scholarly journals Excess pore pressure generation and post-cyclic loading settlement of geofiber-reinforced sand

2018 ◽  
Vol 70 (1) ◽  
pp. 11-18 ◽  
2018 ◽  
Vol 55 (5) ◽  
pp. 689-697 ◽  
Author(s):  
Anna Mamou ◽  
Jeffrey A. Priest ◽  
Christopher R.I. Clayton ◽  
William Powrie

This paper presents results of a series of hollow cylinder tests carried out to investigate the undrained behaviour of saturated railway track foundation materials during cyclic loading involving principal stress rotation. Four sand–clay mixes representative of real railway track foundation materials were investigated. It was found that moderate additions of clay (up to ∼14% by weight) increased the cyclic shear stress threshold at which significant excess pore pressures started to accumulate. After the cyclic shear stress threshold had been exceeded, the rate of pore pressure increase with the logarithm of axial strain was greatest for the material having a clay content of 11%. Excess pore pressure generation reduced with increasing intergranular and global void ratio, with the global void ratio being perhaps the more useful indicator because of the reduced amount of scatter and higher correlation of the idealized relationship.


2012 ◽  
Vol 446-449 ◽  
pp. 1940-1943
Author(s):  
Yang Liu ◽  
Hong Xiang Yan

Numerical simulation of vibro-stone column is taken to simulate the installation of vibro-stone column. A relationship based on test is adopted to calculate the excess pore pressure induced by vibratory energy during the installation of vibro-stone column. A numerical procedure is developed based on the formula and Terzaghi-Renduric consolidation theory. Finally numerical results of composite stone column are compared single stone column.


2020 ◽  
Author(s):  
Davide Mencaroni ◽  
Roger Urgeles ◽  
Jonathan Ford ◽  
Jaume Llopart ◽  
Cristina Sànchez Serra ◽  
...  

<p>Contourite deposits are generated by the interplay between deepwater bottom-currents, sediment supply and seafloor topography. The Gulf of Cadiz, in the Southwest Iberian margin, is a famous example of extensive contourite deposition driven by the Mediterranean Outflow Water (MOW), which exits the Strait of Gibraltar, flows northward following the coastline and distributes the sediments coming from the Guadalquivir and Guadiana rivers. The MOW and related contourite deposits affect the stability of the SW Iberian margin in several ways: on one hand it increases the sedimentation rate, favoring the development of excess pore pressure, while on the other hand, by depositing sand it allows pore water pressure to dissipate, potentially increasing the stability of the slope.</p><p>In the Gulf of Cadiz, grain size distribution of contourite deposits is influenced by the seafloor morphology, which splits the MOW in different branches, and by the alternation of glacial and interglacial periods that affected the MOW hydrodynamic regimes. Fine clay packages alternates with clean sand formations according to the capacity of transport of the bottom-current in a specific area. Generally speaking, coarser deposits are found in the areas of higher MOW flow energy, such as in the shallower part of the slope or in the area closer to the Strait of Gibraltar, while at higher water depths the sedimentation shifts to progressively finer grain sizes as the MOW gets weaker. Previous works show that at present-day the MOW flows at a maximum depth of 1400 m, while during glacial periods the bottom-current could have reached higher depths.</p><p>In this study we derived the different maximum depths at which the MOW flowed by analyzing the distribution of sands at different depths along the Alentejo basin slope, in the Northern sector of the Gulf of Cadiz.</p><p>Here we show how changes in sand distribution along slope, within the stratigraphic units deposited between the Neogene and the present day, are driven by glacial – interglacial period alternation that influenced the hydrodynamic regime of the MOW.</p><p>By deriving the depositional history of sand in the Alentejo basin, we are able to correlate directly the influence that climatic cycles had on the MOW activity. Furthermore, by interpreting new multi-channel seismic profiles we have been able to derive a detailed facies characterization of the uppermost part of the Gulf of Cadiz.</p><p>An accurate definition of sand distribution along slope plays an important role in evaluating the stability of the slope itself, e.g. to understand if the sediments may be subjected to excess pore pressure generation. As sand distribution is a direct function of the bottom-current transport capacity, the ultimate goal of this study is to understand how climate variations can affect the stability of submarine slope by depositing contourite-related sand.</p>


