scholarly journals Formulation and In Vitro Evaluation of Oral Capsules and Suspension from the Ethanolic Extract of Cola nitida Seeds for the Treatment of Diarrhea

2021 ◽  
Vol 2021 ◽  
pp. 1-7
Author(s):  
Fredrick W. A. Owusu ◽  
Christiana O. Asare ◽  
Philomena Enstie ◽  
Ofosua Adi-Dako ◽  
Genevieve Naana Yeboah ◽  
...  
Keyword(s):  
Flow Rate ◽  
Sedimentation Rate ◽  
In Vitro Release ◽  
Ethanolic Extract ◽  
Dosage Forms ◽  
Drug Content ◽  
Sedimentation Volume ◽  
Vitro Release ◽  
Cola Nitida

Management of diarrhea has evolved over the years from relatively inadequate interventions in the early years to more successful physiological approaches. The use of herbal medicinal products and supplements has grown significantly over the past three decades, with more than half of the global population depending on it for some aspect of their primary health care needs. This study is aimed at formulating solid and liquid oral dosage forms of the ethanolic extract of Cola nitida seeds for the treatment of diarrhea. The flow property of the dried ethanolic extract was determined and subsequently formulated into granules for encapsulation. The ethanolic extract was also used in formulating an oral suspension. Pharmacopeia tests such as uniformity of weight, disintegration, drug content, and dissolution were carried out on the formulated capsules. The formulated suspension was also assessed using the following parameters; viscosity, flow rate, drug content, dissolution, sedimentation rate, and sedimentation volume. The dried ethanolic extract and formulated granules exhibited good flow properties. The formulated capsules exhibited optimal in vitro release of extract (>90% after 45 minutes) and passed the uniformity of weight, disintegration, and drug content tests. The formulated suspension also passed the drug content test and had a good sedimentation rate, sedimentation volume, and flow rate. The formulated suspension also exhibited pseudoplastic flow, optimal viscosity, and a good in vitro release profile (>90% after 45 minutes). Capsules and suspension of the ethanolic extract of Cola nitida seeds have been successfully formulated and can be used as standard dosage forms for the management of diarrhea.

scholarly journals Formulation and Pharmaceutical Assessment of Annona muricata Oral Capsules and Suspension as Antidiarrhea Dosage Forms

2021 ◽  
Vol 2021 ◽  
pp. 1-6
Author(s):  
Frederick William Akuffo Owusu ◽  
Mariam El Boakye-Gyasi ◽  
Philomena Entsie ◽  
Christina Osei-Asare ◽  
Ofosua Adi-Dako ◽  
...  
Keyword(s):  
Sedimentation Rate ◽  
Ethanolic Extract ◽  
Dosage Forms ◽  
Oral Dosage ◽  
In Vitro Dissolution ◽  
Annona Muricata ◽  
Drug Content ◽  
Volume Viscosity ◽  
Sedimentation Volume

Annona muricata (Annonaceae) is a tropical plant widely known for its edible fruits. Recent scientific studies have confirmed the folkloric use of its seeds as an antidiarrheal agent. This study sought to formulate capsules and suspensions using the ethanolic extract from Annona muricata seeds. The dried ethanolic extract was formulated into granules and subsequently encapsulated. The suspension formulated was assessed for sedimentation rate, sedimentation volume, viscosity, dissolution, drug content, and flow rate, while pharmacopeia tests such as disintegration, dissolution, uniformity of weight, and drug content were carried out on the formulated capsules. The formulated suspension passed the drug content and in vitro release studies. Annona muricata suspension exhibited pseudoplastic flow with good sedimentation rate and sedimentation volume. The formulated capsules passed the in vitro dissolution studies, weight uniformity, disintegration, and drug content tests. The ethanolic extract of Annona muricata seeds was appropriately formulated into standardized solid and liquid oral dosage forms.

scholarly journals Design and evaluation of Pulsatile drug delivery of Losartan Potassium

2014 ◽  
Vol 12 (2) ◽  
pp. 119-123
Author(s):  
MS Ashwini ◽  
Mohammed Gulzar Ahmed
Keyword(s):  
In Vitro Release ◽  
Losartan Potassium ◽  
Stability Studies ◽  
In Vitro Drug Release ◽  
Drug Content ◽  
Weight Variation ◽  
Release Studies ◽  
The Stability ◽  
Vitro Release

