Depositional Cycles in a Lower Cretaceous Limestone Reservoir, Onshore Abu Dhabi, U.A.E.

2018 ◽  
Vol 88 (7) ◽  
pp. 753-776 ◽  
Author(s):  
Stephen N. Ehrenberg ◽  
Stephen W. Lokier ◽  
Liu Yaxin ◽  
Rulin Chen

AbstractThe upper reservoir zone of the Lower Cretaceous Kharaib Formation (46–54 m thick in the studied wells) is regarded as the upper portion of a third-order depositional sequence comprising higher-order cycles. Whereas the third-order sequence interpretation is clearly supported by the upward-shoaling trend of the reservoir zone, relationships defining the component cycles have not previously been documented and are the focus of the present study. Core descriptions from four wells in a single oilfield reveal little evidence of facies changes or trends of facies patterns indicative of high-frequency depositional cycles. Cycle boundaries could possibly be represented by the repetitive pattern of coarse beds (rudstone and floatstone) 0.1–2 m thick, commonly having sharp basal contacts and gradational upper contacts with enclosing packstone to wackestone. Because the coarse beds do not appear correlative between wells, however, we prefer the alternative interpretation that they reflect episodic storm events which locally redistributed detritus, sourced from a patchwork of low-relief lithosomes, across the flat surface of the epeiric Kharaib platform–lagoon. Although the existence of high-order eustatic fluctuations during upper Kharaib deposition is well established, low-amplitude variations in water depth may not have touched down on the sea floor to significantly affect sediment textures in contrast with the dominant storm signal.Reservoir sub-zones used for production operations, but previously suggested to be fourth-order parasequence sets, are defined by dips in porosity-log profiles, reflecting thin (approximately 1 m) intervals of increased stylolite frequency. These boundaries are thus diagenetic in character, but their correlation over tens to hundreds of kilometers indicates an underlying depositional control. We suggest that the link between sea level and diagenesis is depositional-clay content, which facilitates stylolitic dissolution. Profiles of bulk-rock alumina analyses in the studied cores show subtle indications of higher clay content at the sub-zone tops. Much greater clay peaks mark the third-order sequence boundaries, resulting in the “dense” (very low porosity) zones above and below the studied reservoir zone and the increased stylolite frequency in the upper and lower several meters of the zone. Possible factors promoting clay influx across a carbonate shelf during falls in sea level include increased stream gradients and more humid climate.

GeoArabia ◽  
2005 ◽  
Vol 10 (2) ◽  
pp. 189-192 ◽  
Author(s):  
Moujahed Al-Husseini ◽  
Robley K. Matthews

The recent publication of GTS 2004 (Gradstein et al., 2004) provides an opportunity to recalibrate in time the late Carboniferous, Permian and Early Traissic Arabian Stratigraphy (GeoArabia Special Publication 3, Edited by Al-Husseini, 2004) as represented by the rock units in subsurface Interior Oman (Osterloff et al., 2004a, b) and the Haushi-Huqf Uplift region (Angiolini et al., 2004) (Figure). Additionally, sequence stratigraphic models of orbital forcing (Matthews and Frohlich, 2002; Immenhauser and Matthews, 2004) provide new insights in regards to the time calibration of depositional sequences: the “Rosetta Stone” approach. The Rosetta Stone approach predicts that the period of a third-order depositional sequence is 2.430 ± 0.405 my (denoted DS3 and here adjusted to increase the fourth-order ‘geological tuning fork’ from 0.404 to 0.405 my based on Laskar et al., 2004). The present calibration is also tied to the orbital-forcing model developed by R.K. Matthews (in Al-Husseini and Matthews, 2005; this issue of GeoArabia) that predicts that a second-order depositional sequence (denoted DS2) consists of six DS3s that were deposited in a period of about 14.58 my (6 x 2.430 my); the DS2 being bounded by two regional second-order sequence boundaries (SB2) corresponding to sea-level maximum regression surfaces.


