Application of Gravity-Assisted Wellbore Segregation to Wireline Sampling Operations. A Low Permeability Case Study

2021 ◽  
Author(s):  
German Garcia ◽  
Hadrien Dumont ◽  
Tunde Akindipe

Abstract A common challenge in exploration in the North Slope of Alaska is the formation evaluation of low-permeability formations when near-wellbore damage is caused by water-based muds (WBM). This study describes the novel application of existing technology to collect high-quality hydrocarbon samples efficiently in these challenging conditions. The concept was tested with a wireline formation tester in a well with severe formation damage caused by WBM. The procedure and hardware used are discussed and an example of the effectiveness of the proposed technique is shown. Due to the unfavorable mobility ratio, WBM filtrates tends to move preferentially while attempting oil sampling in low permeability rock leading to long station times during wireline formation testing operations. To overcome this challenge, a target sampling interval was subjected to high drawdown using a 3D radial probe to move the target phase closer to the wellbore. Once hydrocarbon was detected in the fluid analyzer, the 3D radial probe was retracted, and the string repositioned to cover the same interval with a straddle packer assembly. Straddle packers provide wellbore annular space for filtrate and hydrocarbon to segregate after the flow period is resumed. When hydrocarbons are again seen in the fluid analyzer, a simultaneous two-pump flow is used to collect them and discard the filtrate. The combination of 3D radial probe and straddle packer assists with displacing the mud filtrate, bringing the target hydrocarbons to the wellbore, and enables the collection of segregated samples with exceptional quality. After pumping at one sampling station using the 3D Radial probe, the maximum hydrocarbon fraction observed was 5%. When the straddle packer was positioned at the same interval, the fluid analyzer showed that the low velocity in the annular space between tool's mandrel and wellbore enabled hydrocarbon segregation from the filtrate due to the existing density contrast. When the hydrocarbon in the wellbore reached the straddle packer inlet, the lower pump was used to flow most of the filtrate in the down direction at high rate. Meanwhile, the hydrocarbon was "skimmed off" and placed in sample containers at a much lower rate using the upper pump. Laboratory results confirmed that the samples collected with the traditional sampling method contained 95% filtrate whereas the samples collected with our technique contained 90% hydrocarbon. Downhole fluid segregation using single-inlet, wireline straddle packer and dual-pump action has not been found in the literature. Recent developments in wireline formation testing use dual inlets in straddle packer modules to enable downhole segregation. We consider that the technique described here innovatively uses the capabilities of current formation testers to collect high-quality hydrocarbon samples in low permeability conditions. With minor adjustments, this technique can also be applied in gas or water sampling in wells drilled with oil-based muds.

2020 ◽  
Vol 38 (4) ◽  
pp. 1054-1081
Author(s):  
Huang Bo ◽  
Qin Yong ◽  
Wanhong Zhang ◽  
Qiming Zheng ◽  
Songlin Shi ◽  
...  

Coalbed methane (CBM) resources are abundant in the Gujiao block, Xishan coalfield, China. However, few studies have been conducted on the coalbed methane geology of the Gujiao block. In the present study, based on logging responses and numerical simulations, the coal structures of coal seam No. 8 of this block were identified, and the mechanical properties of the coal and its roof/floor were calculated. The geological factors influencing the coalbed methane reservoir were quantitatively characterized according to the fuzzy gray model. High-quality coalbed methane reservoirs in the No. 8 coal were predicted and classified using the model, and some suggestions on rational exploitation were determined. Reservoirs of the No. 8 coal are dominated by the III-type, followed by the II- and IV-types. The III-type reservoirs are the most common, and primarily developed at the Xiqu, Zhenchengdi, Malan, and Tunlan coal mines in the north of the studied area. The III-type reservoirs represent low coalbed methane contents, high thickness proportions of granulated-mylonitized coal, and low burial depths. The II-type reservoirs are primarily developed close to the axis of the Malan syncline and in the south and northwest of the studied area, and have low permeability, less significant differences between the mechanical properties of coals and their roofs and floors, and low reservoir pressure gradients. The IV-type reservoirs have a scattered development, dominance of granulated-mylonitized coal, and low permeability, indicating low potential to improve reservoir permeability. Targeted exploitation technology and drainage systems corresponding to the different types of coal reservoirs should be proposed to improve coalbed methane production.


