scholarly journals Block Method for SolvingState-Space Equations of Linear Continuous-Time Control Systems

2007 ◽  
Vol 4 (2) ◽  
pp. 318-329
Author(s):  
Baghdad Science Journal
Keyword(s):  
State Space ◽  
Continuous Time ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Method Comparison ◽  
The State ◽  
Block Method ◽  
Single Input Single Output ◽  
Single Output ◽  
Time Control

This paper presents a newly developed method with new algorithms to find the numerical solution of nth-order state-space equations (SSE) of linear continuous-time control system by using block method. The algorithms have been written in Matlab language. The state-space equation is the modern representation to the analysis of continuous-time system. It was treated numerically to the single-input-single-output (SISO) systems as well as multiple-input-multiple-output (MIMO) systems by using fourth-order-six-steps block method. We show that it is possible to find the output values of the state-space method using block method. Comparison between the numerical and exact results has been given for some numerical examples for solving different types of state-space equations using block method for conciliated the accuracy of the results of this method.

scholarly journals A Semiempirical MIMO Channel Model in Obstructed Viaduct Scenarios on High-Speed Railway

2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Tao Zhou ◽  
Cheng Tao ◽  
Liu Liu ◽  
Zhenhui Tan
Keyword(s):  
High Speed ◽  
Channel Model ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Time Correlation ◽  
Time Correlation Function ◽  
Mimo Channel ◽  
High Speed Railway ◽  
Single Input Single Output ◽  
Single Output

A semiempirical multiple-input multiple-output (MIMO) channel model is proposed for high-speed railway (HSR) viaduct scenarios. The proposed MIMO model is based on the combination of realistic single-input single-output (SISO) channel measurement results and a theoretical geometry-based stochastic model (GBSM). Temporal fading characteristics involvingK-factor and Doppler power spectral density (PSD) are derived from the wideband measurement under an obstructed viaduct on Zhengzhou-Xi’an HSR in China. The GBSM composed of a one-ring model and an elliptical model is employed to describe the entire propagation environment. Environment-related parameters in the GBSM are determined by the measured temporal fading properties. And a close agreement is achieved between the model results and measured data. Finally, a deterministic simulation model is established to perform the analysis of the space-time correlation function, the space-Doppler PSD, and the channel capacity for the measured scenario. This model is more realistic and particularly beneficial for the performance evaluation of MIMO systems in HSR environments.

scholarly journals Deep Learning-based Cooperative Automatic Modulation Classification Method for MIMO Systems

2020 ◽  
Author(s):  
Yu Wang ◽  
Juan Wang ◽  
Jie Yang ◽  
Wei Zhang ◽  
Guan Gui
Keyword(s):  
Deep Learning ◽  
Communication Systems ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Decision Rules ◽  
Modulation Classification ◽  
Single Input Single Output ◽  
Automatic Modulation Classification ◽  
Single Output ◽  
Input Multiple Output

Automatic modulation classification (AMC) is one of the most essential algorithms to identify the modulation types for the non-cooperative communication systems. Recently, it has been demonstrated that deep learning (DL)-based AMC method effectively works in the single-input single-output (SISO) systems, but DL-based AMC method is scarcely explored in the multiple-input multiple-output (MIMO) systems. In this correspondence, we propose a convolutional neural network (CNN)-based cooperative AMC (Co-AMC) method for the MIMO systems, where the receiver equipped with multiple antennas cooperatively recognizes the modulation types. Specifically, each received antenna gives their recognition sub-results via the CNN, respectively. Then, the decision maker identifies the modulation types with the recognition sub-results and cooperative decision rules, such as direct voting (DV), weighty voting (WV), direct averaging (DA) and weighty averaging (WA). The simulation results demonstrate that the Co-AMC method, based on the CNN and WA, has the highest correct classification probability in the four cooperative decision rules. In addition, the CNN-based Co-AMC method also performs better than the high order cumulants (HOC)-based traditional AMC methods, which shows the effective feature extraction and powerful classification capabilities of the CNN.

scholarly journals Optimized Scheduling Technique of Null Subcarriers for Peak Power Control in 3GPP LTE Downlink

2014 ◽  
Vol 2014 ◽  
pp. 1-8 ◽  
Author(s):  
Soobum Cho ◽  
Sang Kyu Park
Keyword(s):  
Power Efficiency ◽  
Multiple Access ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Average Power ◽  
Papr Reduction ◽  
Single Input Single Output ◽  
Single Output ◽  
Multiple Input ◽  
Input Multiple Output

Orthogonal frequency division multiple access (OFDMA) is a key multiple access technique for the long term evolution (LTE) downlink. However, high peak-to-average power ratio (PAPR) can cause the degradation of power efficiency. The well-known PAPR reduction technique, dummy sequence insertion (DSI), can be a realistic solution because of its structural simplicity. However, the large usage of subcarriers for the dummy sequences may decrease the transmitted data rate in the DSI scheme. In this paper, a novel DSI scheme is applied to the LTE system. Firstly, we obtain the null subcarriers in single-input single-output (SISO) and multiple-input multiple-output (MIMO) systems, respectively; then, optimized dummy sequences are inserted into the obtained null subcarrier. Simulation results show that Walsh-Hadamard transform (WHT) sequence is the best for the dummy sequence and the ratio of 16 to 20 for the WHT and randomly generated sequences has the maximum PAPR reduction performance. The number of near optimal iteration is derived to prevent exhausted iterations. It is also shown that there is no bit error rate (BER) degradation with the proposed technique in LTE downlink system.