2004 ◽  
Vol 83 (2) ◽  
pp. 81-91 ◽  
Author(s):  
O.A. Abbink ◽  
J.H.A. Van Konijnenburg-Van Cittert ◽  
C.J. Van der Zwan ◽  
H. Visscher

AbstractJurassic shallow marine to non-marine depositional sequences are among the most important economic targets in the North Sea. Detailed, ‘high resolution’ stratigraphy of these sequences has become a necessity in both predictive geological exploration models as well as in production reservoir models. In these paralic sequences, palynomorphs are the most abundant (micro) fossil group. Palynology is increasingly challenged to improve the biostratigraphic control, and to support the sequence stratigraphical framework. Based on a recently developed, conceptual Sporomorph EcoGroup model, the quantitative distribution patterns of terrestrial palynomorphs are grouped in six Sporomorph EcoGroups (SEGs), viz. Upland, Lowland, River, Pioneer, Coastal, and Tidally-influenced SEG. Application of the SEG model to data from a marginal marine, uppermost Callovian - Middle Oxfordian section of NAM well F17-4 from the southern part of the Central North Sea Graben allows the recognition of sea-level fluctuations and climate changes. A marked palaeoclimatic shift occurred in the earliest Middle Oxfordian. The relatively cool-subtropical, humid climate changed into a warmer, subtropical-tropical, drier climate. The sea-level reconstructions based on the SEG model are validated against a latest Callovian - Earliest Oxfordian depositional sequence.


Geologos ◽  
2020 ◽  
Vol 26 (1) ◽  
pp. 1-23
Author(s):  
Gerard B.S. van Loevezijn ◽  
J.G.M. Raven

AbstractRelative sea level fluctuations during the Frasnian generated two shallow-marine, mixed siliciclastic-carbonate successions in the Devonian Asturo-Leonese Basin. Each system represents a third-order sequence-stratigraphical unit deposited in the same basin during comparable extreme greenhouse conditions without nearby fluvial entry points. Depositional control on the siliciclastic and carbonate distribution was driven by relative sea level fluctuations, basin geometry, availability of sand and the way sediment was distributed by shelf currents. Early Variscan flexural bending of the continental crust changed the basin shape from a shelf with a gradual profile and low dip (early Frasnian) towards a shelf with a steep depositional dip (late Frasnian). Shelf distribution changed from along-shelf transport (early Frasnian) towards offshore-directed gravity flows (late Frasnian). As a consequence, siliciclastic-carbonate distribution changed from a predominance of skeletal carbonate in the proximal shoreface – foreshore area and siliciclastic predominance distally (early Frasnian), to a distribution pattern with proximal shoreface skeletal carbonates, offshore muddy carbonates and a siliciclastic zone in between where gravity flows distributed the siliciclastic sediment down dip (late Frasnian).


2021 ◽  
Vol 54 (2C) ◽  
pp. 1-12
Author(s):  
Mahmoud Elsheikh

This study focuses on the subsurface Miocene-Pleistocene sedimentary sequence of the Western Delta of Deep-Sea field. Analysis of seismic, based on obtainable well data, and seismic data, allows us to divide the studied successions into two mega sequences: Pre and Post Messinian complexes resulting in transgressive-regressive sedimentation cycles of sea level during the evolution of the Miocene-Pleistocene subsurface sedimentary sequence. The Relative level of the sea was extremely falling in the time of the Messinian period, although it was largely rising at the time of the lower to Middle Pliocene. Pre-Messinian complex encompasses the Miocene strata, while the Post-Messinian complex consists of a thickness pattern of deposits in the time of Pliocene to Pleistocene and ended up with Holocene. The comprehensive study presented here divides these complexes into several orders of sea-level cycles. Pre and Post-Messinian complexes are consisting of several third-order cycles, which is called a depositional sequence, hence the thickness pattern starts from Sidi Salem Formation and ends up with Mit Ghamr Formation (Pleistocene). The interpreted anticline represents a characteristic overlap that can create an appropriate structural trap for hydrocarbons in the sandy intermission of the formations of the Western Deep-Sea Delta field such as Kafr El Sheik siliceous clastic. Besides, the recognized individual and various hidden routes, such as channel and sub-channel in the Pre-Messinian complex are approved for additional inspection to discover hydrocarbons.


2018 ◽  
Vol 10 (1) ◽  
pp. 250-260 ◽  
Author(s):  
EnZhao Xiao ◽  
Khalid Latif ◽  
Muhammad Riaz ◽  
Yinglun Qin ◽  
Hao Wang

Abstract In order to study the sedimentological response of the first episode of “cyanobacteria calcification event” in Phanerozoic, we studied the microbialites from Furongian Series in Qijiayu section, Hebei Province, which is located in the central part of the North China Platform. Cambrian Furongian Series is made up of three third-order depositional sequences, Depositional Sequence 1 (DS1) in Changshan Formation and DS2 and DS3 in Fengshan Formation. Two beds of massive limestone of a shallow ramp facies developed in Changshan Formation and the first third-order sequence of Fengshan Formation. Both of them contains many dome-shaped carbonate structures that formed as a result of forced regression. These structures can be described as leiolitic bioherms, with a morphology like string of beads. In the current study, microorganisms such as Epiphyton, Girvanella and Renalcis are reported from the leiolitic bioherms. This provides not only documentation for the model of cyanobacteria calcification, but also describes the genesis of leiolitic bioherms by microbial processes inside cyanobacteria dominated microbial mats. Moreover, the diverse emergence of the calcified microorganisms represents the fossil evidence of calcified microorganisms’ blooms in Cambrian Furongian and offers a reference for studying the complex microbial processes in such old carbonate depositions.


