Resonant Frequency Tuning System for Repeater Resonator of Resonant Inductive Coupling Wireless Power Transfer

Author(s):  
Akihiro Konishi ◽  
Keita Fujiki ◽  
Kazuhiro Umetani ◽  
Eiji Hiraki
Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 415
Author(s):  
Haiyue Wang ◽  
Lianwen Deng ◽  
Heng Luo ◽  
Junsa Du ◽  
Daohan Zhou ◽  
...  

The microwave wireless power transfer (MWPT) technology has found a variety of applications in consumer electronics, medical implants and sensor networks. Here, instead of a magnetic resonant coupling wireless power transfer (MRCWPT) system, a novel MWPT system based on a frequency reconfigurable (covering the S-band and C-band) microstrip patch antenna array is proposed for the first time. By switching the bias voltage-dependent capacitance value of the varactor diode between the larger main microstrip patch and the smaller side microstrip patch, the working frequency band of the MWPT system can be switched between the S-band and the C-band. Specifically, the operated frequencies of the antenna array vary continuously within a wide range from 3.41 to 3.96 GHz and 5.7 to 6.3 GHz. For the adjustable range of frequencies, the return loss of the antenna array is less than −15 dB at the resonant frequency. The gain of the frequency reconfigurable antenna array is above 6 dBi at different working frequencies. Simulation results verified by experimental results have shown that power transfer efficiency (PTE) of the MWPT system stays above 20% at different frequencies. Also, when the antenna array works at the resonant frequency of 3.64 GHz, the PTE of the MWPT system is 25%, 20.5%, and 10.3% at the distances of 20 mm, 40 mm, and 80 mm, respectively. The MWPT system can be used to power the receiver at different frequencies, which has great application prospects and market demand opportunities.


2016 ◽  
Vol 3 (1) ◽  
pp. 9-14
Author(s):  
Nurcan Keskin ◽  
Huaping Liu

Power transfer efficiency in loosely coupled inductive systems can be enhanced by resonance. Primary and secondary can be tuned to same resonant frequency. In this paper, MOSFET-based Varactors and switchable capacitors are used for re-tuning of such a system at 13.56 MHz. This is achieved either using each cap structure alone or as a hybrid model. These techniques are designed for 13.56 MHz wireless power transfer system.


Electronics ◽  
2020 ◽  
Vol 9 (8) ◽  
pp. 1303
Author(s):  
Do-Hyun Kim ◽  
Min-Soo Kim ◽  
Hee-Je Kim

The wireless power transfer (WPT) system has attracted attention for energy transmission without physical contact. However, a WPT system has low coupling condition because of a big air gap between transmitter and receiver coils. The low coupling condition has a high leakage inductance. To overcome this problem, we design a proposed system for WPT using series-series (S-S) topology of one resonant circuit. To obtain the higher efficiency power conversion of the WPT system, it has to operate the resonant frequency in the zero phase angle (ZPA) point even under mutual coefficient and load variation. Therefore, we propose the resonant frequency tracking algorithm to operate ZPA point based on the second order generalized integrator-frequency locked loop (SOGI-FLL) method. This proposed frequency-tracking algorithm can estimate ZPA point by changing switching frequency. We can reduce the switching loss with this proposed algorithm and improve the low conversion efficiency of the WPT system. The performance of the proposed frequency-tracking algorithm is automatically verified through various coupling coefficients and the load variation.


Sign in / Sign up

Export Citation Format

Share Document