scholarly journals The Relationships between the Permeability and Structural Characteristics of Fine Coal Beds

1960 ◽  
Vol 63 (8) ◽  
pp. 1282-1287
Author(s):  
Seiichi Tejima ◽  
Yoshio Yamagata ◽  
Shoichiro Tachikawa
Keyword(s):  
Structural Characteristics ◽  
Fine Coal ◽  
Coal Beds

scholarly journals Relation between Void Structure and Dewatering in Fine Coal Beds

1960 ◽  
Vol 63 (3) ◽  
pp. 508-512
Author(s):  
Seiichi Tajima ◽  
Yoshio Yamagata ◽  
Shoichiro Tachikawa
Keyword(s):  
Fine Coal ◽  
Coal Beds ◽  
Void Structure

scholarly journals Coal Moisture Variations in Response to Rainfall Events in Mine and Coal-Fired Power Plant Stockpiles—Part 2: Evaporation

Minerals ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 1366
Author(s):  
Quentin Peter Campbell ◽  
Marco le Roux ◽  
Fardis Nakhaei
Keyword(s):  
Laboratory Experiments ◽  
Evaporation Process ◽  
Ambient Conditions ◽  
Moisture Evaporation ◽  
Rainfall Events ◽  
Heating Value ◽  
Surface Evaporation ◽  
Fine Coal ◽  
Coal Beds ◽  
Rate Of Evaporation

Additional moisture added in coal stockpiles due to rain and other climatic processes causes a significant problem worldwide, which leads to not only decrease in the heating value of the coal but also creates an extra efficiency penalty. Therefore, it is important to make some predictions for control of coal moisture within stockpiles after the rainfall. When the rain falls on the stockpile, it either runs off the surface or infiltrates the stockpile. The infiltrated water may evaporate from the surface, drain or stay within the stockpile. The aims of this study (parts 1 and 2) are to describe and compare the changes in coal moisture content following rainfall events. The mechanisms of runoff, infiltration and drainage after rainfall were described in the first paper of this series. In part 2 the influence of coal particle size and ambient conditions on the rate and depth of moisture evaporation within the stockpile is investigated. The laboratory experiments showed cyclic events of adsorbing moisture overnight and desorbing this moisture during the day as part of the coal surface evaporation process. The rate of evaporation from the surface of the fine coal stockpile was faster than the coarse stockpile; however, the coarse stockpile experienced a more efficient evaporation process because of its porous structure. Fine coal beds experienced evaporation only near the surface, while the maximum influencing layer of evaporation is a depth of 0.4 cm below the surface in coarse coal beds.

A High Resolution Study of G.P. Zones in Aluminum - 4.2 at % Silver

1982 ◽  
Vol 40 ◽  
pp. 722-723 ◽  
Author(s):  
R. Gronsky
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Computer Simulations ◽  
Structural Characteristics ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Resolution Study

The phenomenon of clustering in Al-Ag alloys has been extensively studied since the early work of Guinierl, wherein the pre-precipitation state was characterized as an assembly of spherical, ordered, silver-rich G.P. zones. Subsequent x-ray and TEM investigations yielded results in general agreement with this model. However, serious discrepancies were later revealed by the detailed x-ray diffraction - based computer simulations of Gragg and Cohen, i.e., the silver-rich clusters were instead octahedral in shape and fully disordered, atleast below 170°C. The object of the present investigation is to examine directly the structural characteristics of G.P. zones in Al-Ag by high resolution transmission electron microscopy.

SEM analysis of the change in the reaction rates with deposit structures in the copper-iron cementation system

1978 ◽  
Vol 36 (1) ◽  
pp. 456-457
Author(s):  
V. Annamalai ◽  
L.E. Murr
Keyword(s):  
Structural Characteristics ◽  
Secondary Electron Emission ◽  
Copper Deposit ◽  
Reaction Rates ◽  
Sem Analysis ◽  
Experimental Conditions ◽  
Major Drawback ◽  
Emission Mode ◽  
Scrap Iron ◽  
Image Position

Economical recovery of copper metal from leach liquors has been carried out by the simple process of cementing copper onto a suitable substrate metal, such as scrap-iron, since the 16th century. The process has, however, a major drawback of consuming more iron than stoichiometrically needed by the reaction.Therefore, many research groups started looking into the process more closely. Though it is accepted that the structural characteristics of the resultant copper deposit cause changes in reaction rates for various experimental conditions, not many systems have been systematically investigated. This paper examines the deposit structures and the kinetic data, and explains the correlations between them.A simple cementation cell along with rotating discs of pure iron (99.9%) were employed in this study to obtain the kinetic results The resultant copper deposits were studied in a Hitachi Perkin-Elmer HHS-2R scanning electron microscope operated at 25kV in the secondary electron emission mode.

