Application of a Position Sensitive Atom Probe to the Analysis of the Chemistry and Morphology Of Multi-Quantum Well Interfaces

1988 ◽  
Vol 138 ◽  
Author(s):  
Alfred Cerezo ◽  
J. Alex Liddle ◽  
Chris R.M. Grovenor ◽  
Andrew G. Norman ◽  
George D.W. Smith
1989 ◽  
Vol 139 ◽  
Author(s):  
Alfred Cerezo ◽  
J. Alex Liddle ◽  
Chris R.M. Grovenor ◽  
Andrew G. Norman ◽  
George D.W. Smith

Author(s):  
RAD Mackenzie ◽  
G D W Smith ◽  
A. Cerezo ◽  
J A Liddle ◽  
CRM Grovenor ◽  
...  

The position sensitive atom probe (POSAP), described briefly elsewhere in these proceedings, permits both chemical and spatial information in three dimensions to be recorded from a small volume of material. This technique is particularly applicable to situations where there are fine scale variations in composition present in the material under investigation. We report the application of the POSAP to the characterisation of semiconductor multiple quantum wells and metallic multilayers.The application of devices prepared from quantum well materials depends on the ability to accurately control both the quantum well composition and the quality of the interfaces between the well and barrier layers. A series of metal organic chemical vapour deposition (MOCVD) grown GaInAs-InP quantum wells were examined after being prepared under three different growth conditions. These samples were observed using the POSAP in order to study both the composition of the wells and the interface morphology. The first set of wells examined were prepared in a conventional reactor to which a quartz wool baffle had been added to promote gas intermixing. The effect of this was to hold a volume of gas within the chamber between growth stages, leading to a structure where the wells had a composition of GalnAsP lattice matched to the InP barriers, and where the interfaces were very indistinct. A POSAP image showing a well in this sample is shown in figure 1. The second set of wells were grown in the same reactor but with the quartz wool baffle removed. This set of wells were much better defined, as can be seen in figure 2, and the wells were much closer to the intended composition, but still with measurable levels of phosphorus. The final set of wells examined were prepared in a reactor where the design had the effect of minimizing the recirculating volume of gas. In this case there was again further improvement in the well quality. It also appears that the left hand side of the well in figure 2 is more abrupt than the right hand side, indicating that the switchover at this interface from barrier to well growth is more abrupt than the switchover at the other interface.


1989 ◽  
Vol 54 (16) ◽  
pp. 1555-1557 ◽  
Author(s):  
J. A. Liddle ◽  
A. G. Norman ◽  
A. Cerezo ◽  
C. R. M. Grovenor

2021 ◽  
Vol 118 (22) ◽  
pp. 221103
Author(s):  
P. Schmiedeke ◽  
A. Thurn ◽  
S. Matich ◽  
M. Döblinger ◽  
J. J. Finley ◽  
...  

2005 ◽  
Vol 87 (11) ◽  
pp. 111908 ◽  
Author(s):  
L. S. Wang ◽  
S. Tripathy ◽  
S. J. Chua ◽  
K. Y. Zang

2007 ◽  
Vol 17 (01) ◽  
pp. 81-84
Author(s):  
J. Senawiratne ◽  
M. Zhu ◽  
W. Zhao ◽  
Y. Xia ◽  
Y. Li ◽  
...  

Optical properties of green emission Ga 0.80 In 0.20 N/GaN multi-quantum well and light emitting diode have been investigated by using photoluminescence, cathodoluminescence, electroluminescence, and photoconductivity. The temperature dependent photoluminescence and cathodoluminescence studies show three emission bands including GaInN/GaN quantum well emission centered at 2.38 eV (~ 520 nm). The activation energy of the non-radiative recombination centers was found to be ~ 60 meV. The comparison of photoconductivity with luminescence spectroscopy revealed that optical properties of quantum well layers are strongly affected by the quantum-confined Stark effect.


Author(s):  
P. Kung ◽  
A. Saxler ◽  
D. Walker ◽  
A. Rybaltowski ◽  
Xiaolong Zhang ◽  
...  

We report the growth, fabrication and characterization of GaInN/GaN multi-quantum well lasers grown on (00·1) sapphire substrates by low pressure metalorganic chemical vapor deposition. The threshold current density of a 1800 μm long cavity length laser was 1.4 kA/cm2 with a threshold voltage of 25 V. These lasers exhibited series resistances of 13 and 14 Ω at 300 and 79 K, respectively.


Sign in / Sign up

Export Citation Format

Share Document