scholarly journals The Assessment of H2S Emission from Araç Watercourse, in Karabük

Author(s):  
Kadir ULUTAŞ ◽  
Ayhan KOCAMAN ◽  
Rahman ÇALHAN
Keyword(s):  
2010 ◽  
Vol 101 (7) ◽  
pp. 2141-2151 ◽  
Author(s):  
Lyman Moreno ◽  
Bernardo Predicala ◽  
Mehdi Nemati
Keyword(s):  

Water ◽  
2021 ◽  
Vol 13 (13) ◽  
pp. 1876
Author(s):  
Daneish Despot ◽  
Micaela Pacheco Fernández ◽  
Matthias Barjenbruch

Hydrogen sulfide (H2S) related to wastewater in sewer systems is known for causing significant problems of corrosion and odor nuisance. Sewer systems severely affected by H2S typically rely on online H2S gas sensors for monitoring and control. However, these H2S gas sensors only provide information about the H2S emission potential at the point being monitored, which is sometimes inadequate to design control measures. In this study, a comparison of three market-ready online sensors capable of liquid-phase H2S detection in sewer systems was assessed and compared. Two of the three sensors are based on UV/Vis spectrophotometry, while the other adapted the design and principles of a Clark-type electrochemical microsensor. The H2S measurements of the sensors were statistically compared to a standard laboratory method at first. Following that, the performance of the online sensors was evaluated under realistic sewer conditions using the Berlin Water Company (BWB) research sewer pilot plant. Test applications representing scenarios of typical H2S concentrations found in sulfide-affected sewers and during control measures were simulated. The UV/Vis spectrometers showed that the performance of the sensors was highly dependent on the calibration type and measurements used for deriving the calibration function. The electrochemical sensor showed high sensitivity by responding to alternating anaerobic/anoxic conditions simulated during nitrate dosing. All sensors were prone to measurement disturbances due to high amounts of sanitary solids in wastewater at the study site and required continuous maintenance for reliable measurements. Finally, a summary of the key attributes and limitations of the sensors compared for liquid phase H2S detection is outlined.


Author(s):  
Tariwari C.N Angaye ◽  
Koru J. Alagoa

Emission of Hydrogen Sulphide (H2S) from dumpsites has become a global threat due to its impact on global climate change. This study assessed the spatial and seasonal levels of H2S emissions from 6 dumpsites (LA - LF), with portable air quality meter (AEROQUAL-Series 300). Results showed that the spatial level of H2S ranged from 1.40 ppm - 14.34 ppm. Based on seasonal variation level of H2S ranged from 1.88 ppm – 3.86 ppm (p<0.05), with higher values in wet season. Meanwhile H2S were not detected in the control station (LX). Based on model for Air Quality Index (AQI), H2S emission was predominantly rated as safe and moderate, except for the two stations in the central dumpsite (LE and LF). These results confirmed the emission of H2S from the dumpsite due to anthropogenic activities. We therefore recommend policies aimed at sequestration of H2S, by the reduce, reuse and recycle policy of waste stream.


Catalysts ◽  
2020 ◽  
Vol 10 (8) ◽  
pp. 940 ◽  
Author(s):  
Baitong Chen ◽  
Jacek A. Koziel ◽  
Andrzej Białowiec ◽  
Myeongseong Lee ◽  
Hantian Ma ◽  
...  

Acute releases of hydrogen sulfide (H2S) are of serious concern in agriculture, especially when farmers agitate manure to empty storage pits before land application. Agitation can cause the release of dangerously high H2S concentrations, resulting in human and animal fatalities. To date, there is no proven technology to mitigate these short-term releases of toxic gas from manure. In our previous research, we have shown that biochar, a highly porous carbonaceous material, can float on manure and mitigate gaseous emissions over extended periods (days–weeks). In this research, we aim to test the hypothesis that biochar can mitigate H2S emissions over short periods (minutes–hours) during and shortly after manure agitation. The objective was to conduct proof-of-the-concept experiments simulating the treatment of agitated manure. Two biochars, highly alkaline and porous (HAP, pH 9.2) made from corn stover and red oak (RO, pH 7.5), were tested. Three scenarios (setups): Control (no biochar), 6 mm, and 12 mm thick layers of biochar were surficially-applied to the manure. Each setup experienced 3 min of manure agitation. Real-time concentrations of H2S were measured immediately before, during, and after agitation until the concentration returned to the initial state. The results were compared with those of the Control using the following three metrics: (1) the maximum (peak) flux, (2) total emission from the start of agitation until the concentration stabilized, and (3) the total emission during the 3 min of agitation. The Gompertz’s model for determination of the cumulative H2S emission kinetics was developed. Here, 12 mm HAP biochar treatment reduced the peak (1) by 42.5% (p = 0.125), reduced overall total emission (2) by 17.9% (p = 0.290), and significantly reduced the total emission during 3 min agitation (3) by 70.4%. Further, 6 mm HAP treatment reduced the peak (1) by 60.6%, and significantly reduced overall (2) and 3 min agitation’s (3) total emission by 64.4% and 66.6%, respectively. Moreover, 12 mm RO biochar treatment reduced the peak (1) by 23.6%, and significantly reduced overall (2) and 3 min total (3) emission by 39.3% and 62.4%, respectively. Finally, 6 mm RO treatment significantly reduced the peak (1) by 63%, overall total emission (2) by 84.7%, and total emission during 3 min agitation (3) by 67.4%. Biochar treatments have the potential to reduce the risk of inhalation exposure to H2S. Both 6 and 12 mm biochar treatments reduced the peak H2S concentrations below the General Industrial Peak Limit (OSHA PEL, 50 ppm). The 6 mm biochar treatments reduced the H2S concentrations below the General Industry Ceiling Limit (OSHA PEL, 20 ppm). Research scaling up to larger manure volumes and longer agitation is warranted.


2006 ◽  
Vol 54 (9) ◽  
pp. 173-180 ◽  
Author(s):  
J.M. Santos ◽  
L.M. Sá ◽  
N.C. Reis Junior ◽  
R.F. Gonçalves ◽  
R.N. Siqueira

Hydrogen sulphide (H2S) represents one of the main odorant gases emitted from wastewater treatment plants (WWTP) and a mathematical model can be a fast and low cost tool to estimate its emission. In this work H2S emission rates in a WWTP, composed of an up-flow anaerobic sludge blanket (UASB) reactor and an aerobic biofilter (BF), are estimated using four mathematical models available in the literature (AP-42, GPC, TOXCHEM+ and WATER8). The results show that the GPC model leads to the best agreement with the experimental data, except for the biofilter due to its lack of capability to include biodegradation as a H2S removal process. On the other hand, the AP-42 and WATER8 models showed a slightly better ability to predict H2S removal in the biofilter than the TOXCHEM+ model, as all models underestimate the H2S concentration decay.


2016 ◽  
Vol 6 (1) ◽  
Author(s):  
Yuyang Long ◽  
Yuan Fang ◽  
Dongsheng Shen ◽  
Huajun Feng ◽  
Ting Chen

Sign in / Sign up

Export Citation Format

Share Document