Applications of the Linear Mass-Sectional Breakage Population Balance to Various Milling Process Configurations

2021 ◽  
Vol 22 (3) ◽  
Author(s):  
Russell B. Diemer
2010 ◽  
Vol 5 (4) ◽  
pp. 161-168 ◽  
Author(s):  
Pavan Kumar Akkisetty ◽  
Ung Lee ◽  
Gintaras V. Reklaitis ◽  
Venkat Venkatasubramanian

2019 ◽  
Vol 2 (2) ◽  
pp. 91-95 ◽  
Author(s):  
Jimmy Jimmy ◽  
Diah Indriani Widiputri ◽  
Paulus Gunawan

Eichhornia crassipes is well-known as water hyacinth. Water hyacinth grows rapidly in the nutrient-rich water and high light intensity places. The uncontrollable growth of water hyacinth has caused many negative impacts to the environment. For instance, interrupted water transport and decreased population of aquatic lives. The capacity of utilising water hyacinth is slower than water hyacinth growth and water hyacinth is still considered as a threat to theecosystem. This work was focused on the study of the pharmacological activity and heavy metal content of water hyacinth in Lake Cipondoh, Tangerang. Fresh water hyacinth was pre-treated through oven-drying and milling process. After that, each part of the plant was macerated by using multiple extraction method with 96% ethanol/water and three variations of sample-to-solvent ratios (1:30, 1:50, and 1:75 w/v). The result of the experiment showed thatwater hyacinth leaves produced an extract with lowest IC 50 (55.76 ± 6.73 ppm) compared toother parts. The most optimum solvent used to achieve this result was 96% ethanol/water (1:1 v/v). In order to obtain the lowest antioxidant activity, the sample to solvent ratio used was 1:50 and the heavy metal in the extract was very low. With this result, it was concluded that there is a promising opportunity to apply the water hyacinth growing in Lake Cipondoh, Tangerang as herbal medicine ingredient. Through this utilization, the overall number of water hyacinth in Indonesia can be reduced or at the least be controlled, so that the environmental problem caused by this plant can be minimized.


2018 ◽  
Vol 60 (7-8) ◽  
pp. 719-726 ◽  
Author(s):  
Sıddıka Mertdinç ◽  
Emre Tekoğlu ◽  
Duygu Ağaoğulları ◽  
M. Lütfi Öveçoğlu

Author(s):  
D. Vallett ◽  
J. Gaudestad ◽  
C. Richardson

Abstract Magnetic current imaging (MCI) using superconducting quantum interference device (SQUID) and giant-magnetoresistive (GMR) sensors is an effective method for localizing defects and current paths [1]. The spatial resolution (and sensitivity) of MCI is improved significantly when the sensor is as close as possible to the current paths and associated magnetic fields of interest. This is accomplished in part by nondestructive removal of any intervening passive layers (e.g. silicon) in the sample. This paper will present a die backside contour-milling process resulting in an edge-to-edge remaining silicon thickness (RST) of < 5 microns, followed by a backside GMR-based MCI measurement performed directly on the ultra-thin silicon surface. The dramatic improvement in resolving current paths in an ESD protect circuit is shown as is nanometer scale resolution of a current density peak due to a power supply shortcircuit defect at the edge of a flip-chip packaged die.


Sign in / Sign up

Export Citation Format

Share Document