2003 ◽  
Vol 762 ◽  
Author(s):  
Guofu Hou ◽  
Xinhua Geng ◽  
Xiaodan Zhang ◽  
Ying Zhao ◽  
Junming Xue ◽  
...  

AbstractHigh rate deposition of high quality and stable hydrogenated amorphous silicon (a-Si:H) films were performed near the threshold of amorphous to microcrystalline phase transition using a very high frequency plasma enhanced chemical vapor deposition (VHF-PECVD) method. The effect of hydrogen dilution on optic-electronic and structural properties of these films was investigated by Fourier-transform infrared (FTIR) spectroscopy, Raman scattering and constant photocurrent method (CPM). Experiment showed that although the phase transition was much influenced by hydrogen dilution, it also strongly depended on substrate temperature, working pressure and plasma power. With optimized condition high quality and high stable a-Si:H films, which exhibit σph/σd of 4.4×106 and deposition rate of 28.8Å/s, have been obtained.


2020 ◽  
pp. 1-14
Author(s):  
Richard D. Ray ◽  
Kristine M. Larson ◽  
Bruce J. Haines

Abstract New determinations of ocean tides are extracted from high-rate Global Positioning System (GPS) solutions at nine stations sitting on the Ross Ice Shelf. Five are multi-year time series. Three older time series are only 2–3 weeks long. These are not ideal, but they are still useful because they provide the only in situ tide observations in that sector of the ice shelf. The long tide-gauge observations from Scott Base and Cape Roberts are also reanalysed. They allow determination of some previously neglected tidal phenomena in this region, such as third-degree tides, and they provide context for analysis of the shorter datasets. The semidiurnal tides are small at all sites, yet M2 undergoes a clear seasonal cycle, which was first noted by Sir George Darwin while studying measurements from the Discovery expedition. Darwin saw a much larger modulation than we observe, and we consider possible explanations - instrumental or climatic - for this difference.


Geophysics ◽  
1988 ◽  
Vol 53 (3) ◽  
pp. 346-358 ◽  
Author(s):  
Greg Beresford‐Smith ◽  
Rolf N. Rango

Strongly dispersive noise from surface waves can be attenuated on seismic records by Flexfil, a new prestack process which uses wavelet spreading rather than velocity as the criterion for noise discrimination. The process comprises three steps: trace‐by‐trace compression to collapse the noise to a narrow fan in time‐offset (t-x) space; muting of the noise in this narrow fan; and inverse compression to recompress the reflection signals. The process will work on spatially undersampled data. The compression is accomplished by a frequency‐domain, linear operator which is independent of trace offset. This operator is the basis of a robust method of dispersion estimation. A flexural ice wave occurs on data recorded on floating ice in the near offshore of the North Slope of Alaska. It is both highly dispersed and of broad frequency bandwidth. Application of Flexfil to these data can increase the signal‐to‐noise ratio up to 20 dB. A noise analysis obtained from a microspread record is ideal to use for dispersion estimation. Production seismic records can also be used for dispersion estimation, with less accurate results. The method applied to field data examples from Alaska demonstrates significant improvement in data quality, especially in the shallow section.


Parasitology ◽  
2014 ◽  
Vol 142 (1) ◽  
pp. 54-67 ◽  
Author(s):  
K. MACKENZIE ◽  
W. HEMMINGSEN

SUMMARYStudies of the use of parasites as biological tags for stock identification and to follow migrations of marine fish, mammals and invertebrates in European Atlantic waters are critically reviewed and evaluated. The region covered includes the North, Baltic, Barents and White Seas plus Icelandic waters, but excludes the Mediterranean and Black Seas. Each fish species or ecological group of species is treated separately. More parasite tag studies have been carried out on Atlantic herring Clupea harengus than on any other species, while cod Gadus morhua have also been the subject of many studies. Other species that have been the subjects of more than one study are: blue whiting Micromesistius poutassou, whiting Merlangius merlangus, haddock Melanogrammus aeglefinus, Norway pout Trisopterus esmarkii, horse mackerel Trachurus trachurus and mackerel Scomber scombrus. Other species are dealt with under the general headings redfishes, flatfish, tunas, anadromous fish, elasmobranchs, marine mammals and invertebrates. A final section highlights how parasites can be, and have been, misused as biological tags, and how this can be avoided. It also reviews recent developments in methodology and parasite genetics, considers the potential effects of climate change on the distributions of both hosts and parasites, and suggests host-parasite systems that should reward further research.


