Relationships between macrosynoptic weather types and development of the thermal excess in suburban areas in Debrecen, Hungary

2014 ◽  
Vol 5 (2) ◽  
pp. 167-172
Author(s):  
S. Szegedi ◽  
I. Lázár ◽  
T. Tóth

Impacts of macrosynoptic weather patterns on the development of the thermal excess in suburban areas of Debrecen are examined in this paper. Temperature datasets have been recorded at two heights by three automatic weather stations mounted in Debrecen (east Hungary) and a small settlement in its vicinity. An additional automatic weather station is used as a reference station outside Debrecen. Urban heat island (UHI) intensities have been calculated from the raw datasets. Impacts of synoptic conditions have been analyzed on the base of Péczely’s macrosynoptic types. It has been found that anticyclone types are more favorable from the aspect of UHI development, while cyclone types, especially the passage of warm fronts can effectively hinder the formation of strong heat islands in Debrecen.

Author(s):  
Valdiney José da Silva ◽  
Cláudio Ricardo da Silva ◽  
Leandro Da Silva Almeida ◽  
Claudionor Ribeiro da Silva ◽  
Hudson De Paula Carvalho ◽  
...  

The “heat island” phenomenon is one of many serious problems caused by rapid urban growth. This study therefore sought to characterize and quantify heat islands in Uberlandia, to evaluate the seasonality of these islands (winter-summer) and to identify the effect of surface coverage on their intensity. To identify intra-urban heat islands in Uberlandia, air temperature data were collected in two seasons (winter and summer) using mobile and fixed transects seasons. Transition measurements were recorded automatically every 0.5 seconds using a car-mounted thermos-hygrometer moving at an average of 40 km h-1. GPS was used to select approximately ten data points every 500 meters of each transect. Fixed weather stations measured air temperature at three sites in the region. Transect data analysis showed that the intra-urban heat islands were more intense in winter (ΔT = 2.2ºC) than in summer (ΔT = 1.2ºC) mainly because by reduction in atmospheric vapor in winter (dry season) and by higher rate of radiative cooling that is favored in permeable areas. The methodology used in the present study proved to be a quick and efficient way to carry out this type of monitoring.


2013 ◽  
Vol 135 (2) ◽  
Author(s):  
Kaufui V. Wong ◽  
Andrew Paddon ◽  
Alfredo Jimenez

