Self-Assembled Gold Nanoparticle Cluster Array Onto Seeded Optical Fiber for Chemical Sensors

2020 ◽  
Vol MA2020-01 (33) ◽  
pp. 2356-2356
Author(s):  
Nerea De Acha ◽  
Diego López-Torres ◽  
Arantzazu Delgado-Camón ◽  
Víctor Elía-Lorente ◽  
César Elosúa ◽  
...  
2021 ◽  
Vol 11 (7) ◽  
pp. 3254
Author(s):  
Marco Pisco ◽  
Francesco Galeotti

The realization of advanced optical fiber probes demands the integration of materials and structures on optical fibers with micro- and nanoscale definition. Although researchers often choose complex nanofabrication tools to implement their designs, the migration from proof-of-principle devices to mass production lab-on-fiber devices requires the development of sustainable and reliable technology for cost-effective production. To make it possible, continuous efforts are devoted to applying bottom-up nanofabrication based on self-assembly to decorate the optical fiber with highly ordered photonic structures. The main challenges still pertain to “order” attainment and the limited number of implementable geometries. In this review, we try to shed light on the importance of self-assembled ordered patterns for lab-on-fiber technology. After a brief presentation of the light manipulation possibilities concerned with ordered structures, and of the new prospects offered by aperiodically ordered structures, we briefly recall how the bottom-up approach can be applied to create ordered patterns on the optical fiber. Then, we present un-attempted methodologies, which can enlarge the set of achievable structures, and can potentially improve the yielding rate in finely ordered self-assembled optical fiber probes by eliminating undesired defects and increasing the order by post-processing treatments. Finally, we discuss the available tools to quantify the degree of order in the obtained photonic structures, by suggesting the use of key performance figures of merit in order to systematically evaluate to what extent the pattern is really “ordered”. We hope such a collection of articles and discussion herein could inspire new directions and hint at best practices to fully exploit the benefits inherent to self-organization phenomena leading to ordered systems.


2019 ◽  
Vol 21 (19) ◽  
pp. 10146-10151
Author(s):  
Dániel Péter Szekrényes ◽  
Szilárd Pothorszky ◽  
Dániel Zámbó ◽  
András Deák

Spatial arrangement of self-assembled gold nanosphere/nanorod heterodimers and their reorgaization upon drying detected using polarization-resolved scattering spectroscopy.


2005 ◽  
Vol 86 (12) ◽  
pp. 121106 ◽  
Author(s):  
Y. Lin ◽  
P. R. Herman ◽  
C. E. Valdivia ◽  
J. Li ◽  
V. Kitaev ◽  
...  

2003 ◽  
Vol 107 (30) ◽  
pp. 7406-7413 ◽  
Author(s):  
Yvonne Joseph ◽  
Isabelle Besnard ◽  
Miriam Rosenberger ◽  
Berit Guse ◽  
Heinz-Georg Nothofer ◽  
...  

1999 ◽  
Author(s):  
Jennifer L. Elster ◽  
Jonathan A. Greene ◽  
Mark E. Jones ◽  
Timothy A. Bailey ◽  
Shannon M. Lenahan ◽  
...  

Langmuir ◽  
1998 ◽  
Vol 14 (19) ◽  
pp. 5425-5429 ◽  
Author(s):  
Mathias Brust ◽  
Donald Bethell ◽  
Christopher J. Kiely ◽  
David J. Schiffrin

Chemosensors ◽  
2021 ◽  
Vol 9 (11) ◽  
pp. 327
Author(s):  
Panxue Wang ◽  
Yan Sun ◽  
Li Wang ◽  
Xiang Li ◽  
Miaomiao Liu ◽  
...  

Rapid and facile determination of pesticides is critically important in food and environmental monitoring. This study developed a self-assembled gold nanoparticle array based SERS method for highly specific and sensitive detection of acetamiprid, a neonicotinoid pesticide that used to be difficult in SERS analysis due to its low affinity with SERS substrates. SERS detection and quantification of acetamiprid was conducted with self-assembled gold nanoparticle arrays at the interface of chloroform and water as the enhancing substrate. Since targets dissolved in chloroform (organic phase) also have access to the hot-spots of Au NP array, the developed method exhibited good sensitivity and specificity for acetamiprid determination. Under the optimal conditions, SERS intensities at Raman shifts of 631 cm−1 and 1109 cm−1 displayed a good linear relationship with the logarithm concentration of acetamiprid in the range of 5.0 × 10−7 to 1.0 × 10−4 mol/L (0.11335 ppm to 22.67 ppm), with correlation coefficients of 0.97972 and 0.97552, respectively. The calculated LOD and LOQ of this method were 1.19 × 10−7 mol/L (0.265 ppb) and 2.63 × 10−7 mol/L (0.586 ppb), respectively, using SERS signal at 631 cm−1, and 2.95 × 10−7 mol/L (0.657 ppb) and 3.86 × 10−7 mol/L (0.860 ppb) using SERS signal at 1109 cm−1, respectively. Furthermore, the developed SERS method was successfully applied in determining acetamiprid on the surface of apple and spinach. This method offers an exciting opportunity for rapid detection of acetamiprid and other organic pesticides considering its advantages of simple preparation process, good specificity and sensitivity, and short detection time (within 1 h).


Sign in / Sign up

Export Citation Format

Share Document