scholarly journals A Study on Upflow-Anaerobic Sludge Blanket (Uasb) Reactor Compare with Conventional Activated Sludge Process

2020 ◽  
Vol 9 (4) ◽  
pp. 12-18
Author(s):  
S. Arivalagan S. Arivalagan ◽  
M. Narmatha M. Narmatha
2009 ◽  
Vol 60 (11) ◽  
pp. 2829-2839 ◽  
Author(s):  
Ye Shi Cao ◽  
Chee Meng Ang

A laboratory-scale system consisting of an upflow anaerobic sludge blanket (UASB) reactor followed by a modified Ludzack-Ettinger (MLE) activated sludge process was adopted to investigate COD and nitrogen removals in municipal sewage treatment in warm climate. The COD, SCOD, acetic acid (HAc), NH4+-N and PO43−-P conversions in the UASB reactor were investigated. A 35% reduction in volatile suspended solid (VSS) was achieved in the UASB process. The net methane (CH4) production was 0.06 l (g CODremoved)−1. Acids accumulation was not observed. In the MLE activated sludge process, nitrification was almost complete while denitrification was modest. Little excess sludge was produced as the bulk of the COD was removed in the UASB reactor, which reduced the COD mass load to the activated sludge process. The average COD and SCOD of the final effluent of the activated sludge process were 51 and 25 mg l−1, respectively and the average NH4+-N concentration of the final effluent was 3.1 mg N l−1. The results illustrated that the coupled process is feasible for COD and nitrogen removals in municipal sewage treatment in warm climate. However, the low pH of the final effluent (<6 on average) remains an issue to be solved.


2013 ◽  
Vol 33 (4) ◽  
pp. 808-819 ◽  
Author(s):  
Marcelo Bruno ◽  
Roberto A. de Oliveira

In this study it was evaluated the efficiency of the treatment of wet-processed coffee wastewater in upflow anaerobic sludge blanket (UASB) reactors in two stages, in bench scale, followed by post-treatment with activated sludge in batch. The first UASB reactor was submitted to an hydraulic retention time (HRT) of 6.2 d and organic loading rates (OLR) of 2.3 and 4.5g CODtotal (L d)-1, and the second UASB reactor to HRT of 3.1 d with OLR of 0.4 and 1.4g CODtotal (L d)-1. The average values of the affluent CODtotal increased from 13,891 to 27,926mg L-1 and the average efficiencies of removal of the CODtotal decreased from 95 to 91%, respectively, in the UASB reactors in two stages. The volumetric methane production increased from 0.274 to 0.323L CH4 (L reactor d)-1 with increment in the OLR. The average concentrations of total phenols in the affluent were of 48 and 163mg L-1, and the removal efficiencies in the UASB reactors in two stages of 92 and 90%, respectively, and increased to 97% with post-treatment. The average values of the removal efficiencies of total nitrogen and phosphorus were of 57 to 80% and 44 to 60%, respectively, in the UASB reactors in two stages and increased to 91 and 84% with the post-treatment.


1994 ◽  
Vol 30 (6) ◽  
pp. 31-40 ◽  
Author(s):  
Hiroyshi Emori ◽  
Hiroki Nakamura ◽  
Tatsuo Sumino ◽  
Tadashi Takeshima ◽  
Katsuzo Motegi ◽  
...  

For the sewage treatment plants near rivers and closed water bodies in urbanized areas in Japan and European countries, there is a growing demand for introduction of advanced treatment processes for nitrogen and phosphorus from the viewpoints of water quality conservation and environmental protection. In order to remove nitrogen by the conventional biological treatment techniques, it is necessary to make a substantial expansion of the facility as compared with the conventional activated sludge process. In such urbanized districts, it is difficult to secure a site and much capital is required to expand the existing treatment plant. To solve these problems, a compact single sludge pre-denitrification process using immobilized nitrifiers was developed. Dosing the pellets, which are suitable for nitrifiers growth and physically durable, into the nitrification tank of single sludge pre-denitrification process made it possible to perform simultaneous removal of BOD and nitrogen in a retention time equal to that in the conventional activated sludge process even at the low water temperature of about 10 °C. The 3,000 m3/d full-scale conventional activated sludge plant was retrofitted and has been successfully operated.


Catalysts ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 512
Author(s):  
Jeremiah Chimhundi ◽  
Carla Hörstmann ◽  
Evans M. N. Chirwa ◽  
Hendrik G. Brink

The main objective of this study was to achieve the continuous biorecovery and bioreduction of Pb(II) using an industrially obtained consortia as a biocatalyst. An upflow anaerobic sludge blanket reactor was used in the treatment process. The bioremediation technique that was applied made use of a yeast extract as the microbial substrate and Pb(NO3)2 as the source of Pb(II). The UASB reactor exhibited removal efficiencies of between 90 and 100% for the inlet Pb concentrations from 80 to 2000 ppm and a maximum removal rate of 1948.4 mg/(L·d) was measured. XRD and XPS analyses of the precipitate revealed the presence of Pb0, PbO, PbS and PbSO4. Supporting experimental work carried out included growth measurements, pH, oxidation–reduction potentials and nitrate levels.


