scholarly journals Cerebellar inactivation impairs memory of learned prism gaze-reach calibrations

2011 ◽  
Vol 105 (5) ◽  
pp. 2248-2259 ◽  
Author(s):  
Scott A. Norris ◽  
Emily N. Hathaway ◽  
Jordan A. Taylor ◽  
W. Thomas Thach
Keyword(s):  
Kainic Acid ◽  
Cerebellar Cortex ◽  
Dentate Nucleus ◽  
Visually Guided ◽  
The Gaze ◽  
Reach Angle ◽  
And Performance ◽  
And Storage ◽  
Direction Opposite

Three monkeys performed a visually guided reach-touch task with and without laterally displacing prisms. The prisms offset the normally aligned gaze/reach and subsequent touch. Naive monkeys showed adaptation, such that on repeated prism trials the gaze-reach angle widened and touches hit nearer the target. On the first subsequent no-prism trial the monkeys exhibited an aftereffect, such that the widened gaze-reach angle persisted and touches missed the target in the direction opposite that of initial prism-induced error. After 20–30 days of training, monkeys showed long-term learning and storage of the prism gaze-reach calibration: they switched between prism and no-prism and touched the target on the first trials without adaptation or aftereffect. Injections of lidocaine into posterolateral cerebellar cortex or muscimol or lidocaine into dentate nucleus temporarily inactivated these structures. Immediately after injections into cortex or dentate, reaches were displaced in the direction of prism-displaced gaze, but no-prism reaches were relatively unimpaired. There was little or no adaptation on the day of injection. On days after injection, there was no adaptation and both prism and no-prism reaches were horizontally, and often vertically, displaced. A single permanent lesion (kainic acid) in the lateral dentate nucleus of one monkey immediately impaired only the learned prism gaze-reach calibration and in subsequent days disrupted both learning and performance. This effect persisted for the 18 days of observation, with little or no adaptation.

MODERN PROBLEMATICS AND ANALYSIS OF EFFICIENCY OF APPLICATION OF DIFFERENT APPROACHES TO DESTRUCTION OF INFORMATION ON MAGNETIC MEDIA

2019 ◽  
Vol 2 (12) ◽  
pp. 154-164
Author(s):  
O. Semenenko ◽  
O. Vodchyts ◽  
V. Koverga ◽  
R. Lukash ◽  
O. Lutsenko
Keyword(s):  
Armed Forces ◽  
Information Storage ◽  
Storage Device ◽  
Magnetic Media ◽  
Long Term Storage ◽  
Physical Impact ◽  
And Storage ◽  
Term Storage

The introduction and active use of information transmission and storage systems in the Ministry of Defense (MoD) of Ukraine form the need to develop ways of guaranteed removal of data from media after their use or long-term storage. Such a task is an essential component of the functioning of any information security system. The article analyzes the problems of guaranteed destruction of information on magnetic media. An overview of approaches to the guaranteed destruction of information on magnetic media of different types is presented, and partial estimates of the effectiveness of their application are given by some generally accepted indicators of performance evaluation. The article also describes the classification of methods of destruction of information depending on the influence on its medium. The results of the analysis revealed the main problems of application of software methods and methods of demagnetization of the information carrier. The issue of guaranteed destruction of information from modern SSD devices, which are actively used in the formation of new systems of information accumulation and processing, became particularly relevant in the article. In today's conditions of development of the Armed Forces of Ukraine, methods of mechanical and thermal destruction are more commonly used today. In the medium term, the vector of the use of information elimination methods will change towards the methods of physical impact by the pulsed magnetic field and the software methods that allow to store the information storage device, but this today requires specialists to develop new ways of protecting information in order to avoid its leakage.

Design and planning of the balanced scorecard: A case study

2007 ◽  
Vol 26 (3) ◽  
pp. 217-227
Author(s):  
Ming-Hon Hwang ◽  
Hsin Rau
Keyword(s):  
Performance Evaluation ◽  
Balanced Scorecard ◽  
Process Management ◽  
Planning Process ◽  
Company Performance ◽  
Correct Process ◽  
The Balanced Scorecard ◽  
Strategy Planning ◽  
And Performance

In the industrial economy, evaluating company performance based on financial results was good enough. However, in the current globalized and highly competitive environment, maintaining long term competitiveness requires companies to engage in overall strategic planning and performance evaluation. The balanced scorecard is a tool or method for balancing an organization's performance and can react to situations where a company's direction becomes disoriented. This approach assists in strategy planning, process management, and performance evaluation from four perspectives, including financial, customer, internal process, and learning and growth. Good strategy planning provides companies with a correct management direction, correct process management ensures the efficient execution of plans, and correct performance evaluation illustrates the execution results. This study mainly focuses on how a large rubber company in Taiwan utilizes the balanced scorecard in its organization. As the technical perspective is important in the rubber keypad industry, besides the four above perspectives, this company has added the technical perspective. By introducing this company and its progress in implementing the balanced scorecard, this study hopes to provide other companies, especially rubber companies, with a planning direction and reference for the future implementation of the balanced scorecard.