Medical and health researchers have shown that fatalities during heat waves are most commonly due to respiratory and cardiovascular diseases, primarily from heat's negative effect on the cardiovascular system. In an attempt to control one's internal temperature, the body’s natural instinct is to circulate large quantities of blood to the skin. However, to perform this protective measure against overheating actually harms the body by inducing extra strain on the heart. This excess strain has the potential to trigger a cardiac event in those with chronic health problems, such as the elderly, Cui et al. Frumkin showed that the relationship of mortality and temperature creates a J-shaped function, showing a steeper slope at higher temperatures. Records show that more casualties have resulted from heat waves than hurricanes, floods, and tornadoes together. This statistic’s significance is that extreme heat events (EHEs) are becoming more frequent, as shown by Stone et al. Their analysis shows a growth trend of EHEs by 0.20 days/year in U.S. cities between 1956 and 2005, with a 95% confidence interval and uncertainty of ±0.6. This means that there were 10 more days of extreme heat conditions in 2005 than in 1956. Studies held from 1989 to 2000 in 50 U.S. cities recorded a rise of 5.7% in mortality during heat waves. The research of Schifano et al. revealed that Rome’s elderly population endures a higher mortality rate during heat waves, at 8% excess for the 65–74 age group and 15% for above 74. Even more staggering is findings of Dousset et al. on French cities during the 2003 heat wave. Small towns saw an average excess mortality rate of 40%, while Paris witnessed an increase of 141%. During this period, a 0.5 °C increase above the average minimum nighttime temperature doubled the risk of death in the elderly. Heat-related illnesses and mortality rates have slightly decreased since 1980, regardless of the increase in temperatures. Statistics from the U.S. Census state that the U.S. population without air conditioning saw a drop of 32% from 1978 to 2005, resting at 15%. Despite the increase in air conditioning use, a study done by Kalkstein through 2007 proved that the shielding effects of air conditioning reached their terminal effect in the mid-1990s. Kan et al. hypothesize in their study of Shanghai that the significant difference in fatalities from the 1998 and 2003 heat waves was due to the increase in use of air conditioning. Protective factors have mitigated the danger of heat on those vulnerable to it, however projecting forward the heat increment related to sprawl may exceed physiologic adaptation thresholds. It has been studied and reported that urban heat islands (UHI) exist in the following world cities and their countries and/or states: Tel-Aviv, Israel, Newark, NJ, Madrid, Spain, London, UK, Athens, Greece, Taipei, Taiwan, San Juan, Puerto Rico, Osaka, Japan, Hong Kong, China, Beijing, China, Pyongyang, North Korea, Bangkok, Thailand, Manila, Philippines, Ho Chi Minh City, Vietnam, Seoul, South Korea, Muscat, Oman, Singapore, Houston, USA, Shanghai, China, Wroclaw, Poland, Mexico City, Mexico, Arkansas, Atlanta, USA, Buenos Aires, Argentina, Kenya, Brisbane, Australia, Moscow, Russia, Los Angeles, USA, Washington, DC, USA, San Diego, USA, New York, USA, Chicago, USA, Budapest, Hungary, Miami, USA, Istanbul, Turkey, Mumbai, India, Shenzen, China, Thessaloniki, Greece, Rotterdam, Netherlands, Akure, Nigeria, Bucharest, Romania, Birmingham, UK, Bangladesh, and Delhi, India. The strongest being Shanghai, Bangkok, Beijing, Tel-Aviv, and Tokyo with UHI intensities (UHII) of 3.5–7.0, 3.0–8.0, 5.5–10, 10, and 12 °C, respectively. Of the above world cities, Hong Kong, Bangkok, Delhi, Bangladesh, London, Kyoto, Osaka, and Berlin have been linked to increased mortality rates due to the heightened temperatures of nonheat wave periods. Chan et al. studied excess mortalities in cities such as Hong Kong, Bangkok, and Delhi, which currently observe mortality increases ranging from 4.1% to 5.8% per 1 °C over a temperature threshold of approximately 29 °C. Goggins et al. found similar data for the urban area of Bangladesh, which showed an increase of 7.5% in mortality for every 1 °C the mean temperature was above a similar threshold. In the same study, while observing microregions of Montreal portraying heat island characteristics, mortality was found to be 28% higher in heat island zones on days with a mean temperature of 26 °C opposed to 20 °C compared to a 13% increase in colder areas.


2017 ◽  
Vol 17 (8) ◽  
pp. 5439-5457 ◽  
Author(s):  
Shi Zhong ◽  
Yun Qian ◽  
Chun Zhao ◽  
Ruby Leung ◽  
Hailong Wang ◽  
...  

Abstract. The WRF-Chem model coupled with a single-layer urban canopy model (UCM) is integrated for 5 years at convection-permitting scale to investigate the individual and combined impacts of urbanization-induced changes in land cover and pollutant emissions on regional climate in the Yangtze River Delta (YRD) region in eastern China. Simulations with the urbanization effects reasonably reproduced the observed features of temperature and precipitation in the YRD region. Urbanization over the YRD induces an urban heat island (UHI) effect, which increases the surface temperature by 0.53 °C in summer and increases the annual heat wave days at a rate of 3.7 d yr−1 in the major megacities in the YRD, accompanied by intensified heat stress. In winter, the near-surface air temperature increases by approximately 0.7 °C over commercial areas in the cities but decreases in the surrounding areas. Radiative effects of aerosols tend to cool the surface air by reducing net shortwave radiation at the surface. Compared to the more localized UHI effect, aerosol effects on solar radiation and temperature influence a much larger area, especially downwind of the city cluster in the YRD. Results also show that the UHI increases the frequency of extreme summer precipitation by strengthening the convergence and updrafts over urbanized areas in the afternoon, which favor the development of deep convection. In contrast, the radiative forcing of aerosols results in a surface cooling and upper-atmospheric heating, which enhances atmospheric stability and suppresses convection. The combined effects of the UHI and aerosols on precipitation depend on synoptic conditions. Two rainfall events under two typical but different synoptic weather patterns are further analyzed. It is shown that the impact of urban land cover and aerosols on precipitation is not only determined by their influence on local convergence but also modulated by large-scale weather systems. For the case with a strong synoptic forcing associated with stronger winds and larger spatial convergence, the UHI and aerosol effects are relatively weak. When the synoptic forcing is weak, however, the UHI and aerosol effects on local convergence dominate. This suggests that synoptic forcing plays a significant role in modulating the urbanization-induced land-cover and aerosol effects on individual rainfall event. Hence precipitation changes due to urbanization effects may offset each other under different synoptic conditions, resulting in little changes in mean precipitation at longer timescales.


