scholarly journals Stationary values of the transmission ratio of the planar fourbar

2008 ◽  
Vol 30 (4) ◽  
Author(s):  
J. Wittenburg

The transmission ratio of the planar fourbar, i.e. the ratio of the angular velocities of input link and output link, is a function of the input angle. Freudenstein [1] showed how to calculate stationary values of the transmission ratio. In the present paper a new method is described. Like Freudenstein’s method it results in a sixth-order polynomial equation.

Author(s):  
Igor Ravve ◽  
Zvi Koren

Summary The inverse problem of finding the slowness vector from a known ray direction in general anisotropic elastic media is a challenging task, needed in many wave/ray-based methods, in particular, solving two-point ray bending problems. The conventional resolving equation set for general (triclinic) anisotropy consists of two fifth-degree polynomials and a sixth-degree polynomial, resulting in a single physical solution for quasi-compressional (qP) waves and up to 18 physical solutions for quasi-shear waves (qS). For polar anisotropy (transverse isotropy with a tilted symmetry axis), the resolving equations are formulated for the slowness vectors of the coupled qP and qSV waves (quasi-shear waves polarized in the axial symmetry plane), and independently for the decoupled pure shear waves polarized in the normal (to the axis) isotropic plane (SH). The novelty of our approach is the introduction of the geometric constraint that holds for any wave mode in polar anisotropic media: The three vectors—the slowness, ray velocity and medium symmetry axis—are coplanar. Thus, the slowness vector (to be found) can be presented as a linear combination of two unit-length vectors: the polar axis and the ray velocity directions, with two unknown scalar coefficients. The axial energy propagation is considered as a limit case. The problem is formulated as a set of two polynomial equations describing: a) the collinearity of the slowness-related Hamiltonian gradient and the ray velocity direction (third-order polynomial equation), and b) the vanishing Hamiltonian (fourth-order polynomial equation). Such a system has up to twelve real and complex-conjugate solutions, which appear in pairs of the opposite slowness directions. The common additional constraint, that the angle between the slowness and ray directions does not exceed ${90^{\rm{o}}}$, cuts off one half of the solutions. We rearrange the two bivariate polynomial equations and the above-mentioned constraint as a single univariate polynomial equation of degree six for qP and qSV waves, where the unknown parameter is the phase angle between the slowness vector and the medium symmetry axis. The slowness magnitude is then computed from the quadratic Christoffel equation, with a clear separation of compressional and shear roots. The final set of slowness solutions consists of a unique real solution for qP wave and one or three real solutions for qSV (due to possible triplications). The indication for a qSV triplication is a negative discriminant of the sixth-order polynomial equation, and this discriminant is computed and analyzed directly in the ray-angle domain. The roots of the governing univariate sixth-order polynomial are computed as eigenvalues of its companion matrix. The slowness of the SH wave is obtained from a separate equation with a unique analytic solution. We first present the resolving equation using the stiffness components, and then show its equivalent forms with the well-known parameterizations: Thomsen, Alkhalifah and ‘weak-anisotropy’. For the Thomsen and Alkhalifah forms, we also consider the (essentially simplified) acoustic approximation for qP waves governed by the quartic polynomials. The proposed method is coordinate-free and can be applied directly in the global Cartesian frame. Numerical examples demonstrate the advantages of the method.


1999 ◽  
Vol 131 (1) ◽  
pp. 137-149 ◽  
Author(s):  
R.M. Trimble ◽  
C.A. Tyndall ◽  
B.D. McGarvey

AbstractNatural rubber sleeve stoppers were impregnated with 10 mg of (E)-10-dodecen-1-yl-acetate, the major component of spotted tentiform leafminer, Phyllonorycter blancardella (F.), pheromone. In the laboratory, there was a linear decline in the amount of pheromone remaining on stoppers during 8 weeks of exposure to 10, 15, 20, and 25 °C. At 30 and 35 °C, the relationship was curvilinear and could be described using a second-order polynomial equation. The estimated rate of evaporation ranged from 0.03 mg/day at 10 °C to 0.08 mg/day at 25 °C; the rate of evaporation at 30 and 35 °C varied with the time since first exposure. There was a linear decline in the amount of pheromone remaining on stoppers during 8 weeks of exposure to fluctuating temperature regimes with average temperatures of 10 °C (i.e., 5–15 °C) and 20 °C (i.e., 15–25 °C). At a fluctuating regime with an average temperature of 30 °C (i.e., 25–35 °C), the relationship was curvilinear and could be described using a second-order polynomial equation. The estimated rate of evaporation was 0.02 and 0.09 mg/day at 5–15 and 15–25 °C, respectively; the estimated daily rate of evaporation at 25–35 °C varied with the time since first exposure. In an orchard, the estimated average rate of evaporation of pheromone from stoppers ranged from 0.05 to 0.31 mg/day and did not vary significantly with temperature. During the first 4 weeks of exposure in an orchard, the observed rate of evaporation was up to 4.4-fold greater than the rate predicted using the relationship between evaporation rate and constant temperatures observed in the laboratory. The potential for using natural rubber sleeve stoppers as controlled-release substrates in studies of sex-pheromone-mediated mating disruption of P. blancardella is discussed.


2016 ◽  
Vol 40 (6) ◽  
pp. 698-705 ◽  
Author(s):  
Clérison dos Santos Belém ◽  
Anderson Miranda de Souza ◽  
Patrícia Rodrigues de Lima ◽  
Francisco Allan Leandro de Carvalho ◽  
Mário Adriano Ávila Queiroz ◽  
...  

