Robust Schur Stable Control Systems

Author(s):  
F.J. Kraus ◽  
M. Mansour
2021 ◽  
Vol 11 (4) ◽  
pp. 1618
Author(s):  
Ping-Nan Chen ◽  
Yung-Te Chen ◽  
Hsin Hsiu ◽  
Ruei-Jia Chen

This paper proposes a passivity theorem on the basis of energy concepts to study the stability of force feedback in a virtual haptic system. An impedance-passivity controller (IPC) was designed from the two-port network perspective to improve the chief drawback of haptic systems, namely the considerable time required to reach stability if the equipment consumes energy slowly. The proposed IPC can be used to achieve stability through model parameter selection and to obtain control gain. In particular, haptic performance can be improved for extreme cases of high stiffness and negative damping. Furthermore, a virtual training system for one-degree-of-freedom sticking was developed to validate the experimental platform of our IPC. To ensure consistency in the experiment, we designed a specialized mechanical robot to replace human operation. Finally, compared with basic passivity control systems, our IPC could achieve stable control rapidly.


Author(s):  
Jun Zhao ◽  
Hugang Han ◽  
◽  

Although the Takagi–Sugeno fuzzy model is effective for representing the dynamics of a plant to be controlled, two main questions arise when using it just as other models: 1) how to deal with the gap, which is referred to as uncertainty in this study, between the model and the concerned plant, and how to estimate the state information when it cannot be obtained directly, especially with the existence of uncertainty; 2) how to design a controller that guarantees a stable control system where only the estimated state is available and an uncertainty exists. While the existing studies cannot effectively observe the state and the resulting control systems can only be managed to be uniformly stable, this study first presents a state observer capable of precisely estimating the state regardless of the existence of uncertainty. Then, based on the state observer, an uncertainty observer is derived, which can track the trajectory of uncertainty whenever it occurs in a real system. Finally, a controller based on both observers is presented, which guarantees the asymptotic stability of the resulting control system.


Automatica ◽  
1995 ◽  
Vol 31 (4) ◽  
pp. 605-609 ◽  
Author(s):  
V. Kučera ◽  
F.J. Kraus

1979 ◽  
Vol 21 (2) ◽  
pp. 115-121
Author(s):  
D. R. Broome

Hydraulic servomechanisms used as positioning control systems within arm prostheses are subject to very high loads. To investigate the effects of such loads on the dynamics of a hydraulic servo, a load-arm test has been constructed. Step-response tests on this rig show stable transients at low-load values which destabilize as load increases. At loads near system stall, a stable control system is again obtained. A mathematical model of the rig has been developed, based on a flexibly connected load, and this can be used to predict the initial destabilization. This model is further refined by the inclusion of a quasi-linear approximation to the steady gravitational load, and this then also demonstrates the further restabilization observed experimentally. It was noted during the tests that it was not possible to excite system instability when operating the servovalve manually. This then means that the servosystem will be suitable for its prosthetic operation where the user will operate the valve from anatomical sites. This stabilizing effect of manual operation is also explained.


Sign in / Sign up

Export Citation Format

Share Document