in / Sign up

Export Citation Format

Share Document