1993 ◽  
Vol 30 (2) ◽  
pp. 301-320 ◽  
Author(s):  
A. F. Embry

Transgressive–regressive (T–R) sequence analysis has been applied to the Jurassic succession of the Sverdrup Basin with sequence boundaries drawn at subaerial unconformities or the correlative transgressive surfaces. A hierarchal system of sequence order that reflects the different nature of the boundaries has been formulated on the basis of boundary characteristics. Second- through fifth-order sequences have been recognized in the Jurassic succession, which itself is part of a first-order sequence of mid-Permian – Early Cretaceous age.The Jurassic strata occur within four second-order sequences. The boundaries of these sequences are characterized by widespread subaerial unconformities across which major changes in depositional and subsidence regimes occur. These boundaries are earliest Rhaetian, earliest Pliensbachian, earliest Bajocian, earliest Oxfordian, and Hauterivian in age.Each second-order sequence is divisible into a number of third-order sequences bounded mainly by basin-wide transgressive surfaces with subaerial unconformities present on the basin margins. The ages of the 10 Jurassic third-order sequences are Rhaetian – Hettangian, Sinemurian, Pliensbachian – Toarcian, late Toarcian – Aalenian, Bajocian, Bathonian, Callovian, Oxfordian – early Kimmeridgian, late Kimmeridgian – early Tithonian, and late Tithonian. The third-order sequences commonly contain three to six fourth-order sequences. These sequences are bound entirely by transgressive surfaces that can be correlated only over a portion of the basin.A good correlation between the second- and third-order transgressive events of the Sverdrup Basin and proposed global events is observed. This worldwide occurrence suggests that the events in part reflect eustatic sea-level changes. The characteristics of the second- and third-order boundaries also indicate that each had a tectonic influence that resulted in a rapid relative sea-level fall (uplift) followed by a rapid rise (subsidence). Given the apparent combination of tectonic and eustatic influence on the generation of the second- and third-order sequence boundaries, they are interpreted to reflect significant plate-tectonic reorganizations that affected the intraplate stress regimes of the oceanic (eustatic) and continental (tectonic) portions of each lithospheric plate.


GeoArabia ◽  
2006 ◽  
Vol 11 (2) ◽  
pp. 53-70 ◽  
Author(s):  
Moujahed Al-Husseini ◽  
Robley K. Matthews

ABSTRACT The Devonian Jauf Formation (Huj Group) froms part of a regional transgressive-regressive depositional sequence that extends more than 1,500 km across the Arabian Platform from the Al Jawf outcrops in northwest Saudi Arabia, to the subsurface of eastern Saudi Arabia and Oman (Misfar Group). The formation ranges in thickness from 200–335 m in eastern Saudi Arabia to about 300–330 m in northwest Saudi Arabia. It disconformably (?unconformably) overlies the continental to shallow-marine Tawil Formation, and is unconformably overlain by the continental Jubah Formation. The Jauf Formation consists of five members that are apparently conformable; from base-up: Sha’iba Shale, Qasr Limestone, Subbat Shale, Hammamiyat Limestone and Murayr. In the Al-Qalibah reference section, it is divided into 21 informal units. The Early Devonian Emsian Hammamiyat Member represents the main marine flooding event; it consists of Hammamiyat units 1–6 each characterized by a clastic section that is capped by limestone. The Jauf Formation is interpreted as an orbital second-order depositional sequence (denoted DS2 28), which is bounded by two second-order sequence boundaries: SB2 28 = Jauf/Tawil (c. 407.6 Ma) and SB2 27 = Jubah/Jauf (c. 393.0 Ma). The Jauf Formation appears to consist of six third-order depositional sequences (DS3 28.1 to 28.6) that were deposited in the Early Devonian, ?Pragian and Emsian stages The Hammamiyat Member (DS3 28.4) is interpreted to consist of six fourth-order orbital cycles (DS4 28.4.1 to 28.4.6) each deposited in 0.405 million years.


Sign in / Sign up

Export Citation Format

Share Document