Author(s):  
Pieter Snyman ◽  
A. Stephen Steyn

Urban heat islands (UHIs) are characterised by warmer urban air temperatures compared to rural air temperatures, and the intensity is equal to the difference between the two. Air temperatures are measured at various sites across the city of Bloemfontein and then analysed to determine the UHI characteristics. The UHI is found to have a horseshoe shape and reaches a maximum intensity of 8.2 °C at 22:00. The UHI is largely affected by the local topography.


1979 ◽  
Vol 89 ◽  
pp. 13-25
Author(s):  
James A. Hughes

The role of urban heat islands in producing systematic isopycnic tilts is explored in more detail, and with greater rigor, than in Part I of this series. (Perth, 1974).Specifically, a three dimensional integration is carried out, and light rays are, in effect, “traced” through the resulting perturbation field by evaluating the integral of anomalous refraction. This is done for various values of the parameters, viz., wind direction and observatory location relative to the heat island, strength of the central perturbation, zenith distance of the observed object, etc.It is stressed that heat islands are not the only source of such systematic effects.Finally, a brief discussion of some possible methods of determining observationally the effects here treated theoretically, as well as other site dependent effects, is appended.


Atmosphere ◽  
2020 ◽  
Vol 11 (6) ◽  
pp. 611
Author(s):  
Donna Cortez ◽  
Rodrigo Padilla ◽  
Sebastián Herrera ◽  
Juan Uribe ◽  
Manuel Paneque

Climate information is crucial to the management and profitability of key development sectors involving agriculture, hydrologic resources, natural hazards, and energy. Climate knowledge, real-time weather information, and climate predictions reliability all contribute to the planning and management of socioeconomic activities and sustainable development. Automatic weather stations (AWSs) are remotely operated and facilitate the recording of meteorological information for unoccupied and out-of-reach areas. However, the representative area of the Atacama region is unknown, whose uniqueness is largely determined by the topography of the terrain. This paper describes the topoclimatic zoning of the Atacama region, based on the identification of homogeneous climatic and topographic areas, using climatic information, principal component analysis, and cluster analysis. Topoclimatic zoning was used to determine the representative area of the AWSs. Sixty-one regional topographic units were identified as equivalent to the representative area of the AWS. The directly represented area was estimated at 2365 km2 (3.13% of the regional total), the indirectly represented area was 8725 km2 (11.53%), and the unrepresented area was 64,561 km2 (85.34%). This large unrepresented area displays potential zones for future AWS installations, which can improve both the efficiency of the regional meteorological network and access to quality climate information.


Author(s):  
Tao Chen ◽  
Anchang Sun ◽  
Ruiqing Niu

Man-made materials now cover a dominant proportion of urban areas, and such conditions not only change the absorption of solar radiation, but also the allocation of the solar radiation and cause the surface urban heat island effect, which is considered a serious problem associated with the deterioration of urban environments. Although numerous studies have been performed on surface urban heat islands, only a few have focused on the effect of land cover changes on surface urban heat islands over a long time period. Using six Landsat image scenes of the Metropolitan Development Area of Wuhan, our experiment (1) applied a mapping method for normalized land surface temperatures with three land cover fractions, which were impervious surfaces, non-chlorophyllous vegetation and soil and vegetation fractions, and (2) performed a fitting analysis of fierce change areas in the surface urban heat island intensity based on a time trajectory. Thematic thermal maps were drawn to analyze the distribution of and variations in the surface urban heat island in the study area. A Multiple Endmember Spectral Mixture Analysis was used to extract the land cover fraction information. Then, six ternary triangle contour graphics were drawn based on the land surface temperature and land cover fraction information. A time trajectory was created to summarize the changing characteristics of the surface urban heat island intensity. A fitting analysis was conducted for areas showing fierce changes in the urban heat intensity. Our results revealed that impervious surfaces had the largest impacts on surface urban heat island intensity, followed by the non-chlorophyllous vegetation and soil fraction. Moreover, the results indicated that the vegetation fraction can alleviate the occurrence of surface urban heat islands. These results reveal the impact of the land cover fractions on surface urban heat islands. Urban expansion generates impervious artificial objects that replace pervious natural objects, which causes an increase in land surface temperature and results in a surface urban heat island.


Sign in / Sign up

Export Citation Format

Share Document