1978 ◽  
Vol 5 (3) ◽  
pp. 334-339
Author(s):  
Brian E. Sullivan

The transit system serving Greater Vancouver has high ridership and a high rate of growth. Using as a base the well-designed, well-patronized trolleybus grid in the City of Vancouver, an inter-connected suburban bus network has been created, with radial, cross-radial, and local routes meeting on a timed connection basis at suburban shopping centres and other foci. Planners' thoughts for the future include greater emphasis on the micro and macro aspects of land use and relations to transit; the use of capital intensive modes for heavy trunk routes; and the use of various forms of para-transit for low-density and certain feeder applications.


2012 ◽  
Vol 25 (23) ◽  
pp. 8238-8258 ◽  
Author(s):  
Johannes Mülmenstädt ◽  
Dan Lubin ◽  
Lynn M. Russell ◽  
Andrew M. Vogelmann

Abstract Long time series of Arctic atmospheric measurements are assembled into meteorological categories that can serve as test cases for climate model evaluation. The meteorological categories are established by applying an objective k-means clustering algorithm to 11 years of standard surface-meteorological observations collected from 1 January 2000 to 31 December 2010 at the North Slope of Alaska (NSA) site of the U.S. Department of Energy Atmospheric Radiation Measurement Program (ARM). Four meteorological categories emerge. These meteorological categories constitute the first classification by meteorological regime of a long time series of Arctic meteorological conditions. The synoptic-scale patterns associated with each category, which include well-known synoptic features such as the Aleutian low and Beaufort Sea high, are used to explain the conditions at the NSA site. Cloud properties, which are not used as inputs to the k-means clustering, are found to differ significantly between the regimes and are also well explained by the synoptic-scale influences in each regime. Since the data available at the ARM NSA site include a wealth of cloud observations, this classification is well suited for model–observation comparison studies. Each category comprises an ensemble of test cases covering a representative range in variables describing atmospheric structure, moisture content, and cloud properties. This classification is offered as a complement to standard case-study evaluation of climate model parameterizations, in which models are compared against limited realizations of the Earth–atmosphere system (e.g., from detailed aircraft measurements).


Polar Record ◽  
1995 ◽  
Vol 31 (177) ◽  
pp. 115-128 ◽  
Author(s):  
K. Morris ◽  
M. O. Jeffries ◽  
W. F. Weeks

AbstractA survey of ice growth and decay processes on a selection of shallow and deep sub-Arctic and Arctic lakes was conducted using radiometrically calibrated ERS-1 SAR images. Time series of radar backscatter data were compiled for selected sites on the lakes during the period of ice cover (September to June) for the years 1991–92 and 1992–93. A variety of lake-ice processes could be observed, and significant changes in backscatter occurred from the time of initial ice formation in autumn until the onset of the spring thaw. Backscatter also varied according to the location and depth of the lakes. The spatial and temporal changes in backscatter were most constant and predictable at the shallow lakes on the North Slope of Alaska. As a consequence, they represent the most promising sites for long-term monitoring and the detection of changes related to global warming and its effects on the polar regions.


2021 ◽  
Author(s):  
Antoni Miszewski ◽  
Adam Miszewski ◽  
Richard Stevens ◽  
Matteo Gemignani

Abstract A set of 5 wells were to be drilled with directional Coiled Tubing Drilling (CTD) on the North Slope of Alaska. The particular challenges of these wells were the fact that the desired laterals were targeted to be at least 6000ft long, at a shallow depth. Almost twice the length of laterals that are regularly drilled at deeper depths. The shallow depth meant that 2 of the 5 wells involved a casing exit through 3 casings which had never been attempted before. After drilling, the wells were completed with a slotted liner, run on coiled tubing. This required a very smooth and straight wellbore so that the liner could be run as far as the lateral had been drilled. Various methods were considered to increase lateral reach, including, running an extended reach tool, using friction reducer, increasing the coiled tubing size and using a drilling Bottom Hole Assembly (BHA) that could drill a very straight well path. All of these options were modelled with tubing forces software, and their relative effectiveness was evaluated. The drilling field results easily exceeded the minimum requirements for success. This project demonstrated record breaking lateral lengths, a record length of liner run on coiled tubing in a single run, and a triple casing exit. The data gained from this project can be used to fine-tune the modelling for future work of a similar nature.


Sign in / Sign up

Export Citation Format

Share Document