Electron Microscopy of Protein-Nucleic Acid Complexes: Uniform Spreading of Flexible Complexes, Staining with a Uniform Thin Layer of Uranyl Acetate, and Determining Helix Handedness

2003 ◽  
pp. 579-587
Author(s):  
Carla W. Gray
Keyword(s):  
Electron Microscopy ◽  
Nucleic Acid ◽  
Thin Layer ◽  
Uranyl Acetate ◽  
Protein Nucleic Acid

Electron Microscopy of Unstained Biomacromolecules

1969 ◽  
Vol 27 ◽  
pp. 264-265
Author(s):  
A.K. Kleinschmidt ◽  
C. Vasquez
Keyword(s):  
Electron Microscopy ◽  
Nucleic Acid ◽  
Carbon Film ◽  
Carbon Support ◽  
Uranyl Acetate ◽  
High Contrast ◽  
Thin Carbon ◽  
New Procedures ◽  
Contrast Studies

The high contrast studies of nucleic acid filaments and proteins applying acetonic solutions of uranyl acetate (10-4) have developed new procedures to observe the macromolecules under similar conditions omitting the stain at low (≤ 104 times) or high (≥105 times) magnifications. The most improving step is choosing extremely thin carbon support films, which are backed by a heavy collodion layer. The collodion is removed from the carbon film by "melting" in an oven (c. 180°C, 10 min.), after the mounting of macromolecules is completed. The thickness on the carbon film was estimated by ellipsometry to range below 70 Å.

Platinum Compounds as Stains for Electron Microscopy

1974 ◽  
Vol 32 ◽  
pp. 230-231
Author(s):  
S. K. Aggarwal ◽  
P. McAllister ◽  
R. W. Wagner ◽  
B. Rosenberg
Keyword(s):  
Electron Microscopy ◽  
Hela Cells ◽  
Uranyl Acetate ◽  
Sarcoma 180 ◽  
Platinum Compounds ◽  
Kb Cells ◽  
En Bloc ◽  
Human Lymphoma ◽  
Ultrathin Sections ◽  
Blue Coloration

Uranyl acetate has been used as an electron stain for en bloc staining as well as for staining ultrathin sections in conjunction with various lead stains (Fig. 1). Present studies reveal that various platinum compounds also show promise as electron stains. Certain platinum compounds have been shown to be effective anti-tumor agents. Of particular interest are the compounds with either uracil or thymine as one of the ligands (cis-Pt(II)-uracil; cis-Pt(II)-thymine). These compounds are amorphous, highly soluble in water and often exhibit an intense blue coloration. These compounds show enough electron density to be used as stains for electron microscopy. Most of the studies are based on various cell lines (human AV, cells, human lymphoma cells, KB cells, Sarcoma-180 ascites cells, chick fibroblasts and HeLa cells) while studies on tissue blocks are in progress.

Localization of immunolabels by electron microscopy and image averaging

1983 ◽  
Vol 41 ◽  
pp. 282-283
Author(s):  
J. Frank ◽  
P.-Y. Sizaret ◽  
A. Verschoor ◽  
J. Lamy
Keyword(s):  
Electron Microscopy ◽  
Single Particle ◽  
Attachment Site ◽  
Uranyl Acetate ◽  
Limulus Polyphemus ◽  
Resolution Limit ◽  
Electron Microscopic ◽  
Image Averaging ◽  
Top View ◽  
Better Than

The accuracy with which the attachment site of immunolabels bound to macromolecules may be localized in electron microscopic images can be considerably improved by using single particle averaging. The example studied in this work showed that the accuracy may be better than the resolution limit imposed by negative staining (∽2nm).The structure used for this demonstration was a halfmolecule of Limulus polyphemus (LP) hemocyanin, consisting of 24 subunits grouped into four hexamers. The top view of this structure was previously studied by image averaging and correspondence analysis. It was found to vary according to the flip or flop position of the molecule, and to the stain imbalance between diagonally opposed hexamers (“rocking effect”). These findings have recently been incorporated into a model of the full 8 × 6 molecule.LP hemocyanin contains eight different polypeptides, and antibodies specific for one, LP II, were used. Uranyl acetate was used as stain. A total of 58 molecule images (29 unlabelled, 29 labelled with antl-LPII Fab) showing the top view were digitized in the microdensitometer with a sampling distance of 50μ corresponding to 6.25nm.