Optimal adaptive inspection and maintenance for redundant systems

2021 ◽  
pp. 1748006X2110201
Author(s):  
Chaochao Lin ◽  
Matteo Pozzi
Keyword(s):  
Engineering Systems ◽  
Discounted Cost ◽  
Markov Decision ◽  
Inspection And Maintenance ◽  
And Performance ◽  
Partially Observable ◽  
Series Systems ◽  
Selection Of ◽  
Redundant Systems

Optimal exploration of engineering systems can be guided by the principle of Value of Information (VoI), which accounts for the topological important of components, their reliability and the management costs. For series systems, in most cases higher inspection priority should be given to unreliable components. For redundant systems such as parallel systems, analysis of one-shot decision problems shows that higher inspection priority should be given to more reliable components. This paper investigates the optimal exploration of redundant systems in long-term decision making with sequential inspection and repairing. When the expected, cumulated, discounted cost is considered, it may become more efficient to give higher inspection priority to less reliable components, in order to preserve system redundancy. To investigate this problem, we develop a Partially Observable Markov Decision Process (POMDP) framework for sequential inspection and maintenance of redundant systems, where the VoI analysis is embedded in the optimal selection of exploratory actions. We investigate the use of alternative approximate POMDP solvers for parallel and more general systems, compare their computation complexities and performance, and show how the inspection priorities depend on the economic discount factor, the degradation rate, the inspection precision, and the repair cost.

scholarly journals A Compact Muon Tracker for Dynamic Tomography of Density Based on a Thin Time Projection Chamber with Micromegas Readout

Particles ◽  
2021 ◽  
Vol 4 (3) ◽  
pp. 333-342
Author(s):  
Ignacio Lázaro Roche
Keyword(s):  
Time Projection Chamber ◽  
Wide Field ◽  
Track Reconstruction ◽  
Long Term Stability ◽  
Societal Issues ◽  
Primary Signal ◽  
And Performance ◽  
Time Projection

Tomography based on cosmic muon absorption is a rising technique because of its versatility and its consolidation as a geophysics tool over the past decade. It allows us to address major societal issues such as long-term stability of natural and man-made large infrastructures or sustainable underwater management. Traditionally, muon trackers consist of hodoscopes or multilayer detectors. For applications with challenging available volumes or the wide field of view required, a thin time projection chamber (TPC) associated with a Micromegas readout plane can provide a good tradeoff between compactness and performance. This paper details the design of such a TPC aiming at maximizing primary signal and minimizing track reconstruction artifacts. The results of the measurements performed during a case study addressing the aforementioned applications are discussed. The current works lines and perspectives of the project are also presented.

scholarly journals Quality tracing in meat supply chains

2014 ◽  
Vol 372 (2017) ◽  
pp. 20130308 ◽  
Author(s):  
Miriam Mack ◽  
Patrick Dittmer ◽  
Marius Veigt ◽  
Mehmet Kus ◽  
Ulfert Nehmiz ◽  
...  
Keyword(s):  
Supply Chains ◽  
Process Analysis ◽  
Decision Support Tool ◽  
Temperature Monitoring ◽  
Support Tool ◽  
Logistics Network ◽  
Primary Model ◽  
Sensory Parameters ◽  
And Storage

The aim of this study was the development of a quality tracing model for vacuum-packed lamb that is applicable in different meat supply chains. Based on the development of relevant sensory parameters, the predictive model was developed by combining a linear primary model and the Arrhenius model as the secondary model. Then a process analysis was conducted to define general requirements for the implementation of the temperature-based model into a meat supply chain. The required hardware and software for continuous temperature monitoring were developed in order to use the model under practical conditions. Further on a decision support tool was elaborated in order to use the model as an effective tool in combination with the temperature monitoring equipment for the improvement of quality and storage management within the meat logistics network. Over the long term, this overall procedure will support the reduction of food waste and will improve the resources efficiency of food production.

The IEA Weyburn CO2 monitoring and storage project — Modeling of the long-term migration of CO2 from Weyburn

2005 ◽  
pp. 721-729 ◽  
Author(s):  
W ZHOU ◽  
M STENHOUSE ◽  
R ARTHUR ◽  
S WHITTAKER ◽  
D LAW ◽  
...  
Keyword(s):  
Co2 Monitoring ◽  
And Storage
Sign in / Sign up

Export Citation Format

Share Document