2016 ◽  
Vol 78 (5-6) ◽  
Author(s):  
Sunwanee Jijai ◽  
Chairat Siripatana ◽  
Sompong O-Thong ◽  
Norli Ismail

The three identical lab-scale upflow anaerobic sludge blanket (UASB) reactors were operated continuously for treating cannery seafood wastewater at seven hydraulic retention times (HRTs) of 5, 4, 3, 2, 1, 0.5 and 0.25 days. The different of granule sizes from three sources: a cassava factory (CS), a seafood factory (SS), and a palm oil mill (PS), average sizes in the range 1.5-1.7, 0.7-1.0 and 0.1-0.2 mm respectively were used as inocula for anaerobic digestion. The UASB-R1 used only granules from seafood factory (R1-SS), the UASB-R2 used mixed granules from seafood with cassava factory (R2-SS+CS) and the UASB-R3 used mixed granules from seafood factory with palm oil mill (R3-SS+PS). In this study selected mathematical models including Monod, Contois, Grau second-order and modified Stover-Kicannon kinetic models were applied to determine the substrate removal kinetics of UASB reactor. Kinetic parameters were determined through linear regression using experimental data obtained from the steady-state experiment and subsequently used to predict effluent COD. The results showed that Grau second-order and modified Stover-Kicannon kinetic models were more suitable than that of others for predicting the effluent COD, with high the correlation coefficient (R2). In addition, the UASB-R2 from mixed granules with cassava factory (SS+CS) gave the best performance and highest coefficient value.


1997 ◽  
Vol 36 (6-7) ◽  
pp. 433-440 ◽  
Author(s):  
Lalit K. Agrawal ◽  
Yasuhiro Ohashi ◽  
Etsuo Mochida ◽  
Hiroyuki Okui ◽  
Yasuko Ueki ◽  
...  

The treatability of raw sewage in a temperate climate (wintertime around 10–20°C) using an upflow anaerobic sludge blanket (UASB) reactor and the hanging sponge cubes process was evaluated. After being seeded with digested sewage sludge, a 47.1 L UASB reactor was continuously operated for more than 2 years by feeding raw sewage, which had average COD around 300 mg/L (41% soluble). During summertime at an HRT of 7 h, effluent COD approximately 70 mg/L total, 50 mg/L soluble and BOD5 20 mg/L total, 12 mg/L soluble was obtained. During wintertime also, treatment efficiency and process stability was good. With the hanging sponge cubes process using the effluent of the UASB reactor treating raw sewage, the following results were obtained. The ammonia oxidation rates of 1.9 and 3.5 g NH4-N·m−2·d−1 in a downflow hanging sponge cubes biofilter, under natural air intake only were obtained during wintertime and summertime, respectively. With post-denitrification and an external carbon source, 84% in average N (NO3+NO2) was removed with an HRT of less than 1 hour and in the temperature range of 13 to 30°C using an upflow submerged hanging sponge bed bioreactor, under anaerobic conditions. The overall system using a UASB reactor and the hanging sponge cubes process could be quite an attractive treatment alternative.


2021 ◽  
Author(s):  
Perla Gonzalez ◽  
Ana Aguilar Ruiz ◽  
Andrea Reynosa Varela ◽  
Ulises Durán Hinojosa ◽  
Marco Garzón Zuñiga ◽  
...  

Abstract This study focused on evaluating different support media for COD and nitrogen compound removal from an Upflow Anaerobic Sludge Blanket (UASB) reactor fed with swine wastewater. Maximum specific nitrification (MSNA) and denitrification (MSDA) activity tests were performed in two fixed-film systems with (1) polyurethane foam (R1) and (2) polyethylene rings (R2). The results showed that the R2 system performed more efficiently than R1, reaching organic matter removal of 77 ± 8% and nitrogen of 98 ± 4%, attributed to higher specific denitrifying activity recorded (5.3 ± 0.34 g NO3--N/g VTS ∙h). In this sense, MSDA tests indicated that the suspended biomass was responsible for at least 70% of nitrogen removal in the form of ammonium compared with 20% attributed to biomass in the form of biofilm. On the other hand, 40 ± 5% of initial nitrogen could not be quantified in the system effluents, but 10 ± 1% was attributed to loss by volatilization. According to the analyses, the previous information infers the development of simultaneous nitrification-denitrification (SND) routes. Respect to the analyses of microbial diversity and abundance in the biofilm of R2 rings, the presence of the genus Pseudomonas dominated the prokaryotic community of the system in 54.4%.


Sign in / Sign up

Export Citation Format

Share Document