scholarly journals Effect of Operating Conditions on Pollutants Concentration Emitted from a Spark Ignition Engine Fueled with Gasoline Bioethanol Blends

2015 ◽  
Vol 2015 ◽  
pp. 1-7 ◽  
Author(s):  
Haroun A. K. Shahad ◽  
Saad K. Wabdan
Keyword(s):  
Nitric Oxide ◽  
Carbon Dioxide ◽  
Experimental Investigation ◽  
Spark Ignition ◽  
Operating Conditions ◽  
Spark Ignition Engine ◽  
Variable Speed ◽  
Exhaust Gases ◽  
Speed Increase ◽  
Energy Replacement

This study is an experimental investigation of the effect of bioethanol gasoline blending on exhaust emissions in terms of carbon dioxide CO2, carbon monoxide CO, unburnt hydrocarbons UHC, and nitric oxide NOxof a spark ignition engine. Tests are conducted at controlled throttle and variable speed condition over the range of 1200 to 2000 rpm with intervals 400 rpm. Different compression ratios are tested for each speed, namely (7,8,10, and 11). Pure gasoline and bioethanol gasoline blends are used. The bioethanol used is produced from Iraqi date crop (Zehdi). Blending is done on energy replacement bases. Ethanol energy ratio (EER) used is 5%, 10%, and 15%. At each of the three designated engine speeds, the torque is set as 0, 3, 7, 10, and 14 N·m. It is found that ethanol blending reduces CO and UHC concentration in the exhaust gases by about 45% and 40.15%, respectively, and increases NOxand CO2concentrations in the exhaust gases by about 16.18% and 7.5%, respectively. It is found also that load and speed increase causes an increase in CO2and NOxconcentrations and reduces CO and UHC concentrations. It is also found that increasing the compression ratio causes the emissions of CO2and NOxto decrease and those of CO and UHC to increase.

scholarly journals Impact of the use of comfort devices on the exhaust toxic compounds from a modern PC car with spark ignition engine

2021 ◽  
Author(s):  
Maciej Siedlecki ◽  
Jerzy Merkisz ◽  
Michał Dobrzyński ◽  
Kamil Kubiak
Keyword(s):  
Carbon Dioxide ◽  
Carbon Monoxide ◽  
Size Distribution ◽  
Mass Number ◽  
Spark Ignition ◽  
Operating Conditions ◽  
Solid Particles ◽  
Spark Ignition Engine ◽  
Direct Impact ◽  
Toxic Compounds

The use of comfort systems, the number of which in vehicles is constantly increasing, has a direct impact on fuel consumption and engine load. As part of the article, the vehicle's drive in real operating conditions was analyzed in terms of the emission of toxic compounds. The tests were carried out without and with the systems turned on, using the PEMS apparatus, where road emissions of carbon dioxide, carbon monoxide, hydrocarbons, nitrogen oxides and solid particles were measured in terms of mass, number and size distribution of diameters. The track was driven four times with different setting of the powertrain of examined car.

scholarly journals Ethanol/Gasoline Blends as Alternative Fuel in Last Generation Spark-Ignition Engines: A Review on CO and HC Engine Out Emissions

Energies ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 4034
Author(s):  
Paolo Iodice ◽  
Massimo Cardone
Keyword(s):  
Physicochemical Properties ◽  
Alternative Fuels ◽  
Experimental Studies ◽  
Alternative Fuel ◽  
Exhaust Emissions ◽  
Spark Ignition ◽  
Operating Conditions ◽  
Spark Ignition Engine ◽  
Spark Ignition Engines ◽  
The Impact

Among the alternative fuels existing for spark-ignition engines, ethanol is considered worldwide as an important renewable fuel when mixed with pure gasoline because of its favorable physicochemical properties. An in-depth and updated investigation on the issue of CO and HC engine out emissions related to use of ethanol/gasoline fuels in spark-ignition engines is therefore necessary. Starting from our experimental studies on engine out emissions of a last generation spark-ignition engine fueled with ethanol/gasoline fuels, the aim of this new investigation is to offer a complete literature review on the present state of ethanol combustion in last generation spark-ignition engines under real working conditions to clarify the possible change in CO and HC emissions. In the first section of this paper, a comparison between physicochemical properties of ethanol and gasoline is examined to assess the practicability of using ethanol as an alternative fuel for spark-ignition engines and to investigate the effect on engine out emissions and combustion efficiency. In the next section, this article focuses on the impact of ethanol/gasoline fuels on CO and HC formation. Many studies related to combustion characteristics and exhaust emissions in spark-ignition engines fueled with ethanol/gasoline fuels are thus discussed in detail. Most of these experimental investigations conclude that the addition of ethanol with gasoline fuel mixtures can really decrease the CO and HC exhaust emissions of last generation spark-ignition engines in several operating conditions.

