Surface Contamination with Si and O Impurities for GaN Single-Crystalline Layers Grown by Ultra-High-Vacuum Sputter Epitaxy

2019 ◽  
Keyword(s):  
High Vacuum ◽  
Surface Contamination ◽  
Ultra High Vacuum ◽  
Single Crystalline

Temporal Evolution of Surface Contamination under Ultra-high Vacuum

Langmuir ◽  
2022 ◽  
Author(s):  
Zhen Liu ◽  
Youngsup Song ◽  
Anoop Rajappan ◽  
Evelyn N. Wang ◽  
Daniel J. Preston
Keyword(s):  
Temporal Evolution ◽  
High Vacuum ◽  
Surface Contamination ◽  
Ultra High Vacuum

Surface Smoothing upon Deposition of Nanoparticles on Single Crystalline Substrates

1999 ◽  
Vol 585 ◽  
Author(s):  
C. G. Zimmermann ◽  
C. P. Liu ◽  
M. Yeadon ◽  
K. Nordlund ◽  
J. M. Gibson ◽  
...  
Keyword(s):  
Surface Energy ◽  
High Vacuum ◽  
Strain Analysis ◽  
Lower Surface ◽  
Ultra High Vacuum ◽  
Heat Of Mixing ◽  
Single Crystalline ◽  
Transmission Electron ◽  
The Difference ◽  
Average Size

AbstractSurfaces with artificial roughness were generated by deposition of nanoparticles on single crystalline substrates. Nanoparticles with an average size ≈ 15 nm were produced by inert gas condensation and deposited in situ on the substrate mounted inside a modified ultra high vacuum (UHV) transmission electron microscope (TEM). We have investigated the smoothing behavior on annealing based on the difference in surface energies between cluster and substrate and their heat of mixing. The cluster substrate combination Co/Cu(100) was chosen as a model system in which the cluster has a significantly higher surface energy than the substrate. Upon deposition at 600 K, the clusters do not remain on the surface, but rather burrow into the substrate. This is confirmed by a detailed strain analysis of the particles. Nanoparticles in the system Ge/Si(100) in contrast have a lower surface energy than the substrate and are completely miscible. The particles assume the substrate orientation around 700 K. At 900 K coherent islands form which are arranged in clusters of 4 in the form of a square. The reason for this previously unobserved pattern is not yet understood.

Thin Pyrolytic Graphite Films for Electron Microscope Substrates

1971 ◽  
Vol 29 ◽  
pp. 226-227 ◽  
Author(s):  
George H. N. Riddle ◽  
Benjamin M. Siegel
Keyword(s):  
Vacuum Chamber ◽  
Pyrolytic Graphite ◽  
High Vacuum ◽  
Dark Field ◽  
Ultra High Vacuum ◽  
Graphite Substrate ◽  
Nickel Substrate ◽  
Routine Procedure ◽  
Field Electron Microscopy ◽  
Dark Field Electron

A routine procedure for growing very thin graphite substrate films has been developed. The films are grown pyrolytically in an ultra-high vacuum chamber by exposing (111) epitaxial nickel films to carbon monoxide gas. The nickel serves as a catalyst for the disproportionation of CO through the reaction 2C0 → C + CO2. The nickel catalyst is prepared by evaporation onto artificial mica at 400°C and annealing for 1/2 hour at 600°C in vacuum. Exposure of the annealed nickel to 1 torr CO for 3 hours at 500°C results in the growth of very thin continuous graphite films. The graphite is stripped from its nickel substrate in acid and mounted on holey formvar support films for use as specimen substrates.The graphite films, self-supporting over formvar holes up to five microns in diameter, have been studied by bright and dark field electron microscopy, by electron diffraction, and have been shadowed to reveal their topography and thickness. The films consist of individual crystallites typically a micron across with their basal planes parallel to the surface but oriented in different, apparently random directions about the normal to the basal plane.

