The Study of Seam Line Defects in Silicon-On-Oxide by Merged Epitaxial Lateral Overgrowth

1993 ◽  
Vol 317 ◽  
Author(s):  
Yangchin Shih ◽  
J. C. Lou ◽  
W. G. Oldham
Keyword(s):  
Epitaxial Film ◽  
Single Crystal Silicon ◽  
Silicon On Insulator ◽  
Epitaxial Lateral Overgrowth ◽  
Formation Mechanisms ◽  
Crystal Silicon ◽  
Lateral Overgrowth ◽  
Transmission Electron ◽  
Low Dislocation Density ◽  
Line Defects

ABSTRACTSelective Epitaxial Growth of silicon through windows in SiO2 using low-temperature SiH2Cl2/H2 chemistry in a hot wall LPCVD system was used to form Epitaxial Lateral Overgrowth (ELO) regions of Silicon-on-insulator. In cases where pattern ‘width was less than two times epi film thickness, the ELO regions merged to form a continuous epitaxial film. In this study, 2.5 μm thick single crystal silicon layers were grown perfectly over oxide regions with very low dislocation density (< 104/cm2). The epitaxial Si/oxide interfaces were smooth and defect-free. However, a “seam”-like defect was occasionally observed in the epitaxial film on top of the oxide, at the locations where two growth fronts merged together. This crystallographic defect in some case extends through the whole Silicon-on-Oxide film and would be expected to be detrimental to electronic devices built on or close to it. The sturctures of these seam line defects were investigated in detail by transmission electron Microscopy (TEM). The formation mechanisms of these seam line defects and possible origins are discussed.

Seam line defects in silicon‐on‐insulator by merged epitaxial lateral overgrowth

1994 ◽  
Vol 65 (13) ◽  
pp. 1638-1640 ◽  
Author(s):  
Yang‐Chin Shih ◽  
Jen‐Chung Lou ◽  
William G. Oldham
Keyword(s):  
Silicon On Insulator ◽  
Epitaxial Lateral Overgrowth ◽  
Lateral Overgrowth ◽  
Line Defects

Photoluminescence Characterization of Thin Silicon-On-Insulator Films Produced by Oxygen Implantation

1987 ◽  
Vol 107 ◽  
Author(s):  
J. Weber ◽  
H. Baumgart ◽  
J. Petruzzello ◽  
G.K. Celler
Keyword(s):  
Low Temperature ◽  
Single Crystal Silicon ◽  
Silicon On Insulator ◽  
Crystal Silicon ◽  
Czochralski Silicon ◽  
Transmission Electron ◽  
Processing Step ◽  
Low Temperature Photoluminescence

AbstractSingle crystal silicon films on top of a buried SiO2 layer were produced by implanting 1.7x10180+ions/cm2 at 150keV into (100) Czochralski silicon, followed by annealing at higher temperatures. The defect properties of the layers are studied after each processing step by low temperature photoluminescence measurements and transmission electron micrography (TEM). Dislocation-related photoluminescence signals correlate with their TEM observations in the same samples. The photoluminescence method proves to be a very versatile and convenient method for characterizing the quality of silicon-on-insulat or structures.

EPITAXIAL LATERAL OVERGROWTH OF GaN ON SILICON-ON-INSULATOR

2009 ◽  
Vol 23 (15) ◽  
pp. 1881-1887 ◽  
Author(s):  
BO ZHANG ◽  
JING CHEN ◽  
XI WANG ◽  
AIMIN WU ◽  
JIEXIN LUO ◽  
...  
Keyword(s):  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
Silicon On Insulator ◽  
Epitaxial Lateral Overgrowth ◽  
Micro Raman Spectroscopy ◽  
Lateral Overgrowth ◽  
Transmission Electron ◽  
Single Process ◽  
Soi Substrates

From a single process, GaN layers were laterally overgrown on maskless stripe-patterned (111) silicon-on-insulator (SOI) substrates by metalorganic chemical vapor deposition. The influence of stress on the behavior of dislocations at the coalescence during growth was observed using transmission electron microscopy (TEM). Improvement of the crystalline quality of the GaN layer was demonstrated by TEM and micro-Raman spectroscopy. Furthermore, the benefits of SOI substrates for GaN growth are also discussed.