Use of 2½ D imaging in analysis of NiTi martensite

1978 ◽  
Vol 36 (1) ◽  
pp. 610-611
Author(s):  
G. M. Michal
Keyword(s):  
Memory Effect ◽  
Monoclinic Phase ◽  
Reaction Path ◽  
Structural Characteristics ◽  
Salient Feature ◽  
Martensite Phase ◽  
Orientation Relationships ◽  
Low Symmetry ◽  
Hydride Phases ◽  
Unusual Shape

Several TEM investigations have attempted to correlate the structural characteristics to the unusual shape memory effect in NiTi, the consensus being the essence of the memory effect is ostensible manifest in the structure of NiTi transforming martensitic- ally from a B2 ordered lattice to a low temperature monoclinic phase. Commensurate with the low symmetry of the martensite phase, many variants may form from the B2 lattice explaining the very complex transformed microstructure. The microstructure may also be complicated by the enhanced formation of oxide or hydride phases and precipitation of intermetallic compounds by electron beam exposure. Variants are typically found in selfaccommodation groups with members of a group internally twinned and the twins themselves are often observed to be internally twinned. Often the most salient feature of a group of variants is their close clustering around a given orientation. Analysis of such orientation relationships may be a key to determining the nature of the reaction path that gives the transformation its apparently perfect reversibility.

Use of light microscopy in the qualitative and quantitative study of liquid crystalline order

1992 ◽  
Vol 50 (1) ◽  
pp. 264-265
Author(s):  
Christopher Viney
Keyword(s):  
Light Microscopy ◽  
Liquid Crystalline ◽  
Structural Characteristics ◽  
Molecular Order ◽  
Liquid Crystalline Phases ◽  
Convenient Technique ◽  
Liquid Crystalline Materials ◽  
Transparent Windows

Light microscopy is a convenient technique for characterizing molecular order in fluid liquid crystalline materials. Microstructures can usually be observed under the actual conditions that promote the formation of liquid crystalline phases, whether or not a solvent is required, and at temperatures that can range from the boiling point of nitrogen to 600°C. It is relatively easy to produce specimens that are sufficiently thin and flat, simply by confining a droplet between glass cover slides. Specimens do not need to be conducting, and they do not have to be maintained in a vacuum. Drybox or other controlled environmental conditions can be maintained in a sealed chamber equipped with transparent windows; some heating/ freezing stages can be used for this purpose. It is relatively easy to construct a modified stage so that the generation and relaxation of global molecular order can be observed while specimens are being sheared, simulating flow conditions that exist during processing. Also, light only rarely affects the chemical composition or molecular weight distribution of the sample. Because little or no processing is required after collecting the sample, one can be confident that biologically derived materials will reveal many of their in vivo structural characteristics, even though microscopy is performed in vitro.

Ascidian Mitochondrial tRNAMet Possessing Unique Structural Characteristics

1998 ◽  
Vol 17 (1) ◽  
pp. 531-539 ◽  
Author(s):  
Akiko Kondow ◽  
Shin-ichi Yokobori ◽  
Takuya Ueda ◽  
Kimitsuna Watanabe
Keyword(s):  
Structural Characteristics

Role of the Structural Characteristics of Dendrimers in the Manifestation of the Antiamyloid Properties

INEOS OPEN ◽  
2020 ◽  
Vol 3 ◽  
Author(s):  
S. A. Sorokina ◽  
◽  
Yu. Yu. Stroilova ◽  
V. I. Muronets ◽  
Z. B. Shifrina ◽  
...  
Keyword(s):  
Neurodegenerative Diseases ◽  
Structural Characteristics ◽  
Short Review ◽  
External Factors ◽  
Amyloid Aggregation ◽  
Amyloid Proteins ◽  
Molecular Parameters ◽  
Amyloid Aggregates ◽  
Aggregation Processes

Among the compounds able to efficiently inhibit the amyloid aggregation of proteins and decompose the amyloid aggregates that cause neurodegenerative diseases, of particular interest are dendrimers, which represent individual macromolecules with the hypercrosslinked architectures and given molecular parameters. This short review outlines the peculiarities of the antiamyloid activity of dendrimers and discusses the effect of dendrimer structures and external factors on their antiamyloid properties. The potential of application of dendrimers in further investigations on the aggregation processes of amyloid proteins as the compounds that exhibit the remarkable antiamyloid activity is evaluated.

Sign in / Sign up

Export Citation Format

Share Document