The study was designed for the investigation of pulsatile device to achieve time or site specific release of Losartan potassium based on chronopharmaceutical considerations. The basic design involves the preparation of cross linked hard gelatin capsules by using formaldehyde, then the drug diluent mixture were prepared and loaded in, which was separated by using hydrogel plugs of different polymers of different viscosities. Prepared formulations were subjected to evaluation of various parameters like weight variation, percentage drug content, in vitro drug release and stability studies. Weight variation and percentage drug content results showed that they were within the limits of official standards. The in-vitro release studies revealed that the capsules plugged with polymer HPMC showed better pulsatile or sustained release property as compared to the other formulations. The stability studies were carried out for all the formulations and formulations F1 & F2 were found to be stable. Dhaka Univ. J. Pharm. Sci. 12(2): 119-123, 2013 (December) DOI: http://dx.doi.org/10.3329/dujps.v12i2.17610

scholarly journals FORMULATION OF POLYMERIC NANOSUSPENSION CONTAINING PRAMIPEXOLE DIHYDROCHLORIDE AND HESPERIDIN FOR IMPROVED TREATMENT OF PARKINSON’S DISEASES

2018 ◽  
Vol 11 ◽  
Author(s):  
Somasundaram I
Keyword(s):  
Particle Size ◽  
Drug Release ◽  
Zeta Potential ◽  
In Vitro Release ◽  
Entrapment Efficiency ◽  
Burst Release ◽  
Drug Content ◽  
Pramipexole Dihydrochloride ◽  
Vitro Release

Aims and Objectives: The present study is to formulate the nanosuspension containing a hydrophilic drug pramipexole dihydrochloride and hesperidin and to increase the drug entrapment efficiency.Methods: Hesperidin and pramipexole dihydrochloride loaded in chitosan nanosuspension is prepared by ionic gelation method using chitosan and tripolyphosphate. There was no incompatibility observed between the drug and polymer through Fourier transform infrared and differential scanning calorimetric. Various other parameters such as particle size, zeta potential, scanning electron microscope, drug content, drug entrapment efficiency, and in vitro release have been utilized for the characterization of nanoparticles.Results and Discussion: The average size of particle is 188 nm; zeta potential is 46.7 mV; drug content of 0.364±0.25 mg/ml; entrapment efficiency of 72.8% is obtained with HPN3 formulation. The PHC1 shows the highest drug release followed by PHC2 due to low concentration of polymer and PHC4 and PHC5 show less drug release due to high concentration of polymer. The in vitro release of PHC3 is 85.2%, initial the burst release is shown which is approximately 60% in 8 h; then, slow release later on drastic reduction in release rate is shown in 24 h. The in vivo study histopathological report confers the effective protective against rotenone induces Parkinson’s.Conclusion: PHC3 was chosen as the best formulation due to its reduced particle size and controlled release at optimum polymer concentration which may be used to treat Parkinson’s disease effectively..

Evaluation of the in vitro release and permeation of Cordia verbenacea DC essential oil from topical dosage forms

2019 ◽  
Vol 53 ◽  
pp. 101173 ◽  
Author(s):  
Jéssica Domingos da Silva ◽  
Márcio Vinícius Gomes ◽  
Lucio Mendes Cabral ◽  
Valeria Pereira de Sousa
Keyword(s):  
Essential Oil ◽  
In Vitro Release ◽  
Dosage Forms ◽  
Topical Dosage ◽  
Vitro Release ◽  
Topical Dosage Forms

scholarly journals SOLUBILITY ENHANCEMENT OF CELECOXIB BY SOLID DISPERSION TECHNIQUE AND INCORPORATION INTO TOPICAL GEL

2019 ◽  
pp. 294-300
Author(s):  
AMRIN SHAIKH ◽  
PRASHANT BHIDE ◽  
REESHWA NACHINOLKAR
Keyword(s):  
Drug Release ◽  
Dissolution Rate ◽  
In Vitro Release ◽  
Methyl Cellulose ◽  
In Vitro Drug Release ◽  
Peg 6000 ◽  
Topical Gel ◽  
Drug Content ◽  
Vitro Release