2018 ◽  
Vol 55 (12) ◽  
pp. 1756-1768
Author(s):  
Jahanzaib Israr ◽  
Buddhima Indraratna

This paper presents results from a series of piping tests carried out on a selected range of granular filters under static and cyclic loading conditions. The mechanical response of filters subjected to cyclic loading could be characterized in three distinct phases; namely, (I) pre-shakedown, (II) post-shakedown, and (III) post-critical (i.e., the occurrence of internal erosion). All the permanent geomechanical changes such, as erosion, permeability variations, and axial strain developments, took place during phases I and III, while the specimen response remained purely elastic during phase II. The post-critical occurrence of erosion incurred significant settlement that may not be tolerable for high-speed railway substructures. The analysis revealed that a cyclic load would induce excess pore-water pressure, which, in corroboration with steady seepage forces and agitation due to dynamic loading, could then cause internal erosion of fines from the specimens. The resulting excess pore pressure is a direct function of the axial strain due to cyclic densification, as well as the loading frequency and reduction in permeability. A model based on strain energy is proposed to quantify the excess pore-water pressure, and subsequently validated using current and existing test results from published studies.


Geofluids ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-12 ◽  
Author(s):  
Hung-Ming Lin ◽  
Jian-Hong Wu ◽  
Erik Sunarya

A new consolidated undrained ring shear test capable of measuring the pore pressures is presented to investigate the initiation mechanism of the Hsien-du-shan rock avalanche, triggered by Typhoon Morakot, in southern Taiwan. The postpeak state of the landslide surface between the Tangenshan sandstone and the remolded landslide gouge is discussed to address the unstable geomorphological precursors observed before the landslide occurred. Experimental results show that the internal friction angle of the high water content sliding surface in the total stress state, between 25.3 and 26.1°, clarifies the reason of the stable slope prior to Typhoon Morakot. In addition, during the ring shear tests, it is observed that the excess pore pressure is generated by the shear contractions of the sliding surface. The remolded landslide gouge, sheared under the high normal stress, rendered results associated with high shear strength, small shear contraction, low hydraulic conductivity, and continuous excess pore pressure. The excess pore pressure feedback at the sliding surface may have accelerated the landslide.


2019 ◽  
Vol 9 (18) ◽  
pp. 3821 ◽  
Author(s):  
Andrzej Głuchowski ◽  
Emil Soból ◽  
Alojzy Szymański ◽  
Wojciech Sas

Cohesive soils subjected to cyclic loading in undrained conditions respond with pore pressure generation and plastic strain accumulation. The article focus on the pore pressure development of soils tested in isotropic and anisotropic consolidation conditions. Due to the consolidation differences, soil response to cyclic loading is also different. Analysis of the cyclic triaxial test results in terms of pore pressure development produces some indication of the relevant mechanisms at the particulate level. Test results show that the greater susceptibility to accumulate the plastic strain of cohesive soil during cyclic loading is connected with the pore pressure generation pattern. The value of excess pore pressure required to soil sample failure differs as a consequence of different consolidation pressure and anisotropic stress state. Effective stresses and pore pressures are the main factors that govern the soil behavior in undrained conditions. Therefore, the pore pressure generated in the first few cycles plays a key role in the accumulation of plastic strains and constitutes the major amount of excess pore water pressure. Soil samples consolidated in the anisotropic and isotropic stress state behave differently responding differently to cyclic loading. This difference may impact on test results analysis and hence may change the view on soil behavior. The results of tests on isotropically and anisotropically consolidated soil samples are discussed in this paper in order to point out the main features of the cohesive soil behavior.


Sign in / Sign up

Export Citation Format

Share Document