Electron Microscopy of Cytoplasmic Contractile Proteins

1978 ◽  
Vol 36 (3) ◽  
pp. 606-614 ◽  
Author(s):  
T.D. Pollard ◽  
P. Maupin
Keyword(s):  
Electron Microscopy ◽  
Actin Filaments ◽  
Three Dimensional ◽  
Uranyl Acetate ◽  
Contractile Proteins ◽  
Dimensional Structure ◽  
X Ray Diffraction ◽  
Cytoplasmic Matrix ◽  
Computer Image Processing ◽  
Nonmuscle Cells

In this paper we review some of the contributions that electron microscopy has made to the analysis of actin and myosin from nonmuscle cells. We place particular emphasis upon the limitations of the ultrastructural techniques used to study these cytoplasmic contractile proteins, because it is not widely recognized how difficult it is to preserve these elements of the cytoplasmic matrix for electron microscopy. The structure of actin filaments is well preserved for electron microscope observation by negative staining with uranyl acetate (Figure 1). In fact, to a resolution of about 3nm the three-dimensional structure of actin filaments determined by computer image processing of electron micrographs of negatively stained specimens (Moore et al., 1970) is indistinguishable from the structure revealed by X-ray diffraction of living muscle.

Uranyl Acetate and Rotary Shadowing to Increase the Contrast of Small Aggregated Virus Particles

1969 ◽  
Vol 27 ◽  
pp. 424-425
Author(s):  
Lee F. Ellis ◽  
Richard M. Van Frank ◽  
Walter J. Kleinschmidt
Keyword(s):  
Electron Microscopy ◽  
Tissue Culture ◽  
Density Gradient ◽  
Density Gradient Centrifugation ◽  
Gradient Centrifugation ◽  
Uranyl Acetate ◽  
Interferon Inducer ◽  
Virus Particles ◽  
Staining Methods ◽  
Rotary Shadowing

The extract from Penicillum stoliniferum, known as statolon, has been purified by density gradient centrifugation. These centrifuge fractions contained virus particles that are an interferon inducer in mice or in tissue culture. Highly purified preparations of these particles are difficult to enumerate by electron microscopy because of aggregation. Therefore a study of staining methods was undertaken.

Applications of Photoelectron Microscopy

1976 ◽  
Vol 34 ◽  
pp. 506-507
Author(s):  
William J. Baxter
Keyword(s):  
Electron Microscopy ◽  
Thermal Decomposition ◽  
Chemical Composition ◽  
Ultraviolet Radiation ◽  
Thin Layer ◽  
Edge Effects ◽  
Electron Optics ◽  
Surface Layers ◽  
Crystalline Orientation ◽  
Fluorescent Screen

In this form of electron microscopy, photoelectrons emitted from a metal by ultraviolet radiation are accelerated and imaged onto a fluorescent screen by conventional electron optics. image contrast is determined by spatial variations in the intensity of the photoemission. The dominant source of contrast is due to changes in the photoelectric work function, between surfaces of different crystalline orientation, or different chemical composition. Topographical variations produce a relatively weak contrast due to shadowing and edge effects.Since the photoelectrons originate from the surface layers (e.g. ∼5-10 nm for metals), photoelectron microscopy is surface sensitive. Thus to see the microstructure of a metal the thin layer (∼3 nm) of surface oxide must be removed, either by ion bombardment or by thermal decomposition in the vacuum of the microscope.

Reconstruction of Two-Dimensional Projections of GP 32*I

1981 ◽  
Vol 39 ◽  
pp. 38-39
Author(s):  
H.A. Cohen ◽  
W. Chiu ◽  
J. Hosoda
Keyword(s):  
Electron Microscopy ◽  
Molecular Weight ◽  
Uranyl Acetate ◽  
Distilled Water ◽  
Acetate Solution ◽  
Two Dimensional ◽  
Parent Molecule ◽  
T4 Bacteriophage ◽  
Electron Imaging ◽  
Better Than

GP 32 (molecular weight 35000) is a T4 bacteriophage protein that destabilizes the DNA helix. The fragment GP32*I (77% of the total weight), which destabilizes helices better than does the parent molecule, crystallizes as platelets thin enough for electron diffraction and electron imaging. In this paper we discuss the structure of this protein as revealed in images reconstructed from stained and unstained crystals.Crystals were prepared as previously described. Crystals for electron microscopy were pelleted from the buffer suspension, washed in distilled water, and resuspended in 1% glucose. Two lambda droplets were placed on grids over freshly evaporated carbon, allowed to sit for five minutes, and then were drained. Stained crystals were prepared the same way, except that prior to draining the droplet, two lambda of aqueous 1% uranyl acetate solution were applied for 20 seconds. Micrographs were produced using less than 2 e/Å2 for unstained crystals or less than 8 e/Å2 for stained crystals.

Sign in / Sign up

Export Citation Format

Share Document