Objective: The aim of the present investigation was to design gels for the topical delivery of celecoxib and evaluate with an aim to increase its penetration through the skin and thereby its flux. Method: The solubility of celecoxib is shown to be increased by preparing solid dispersions (SDs) using carriers such as mannitol, polyvinylpyrrolidone (PVP-K30), polyethylene glycol (PEG) 6000 and urea by solvent evaporation, fusion, and coevaporation methods. In vitro release profile of all SD was comparatively evaluated and studied against the pure drug. The prepared SD was subjected for percent practical yield, drug content, infrared spectroscopy, differential scanning calorimetry analysis, X-ray diffraction studies, and scanning electron microscopy (SEM) imaging. The celecoxib gel was prepared using hydroxypropyl methyl cellulose (HPMC) and Carbopol containing a permeation enhancer dimethyl sulfoxide (DMSO) at different proportions and evaluated for drug content, pH, viscosity, spreadability, extrudability, stability, and in vitro drug release. Results: Faster dissolution rate was exhibited by SD containing 1:5 ratio of celecoxib: PVP K-30 prepared by coevaporation method. In vitro drug release of celecoxib, gels revealed that formulation with HPMC has higher drug release as compared to Carbopol. Conclusion: The increase in dissolution rate for SD is observed in the following order of PVP K-30>urea>mannitol>PEG 6000. The CPD5 gel containing a SD CP5 and 20% DMSO showed the best in vitro release 74.13% at the end of 6 h.

scholarly journals Development and Characterization of Glimepiride Novel Solid Nanodispersion for Improving Its Oral Bioavailability

2020 ◽  
Vol 88 (4) ◽  
pp. 52
Author(s):  
Mona Qushawy ◽  
Ali Nasr ◽  
Shady Swidan ◽  
Yasmin Mortagi
Keyword(s):  
Solid Dispersion ◽  
Drug Carrier ◽  
In Vitro Release ◽  
Water Soluble ◽  
Production Yield ◽  
Scanning Calorimetry ◽  
Differential Scanning Calorimetry Study ◽  
Drug Content ◽  
Vitro Release

Glimepiride is an antidiabetic drug which is one of the third generation sulfonylureas. It belongs to class II, according to the BCS (Biopharmaceutical Classification System), which is characterized by low solubility and high permeability. The aim of this work was to formulate glimepiride as solid dispersion using water-soluble carriers to enhance its aqueous solubility and thus enhance its bioavailability. Nine formulations of glimepiride solid dispersion were prepared by a solvent evaporation technique using three different carriers (mannitol, polyethylene glycol 6000, and β-cyclodextrin) with three different drug carrier ratio (1:1, 1:3, and 1:6). Formulation variables were optimized using 32 full factorial design. The prepared formulations were evaluated for production yield, drug content, micromeritic properties, thermal analysis, in-vitro release, and in-vivo hypoglycemic effect. All prepared formulations showed high production yield ranged from 98.4 ± 2.8 to 99.8 ± 2.2% and high drug content in the range of 97.2 ± 3.2 to 99.6 ± 2.1%. The micromeritic properties revealed that all prepared glimepiride formulations showed good flowability. The differential scanning calorimetry study revealed the presence of the drug in the more soluble amorphous form. In accordance with the results of in vitro release study, it was found that the solubility of glimepiride was increased by increasing the drug carrier ratio, compared with the pure form of the drug. It was found that F9 showed a high and rapid reduction in blood glucose levels in diabetic rats, which indicated the success of a solid dispersion technique in improving the solubility and hence the bioavailability of glimepiride.

scholarly journals FIP/AAPS Guidelines for Dissolution/In Vitro Release Testing of Novel/Special Dosage Forms*

2003 ◽  
Vol 10 (1) ◽  
pp. 6-15 ◽  
Author(s):  
Martin Siewert ◽  
Jennifer Dressman ◽  
Cynthia Brown ◽  
Vinod Shah
Keyword(s):  
In Vitro Release ◽  
Dosage Forms ◽  
Dissolution In Vitro ◽  
Vitro Release ◽  
Release Testing
Sign in / Sign up

Export Citation Format

Share Document