ABSTRACT Preserving forage plants adapted to a semi-arid climate as silage may minimize the animal feed deficit during drought. The objective of this study was to evaluate the effects of different quantities of grape pomace added to Calotropis procera silage on its fermentation, in vitro digestibility, total digestible nutrients and microbiology. A completely randomized experimental design was used with four treatments (0, 10, 20 and 40% fresh matter) and four replicates. The silos were opened after 90 days of ensilage, and the soluble carbohydrate, ethanol, organic acid and ammoniacal nitrogen concentrations; pH; fermentation loss; dry matter (DM) recovery; DM density, and microbial populations were determined. The pH (3.96-3.87) was adequate for ensiling in all silage samples. The soluble carbohydrate concentration decreased (p<0.05), and the ethanol concentration increased with increasing quantities of grape pomace. The lactic acid concentration decreased (p<0.05) from 5.3 to 1.94% DM, and the acetic, propionic and butyric acid concentrations increased with increasing quantities of grape pomace. The lactic acid bacteria decreased linearly (p <0.05), varying from 6.43 to 5.82 log CFU/g silage. The mold and yeast population variations fit best using a third-order polynomial equation (p <0.05). Enterobacteria and Clostridium spp were not observed. Adding grape pomace to the silage increased the effluent and gas loss; the latter varied from 5.35 to 14.4%. The total digestible nutrient (TDN) variation fit best using a second-order polynomial equation, and the maximum value was estimated at 82.95% DM with 3.5% grape pomace using the regression equation. The percent digestibility decreased linearly (p<0.05) with increasing quantities of grape pomace. We show that Calotropis procera has potential as silage even without adding grape pomace.


2012 ◽  
Vol 174-177 ◽  
pp. 1520-1523
Author(s):  
Hong Ya Zhang ◽  
Feng Wang ◽  
Hua Cheng

In this study, one new function is defined as change of relative crystallization degree in unit time and named relative crystallization rate (1/min.). The curve of heat flow rate to time is transmitted to that of to . The produced curve was fitted using one high-order polynomial equation with a variable of and the coefficient vector (Ai ,in this paper,the values of i were from 0 to 9)was produced. It was found that, even during the accelerated stage of crystallization from PET melt,both aspects to promote and delay the relative crystallization rate existed, furthermore, both aspects of promotion and delay declined with the crystallization process and appeared “internal exhaustion”.


2012 ◽  
Vol 26 (2) ◽  
pp. 103-108 ◽  
Author(s):  
N. Bagheri ◽  
H. Ahmadi ◽  
S. Alavipanah ◽  
M. Omid

Soil-line vegetation indices for corn nitrogen content prediction The soil-line vegetation indices for prediction of corn canopy nitrogen content were investigated. Results indicated that the vegetation indices applied were correlated with corn canopy nitrogen content and the wavelengths between 630-860 nm are suitable for nitrogen diagnosis. The second-order polynomial equation was the best model for nitrogen content prediction among different regression types. Analyses based on both predicted and measured data were carried out to compare the performance of existing vegetation indices.


Author(s):  
Change-de Zhang ◽  
Shin-Min Song

Abstract This paper presents the closed-form solution of forward position analysis of the nearly general stewart platform, which consists of a base and a moving planar platforms connected by six extensible limbs through spherical joints in the two planar platforms. It becomes a general stewart platform if the centers are not constrained to those two planes. In this study, transformation matrix is used to represent the position of the moving platform. Based on the six dependency equations of the rotation matrix and the six constraint equations related to the six link lengths, a set of six 4-th degree equations in three unknowns are derived. Further derivations produce twenty-one dependent constraint equations. By simultaneous elimination of two unknowns a 20-th order polynomial equation in one unknown is obtained. Due to dual solutions of other unknowns, this indicates a maximum of forty possible solutions. The roots of this polynomial are solved numerically and the realistic solutions are constructed using computer graphics.


2013 ◽  
Vol 67 (12) ◽  
pp. 2706-2711 ◽  
Author(s):  
Juan Wang ◽  
Yuan Cao ◽  
Qin Zhong

The aim of this study was to investigate optimum conditions for biological removal of flue gas pretreatment wastewater and achieve maximum elemental sulfur yield. A three-factor, three-level Box–Behnken design was used to derive a second-order polynomial equation and construct contour plots to predict responses. The independent variables selected were hydraulic retention time (X1), inlet sulfate concentration (X2), and air flow (X3). Fifteen batches were done in a biological united system and evaluated for elemental sulfur yield (Y1). The transformed values of the independent variables and Y1 were subjected to a full-model second-order polynomial equation. The equation was modified based on Fisher's F- and probability P-values. The computer optimization process and contour plots predicted the values of independent variables X1, X2 and X3 (16 h, 1,348 mg L−1 and 165 L h−1 respectively), for maximized response of Y1. The experimental results at predicted conditions demonstrate that the modified model equation has good applicability to the practical system.


2016 ◽  
Vol 8 (8) ◽  
pp. 680 ◽  
Author(s):  
Guoqing Zhou ◽  
Tao Yue ◽  
Yujun Shi ◽  
Rongting Zhang ◽  
Jingjin Huang

Sign in / Sign up

Export Citation Format

Share Document