A High Voltage Electron Microscopy Study of Sub-Oxide Formation in Vanadium

1971 ◽  
Vol 29 ◽  
pp. 212-213
Author(s):  
R. H. Geiss ◽  
R. L. Ladd ◽  
K. R. Lawless
Keyword(s):  
High Vacuum ◽  
Microscopy Study ◽  
Electron Microscopy Study ◽  
Ultra High Vacuum ◽  
Pure Oxygen ◽  
Pressure Oxidation ◽  
High Voltage Electron Microscopy ◽  
Oxidation Study ◽  
Voltage Electron ◽  
Good Agreement

Detailed electron microscope and diffraction studies of the sub-oxides of vanadium have been reported by Cambini and co-workers, and an oxidation study, possibly complicated by carbon and/or nitrogen, has been published by Edington and Smallman. The results reported by these different authors are not in good agreement. For this study, high purity polycrystalline vanadium samples were electrochemically thinned in a dual jet polisher using a solution of 20% H2SO4, 80% CH3OH, and then oxidized in an ion-pumped ultra-high vacuum reactor system using spectroscopically pure oxygen. Samples were oxidized at 350°C and 100μ oxygen pressure for periods of 30,60,90 and 160 minutes. Since our primary interest is in the mechanism of the low pressure oxidation process, the oxidized samples were cooled rapidly and not homogenized. The specimens were then examined in the HVEM at voltages up to 500 kV, the higher voltages being necessary to examine thick sections for which the oxidation behavior was more characteristic of the bulk.

The High Resolution Scanning Transmission Electron Microscope

1974 ◽  
Vol 32 ◽  
pp. 316-317
Author(s):  
A. V. Crewe
Keyword(s):  
Electron Microscope ◽  
High Resolution ◽  
High Vacuum ◽  
Scanning Transmission Electron Microscope ◽  
Ultra High Vacuum ◽  
Resolving Power ◽  
Imaging Characteristics ◽  
Transmission Electron ◽  
Scanning Transmission ◽  
The Moment

The high resolution STEM is now a fact of life. I think that we have, in the last few years, demonstrated that this instrument is capable of the same resolving power as a CEM but is sufficiently different in its imaging characteristics to offer some real advantages.It seems possible to prove in a quite general way that only a field emission source can give adequate intensity for the highest resolution^ and at the moment this means operating at ultra high vacuum levels. Our experience, however, is that neither the source nor the vacuum are difficult to manage and indeed are simpler than many other systems and substantially trouble-free.

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

1970 ◽  
Vol 28 ◽  
pp. 456-457
Author(s):  
L. E. Murr ◽  
G. Wong
Keyword(s):  
Single Crystal ◽  
High Vacuum ◽  
Ultra High Vacuum ◽  
High Rate ◽  
Flash Evaporation ◽  
Optimum Load ◽  
Single Crystal Films ◽  
Crystal Films ◽  
A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

A Field Emission System For Transmission Electron Microscopy

1973 ◽  
Vol 31 ◽  
pp. 298-299
Author(s):  
Michel Troyonal ◽  
Huei Pei Kuoal ◽  
Benjamin M. Siegelal
Keyword(s):  
Electron Microscope ◽  
Field Emission ◽  
Optical System ◽  
High Vacuum ◽  
Ultra High Vacuum ◽  
Objective Lens ◽  
Electron Optical System ◽  
Cross Sectional ◽  
Transmission Electron ◽  
Emission System

A field emission system for our experimental ultra high vacuum electron microscope has been designed, constructed and tested. The electron optical system is based on the prototype whose performance has already been reported. A cross-sectional schematic illustrating the field emission source, preaccelerator lens and accelerator is given in Fig. 1. This field emission system is designed to be used with an electron microscope operated at 100-150kV in the conventional transmission mode. The electron optical system used to control the imaging of the field emission beam on the specimen consists of a weak condenser lens and the pre-field of a strong objective lens. The pre-accelerator lens is an einzel lens and is operated together with the accelerator in the constant angular magnification mode (CAM).

Sign in / Sign up

Export Citation Format

Share Document