Laminar flame speed correlations for methane, ethane, propane and their mixtures, and natural gas and gasoline for spark-ignition engine simulations

2017 ◽  
Vol 18 (9) ◽  
pp. 951-970 ◽  
Author(s):  
Riccardo Amirante ◽  
Elia Distaso ◽  
Paolo Tamburrano ◽  
Rolf D Reitz
Keyword(s):  
Natural Gas ◽  
Laminar Flame ◽  
Spark Ignition ◽  
Flame Speed ◽  
Operating Conditions ◽  
Spark Ignition Engine ◽  
Computational Time ◽  
Laminar Flame Speed ◽  
Spark Ignition Engines ◽  
Empirical Correlations

The laminar flame speed plays an important role in spark-ignition engines, as well as in many other combustion applications, such as in designing burners and predicting explosions. For this reason, it has been object of extensive research. Analytical correlations that allow it to be calculated have been developed and are used in engine simulations. They are usually preferred to detailed chemical kinetic models for saving computational time. Therefore, an accurate as possible formulation for such expressions is needed for successful simulations. However, many previous empirical correlations have been based on a limited set of experimental measurements, which have been often carried out over a limited range of operating conditions. Thus, it can result in low accuracy and usability. In this study, measurements of laminar flame speeds obtained by several workers are collected, compared and critically analyzed with the aim to develop more accurate empirical correlations for laminar flame speeds as a function of equivalence ratio and unburned mixture temperature and pressure over a wide range of operating conditions, namely [Formula: see text], [Formula: see text] and [Formula: see text]. The purpose is to provide simple and workable expressions for modeling the laminar flame speed of practical fuels used in spark-ignition engines. Pure compounds, such as methane and propane and binary mixtures of methane/ethane and methane/propane, as well as more complex fuels including natural gas and gasoline, are considered. A comparison with available empirical correlations in the literature is also provided.

Assessment of the reliability of ionization current measurement in estimating peak pressure angle in a spark ignition engine

2021 ◽  
pp. 146808742110399
Author(s):  
Veniero Giglio ◽  
Livia Della Ragione ◽  
Alessandro di Gaeta ◽  
Natale Rispoli
Keyword(s):  
Peak Pressure ◽  
Angular Position ◽  
Spark Ignition ◽  
Operating Conditions ◽  
Spark Ignition Engine ◽  
Mean Values ◽  
Pressure Angle ◽  
Ionization Current ◽  
Significant Difference ◽  
Second Peak

Ionization current measured at the spark plug during combustion in spark ignition engines has often been proposed to determine the crank-angle at combustion pressure peak, namely the peak pressure angle, for the purpose of regulating spark timing to attain maximum brake torque (MBT). The proposal is based on the assumption that agreement exists between peak pressure angle and the angular position of the ionization current second peak, although no one has ever proved it by an appropriate statistical analysis. The aim of this work, for the first time and by rigorous statistical methods, is to prove the agreement between Peak Pressure Angle and Ionization Current Second Peak Angle (ICSPA), without which a MBT control via ICSPA would be ineffective. Our experimental database consisted of about 9000 pairs of Peak Pressure Angle and Ionization Current Second Peak Angle values corresponding to 90 different operating conditions of a spark ignition engine. A two-sample comparison was first carried out between mean values of Peak Pressure Angle and Ionization Current Second Peak Angle, which showed a statistically significant difference between them. Then Bland-Altman analysis (Lancet, 1986), widely known and used for checking agreement between two different measurement methods, was conducted. It demonstrated that under almost all the experimental operating conditions, there was no agreement between the Ionization Current Second Peak Angle and the Peak Pressure Angle.

Study on flame-vortex interaction in a spark ignition engine fueled with methane/carbon dioxide gases

2018 ◽  
Vol 91 (1) ◽  
pp. 133-144 ◽  
Author(s):  
Xin Zhang ◽  
Tao Wang ◽  
Jian Xu ◽  
Shizhuo Zheng ◽  
Xiaosen Hou
Keyword(s):  
Carbon Dioxide ◽  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Vortex Interaction ◽  
Methane Carbon
Sign in / Sign up

Export Citation Format

Share Document