Analysis of Silicon-On-Insulator Structures Formed By Oxygen Ion Implantation

1985 ◽  
Vol 43 ◽  
pp. 300-301
Author(s):  
N. Lewis ◽  
E. L. Hall ◽  
A. Mogro-Campero ◽  
R. P. Love
Keyword(s):  
Ion Implantation ◽  
Single Crystal ◽  
Single Crystal Silicon ◽  
Silicon Layer ◽  
Device Fabrication ◽  
Silicon On Insulator ◽  
High Dose ◽  
Crystal Silicon ◽  
Oxygen Ion ◽  
Oxygen Ion Implantation

The formation of buried oxide structures in single crystal silicon by high-dose oxygen ion implantation has received considerable attention recently for applications in advanced electronic device fabrication. This process is performed in a vacuum, and under the proper implantation conditions results in a silicon-on-insulator (SOI) structure with a top single crystal silicon layer on an amorphous silicon dioxide layer. The top Si layer has the same orientation as the silicon substrate. The quality of the outermost portion of the Si top layer is important in device fabrication since it either can be used directly to build devices, or epitaxial Si may be grown on this layer. Therefore, careful characterization of the results of the ion implantation process is essential.

TEM characterization of Au/Polysilicon interactions

1990 ◽  
Vol 48 (4) ◽  
pp. 650-651
Author(s):  
N. David Theodore ◽  
Leslie H. Allen ◽  
C. Barry Carter ◽  
James W. Mayer
Keyword(s):  
Solid Phase ◽  
Single Crystal Silicon ◽  
Chemical Vapor ◽  
Electrical Contacts ◽  
Silicon Substrates ◽  
Crystal Silicon ◽  
Transmission Electron ◽  
Polysilicon Films ◽  
The Stability

Metal/polysilicon investigations contribute to an understanding of issues relevant to the stability of electrical contacts in semiconductor devices. These investigations also contribute to an understanding of Si lateral solid-phase epitactic growth. Metals such as Au, Al and Ag form eutectics with Si. reactions in these metal/polysilicon systems lead to the formation of large-grain silicon. Of these systems, the Al/polysilicon system has been most extensively studied. In this study, the behavior upon thermal annealing of Au/polysilicon bilayers is investigated using cross-section transmission electron microscopy (XTEM). The unique feature of this system is that silicon grain-growth occurs at particularly low temperatures ∽300°C).Gold/polysilicon bilayers were fabricated on thermally oxidized single-crystal silicon substrates. Lowpressure chemical vapor deposition (LPCVD) at 620°C was used to obtain 100 to 400 nm polysilicon films. The surface of the polysilicon was cleaned with a buffered hydrofluoric acid solution. Gold was then thermally evaporated onto the samples.

scholarly journals A Flexible PI/Si/SiO2 Piezoresistive Microcantilever for Trace-Level Detection of Aflatoxin B1

Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1118
Author(s):  
Yuan Tian ◽  
Yi Liu ◽  
Yang Wang ◽  
Jia Xu ◽  
Xiaomei Yu
Keyword(s):  
Single Crystal ◽  
Aflatoxin B1 ◽  
Single Crystal Silicon ◽  
Silicon Layer ◽  
Wheatstone Bridge ◽  
Silicon On Insulator ◽  
Passivation Layer ◽  
Spring Constant ◽  
Trace Level ◽  
Crystal Silicon

In this paper, a polyimide (PI)/Si/SiO2-based piezoresistive microcantilever biosensor was developed to achieve a trace level detection for aflatoxin B1. To take advantage of both the high piezoresistance coefficient of single-crystal silicon and the small spring constant of PI, the flexible piezoresistive microcantilever was designed using the buried oxide (BOX) layer of a silicon-on-insulator (SOI) wafer as a bottom passivation layer, the topmost single-crystal silicon layer as a piezoresistor layer, and a thin PI film as a top passivation layer. To obtain higher sensitivity and output voltage stability, four identical piezoresistors, two of which were located in the substrate and two integrated in the microcantilevers, were composed of a quarter-bridge configuration wheatstone bridge. The fabricated PI/Si/SiO2 microcantilever showed good mechanical properties with a spring constant of 21.31 nN/μm and a deflection sensitivity of 3.54 × 10−7 nm−1. The microcantilever biosensor also showed a stable voltage output in the Phosphate Buffered Saline (PBS) buffer with a fluctuation less than 1 μV @ 3 V. By functionalizing anti-aflatoxin B1 on the sensing piezoresistive microcantilever with a biotin avidin system (BAS), a linear aflatoxin B1 detection concentration resulting from 1 ng/mL to 100 ng/mL was obtained, and the toxic molecule detection also showed good specificity. The experimental results indicate that the PI/Si/SiO2 flexible piezoresistive microcantilever biosensor has excellent abilities in trace-level and specific detections of aflatoxin B1 and other biomolecules.

Sign in / Sign up

Export Citation Format

Share Document