scholarly journals Linear detectors and precoding methods for massive MIMO

2021 ◽  
Vol 42 (2) ◽  
pp. 209
Author(s):  
Jean Marcel Faria Tonin ◽  
Taufik Abrao
Keyword(s):  
Massive Mimo ◽  
Communication Systems ◽  
Mean Squared Error ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Wireless Channel ◽  
Single Input Single Output ◽  
Single Output ◽  
Minimum Mean Squared Error ◽  
Input Multiple Output

Detection in multiple-input-multiple-output (MIMO) wireless communication systems is a crucial procedure in receivers since the multiple access transmission schemes generate interference due to the simultaneous transmission along with the several antennas, unlike single-input-single-output (SISO) transmission schemes. Precoding is a technique in MIMO systems used to mitigate the effects of the channel over the received signal. Hence, it is possible to adjust continuously the transmitted information to reverse the effect of the wireless channel at the receiver side. In this work, linear sub-optimal detectors and precoders for massive MIMO (M-MIMO) systems are implemented, analyzed, and compared in terms of performance-complexity trade-off. It is also being considered numerical results in both channel scenarios: a) receiver and transmitter have perfect channel state information (CSI); b) complex channel coefficients are estimated with different levels of inaccuracy. Monte-Carlo simulations (MCS) reveal that linear zero-forcing (ZF) and minimum mean squared error (MMSE) massive MIMO detectors result in a certain robustness against multi-user interference when operating under low and medium system loading, L = K/M, thanks to the favourable propagation phenomenon arising in massive MIMO systems.

scholarly journals Deep Learning-based Cooperative Automatic Modulation Classification Method for MIMO Systems

2020 ◽  
Author(s):  
Yu Wang ◽  
Juan Wang ◽  
Jie Yang ◽  
Wei Zhang ◽  
Guan Gui
Keyword(s):  
Deep Learning ◽  
Communication Systems ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Decision Rules ◽  
Modulation Classification ◽  
Single Input Single Output ◽  
Automatic Modulation Classification ◽  
Single Output ◽  
Input Multiple Output

Automatic modulation classification (AMC) is one of the most essential algorithms to identify the modulation types for the non-cooperative communication systems. Recently, it has been demonstrated that deep learning (DL)-based AMC method effectively works in the single-input single-output (SISO) systems, but DL-based AMC method is scarcely explored in the multiple-input multiple-output (MIMO) systems. In this correspondence, we propose a convolutional neural network (CNN)-based cooperative AMC (Co-AMC) method for the MIMO systems, where the receiver equipped with multiple antennas cooperatively recognizes the modulation types. Specifically, each received antenna gives their recognition sub-results via the CNN, respectively. Then, the decision maker identifies the modulation types with the recognition sub-results and cooperative decision rules, such as direct voting (DV), weighty voting (WV), direct averaging (DA) and weighty averaging (WA). The simulation results demonstrate that the Co-AMC method, based on the CNN and WA, has the highest correct classification probability in the four cooperative decision rules. In addition, the CNN-based Co-AMC method also performs better than the high order cumulants (HOC)-based traditional AMC methods, which shows the effective feature extraction and powerful classification capabilities of the CNN.

Channel Capacity of High Altitude Platform Systems: A case study

2017 ◽  
Author(s):  
Nguyen Thu Hien ◽  
Vu Van San ◽  
Nguyen Viet Hung
Keyword(s):  
High Altitude ◽  
Channel Capacity ◽  
Mimo Systems ◽  
Multiple Input Multiple Output ◽  
Single Input Single Output ◽  
High Altitude Platform ◽  
Coding Schemes ◽  
Single Output ◽  
Shift Keying ◽  
Input Multiple Output

This paper presents a model for Multiple-Input Multiple-Output (MIMO) Land High Altitude Platform channels and analytical evaluation of Discrete-input Continuousoutput Memoryless Channel capacity for High Altitude Platform (HAP)–MIMO systems, where practical transmission environments are considered. Furthermore, for HAP– Single-Input Single-Output (SISO) systems, we propose an adaptive transmission mechanism relying on the transmit power characterized by value at the transmitter side. Achievable channel capacity bounds are established for both idealized and realistic adaptive coding schemes with well-adopted modulation types, namely Phase Shift Keying and Quadrature Amplitude Modulation. DOI: 10.32913/rd-ict.vol3.no14.540

Optimal Nonlinear Estimation of Linear Stochastic Systems: The Multivariable Extension

1996 ◽  
Vol 118 (2) ◽  
pp. 350-353 ◽  
Author(s):  
M. A. Hopkins ◽  
H. F. VanLandingham
Keyword(s):  
Stochastic Systems ◽  
Transfer Functions ◽  
Mimo Systems ◽  
Linear Time ◽  
Nonlinear Method ◽  
Single Input Single Output ◽  
Linear Time Invariant ◽  
Single Output ◽  
Time Invariant ◽  
Time Systems

This paper extends to multi-input multi-output (MIMO) systems a nonlinear method of simultaneous parameter and state estimation that appeared in the ASME JDSM&C (September, 1994), for single-input single-output (SISO) systems. The method is called pseudo-linear identification (PLID), and applies to stochastic linear time-invariant discrete-time systems. No assumptions are required about pole or zero locations; nor about relative degree, except that the system transfer functions must be strictly proper. In the earlier paper, proofs of optimality and convergence were given. Extensions of those proofs to the MIMO case are also given here.

Sign in / Sign up

Export Citation Format

Share Document